Dukane Imagepro 8953h Projector Users Manual

							11
ENGLISH
WARNING
►Before taking care of the air filter, make sure the power cable is not plugged in, then 
allow the projector to cool sufficiently.
►Use only the air filter of the specified type. Do not use the projector without the air 
filter or the filter cover. It could result in a fire or malfunction to the projector.
►Clean the air filter periodically. If the air filter becomes clogged by dust or the like, 
internal temperatures rise and could cause a fire, a burn or malfunction to the projector.
(1) Press the MENU button to display a menu.
(2)
   Point at the “FILTER TIME” using the ▼/▲ button, then press the ► button. A dialog will appear.
(3)  Press the ▲ button to select  RESET on the dialog. It performs resetting the filter time.
NOTE • Please reset the filter time only when you have cleaned or replaced the air filter , for a 
suitable indication about the air filter.
• The projector may display the message such as “ CHECK THE AIR FLOW” or turn off the 
projector, to prevent the internal heat level rising. 
Filter cover
Filter cover knobs
Filter unit
 Filter cover Filter frame
Filter (finer meshed)
Filter (larger meshed)
Please check and clean the air filter periodically. When the indicators or a message prompts you to 
clean the air filter, comply with it as soon as possible. The air filter has two kinds of filters inside. 
Replace the filters when they are damaged or too soiled. To prepare the new filters, make contact 
with your dealer and tell the following type number.
Type number = MU05661
1.Turn the projector off, and unplug the power cord. Allow the projector 
to sufficiently cool down.
2.Use a vacuum cleaner on and around the filter cover.
3.Pull the filter cover knobs while lifting it, to take the filter unit of f.
4.Use a vacuum cleaner for the filter vent of the projector and both sides 
of the filter unit.
5.Pull the filter frame’s knob up while holding the filter cover to remove 
the filter frame, then take the filters out.
6.Set new filters where former filters were. Put the larger meshed filter 
into a filter cover first. Then put the finer meshed filter on the larger 
meshed one.
7.Put the filter frame back where it was.
8.Put the filter unit back into the projector.
9.Turn the projector on and reset the filter time using the FILTER TIME 
item in the  EASY MENU.
When you replace the lamp, please replace the air filter. An air filter of 
specified type will come together with a replacement lamp for this projector
.
I
f the filters are damaged or too soiled, replace them according to the following 
procedure number 5 to 7. Otherwise, please jump to the procedure number 8.
Air filter 
						

							12
1. 
Turn the projector off, and unplug the power cord. Allow the 
projector to cool sufficiently.
2.  
After making sure that the projector has cooled adequately, 
slowly turn over the projector, so that the bottom is facing.
3.  
Turn the battery cover in the direction indicated “ OPEN” 
using such as coins. Then the battery cover will come up. 
While removing the battery cover, pick its knob.
4.  
Press the metal claw of the battery holder. Then the battery 
will come up. Remove the battery.
5.  
Replace battery with HITACHI MAXELL, Part No.CR2032 
only. 
Put a new battery into battery case. Please make sure that the + 
is facing upward. Insert the battery case slowly into the battery 
slot until you hear the snap.
Note:   If the battery is placed in the battery holder upside-
down,
(1)   Remove the battery cover and turn the projector so that top 
faces up. 
(2)   While lifting the side of the projector closest to the lens, 
press the metal claw of the battery holder. The battery will 
fall out of the holder, so be careful not to lose it.
6.  
Close the battery cover. Replace the battery cover in place, 
then turn it in the direction indicated “ CLOSE” using such as 
coins, to fix.
Internal clock batter y
Consumption of the battery makes the clock not to work correctly. When the clock is wrong or it has 
stopped, please replace the battery according to the following procedure\
s.
Battery Cover
 
OPEN
Knob  Metal claw
“+” marking
 CLOSE
WARNING
►Always handle the batteries with care and use them only as directed. Bat\
tery may 
explode if mistreated. Do not recharge, disassemble or dispose of in fire. 
And also improper use may result in cracking or leakage, which could result in fire, 
injury and/or pollution of the surrounding environment.
• Be sure to use only the batteries specified.
• Make sure the plus and minus terminals are correctly aligned when loading a battery .
• Keep a battery away from children and pets. If swallowed consult a physi\
cian 
immediately for emergency treatment.
• Do not short circuit or solder a battery.
• Do not allow a battery in a fire or water. Keep batteries in a dark, cool and dry place. 
• If you observe battery leakage, wipe out the leakage and then replace a battery . If the 
leakage adheres to your body or clothes, rinse well with water immediate\
ly.
• Obey the local laws on disposing the battery. 
						

							13
ENGLISH
Using the CD manual
The other manuals for this product are written into the included CD-ROM titled “User’s Manual 
(detailed)”. Before using the CD-ROM, please read the following to ensure the proper use.
System requirements
The system for using the CD-ROM requires the following. 
Windows®:    OS:  Microsoft®  Windows®  98,  Windows®  98SE,  Windows NT®4.0,  Windows  
Me®, Windows® 2000/Windows®XP, or later
  CPU: Pentium® processor 133MHz / Memory: 32MB or more
Macintosh®:  OS: Mac OS 10.2 or later
  CPU: PowerPC® / Memory: 32MB or more
CD-ROM drive:  4x CD-ROM drive
Display:   256 color / 640x480 dots resolution
Applications:  Microsoft Internet Explorer4.0 or later
How to use the CD
1. 
Insert CD into PC’s CD-ROM drive.
Windows®:  In a while, Web browser automatically starts. Start up window comes up.
Macintosh®:  (1) Double-click on the ”Projectors” icon appeared on the desktop screen. 
  (2) When “main.html” file is clicked, Web browser will start and Initial window 
will appear.
2.  
Click  the  model  name  of  your  projector  first,  and  then  click  language  you  want  from  the 
displayed list. The user’s manual (detailed) will open.
NOTE• The information in the CD-ROM is subject to change without notice.
• No responsibility is taken for any obstacle and defect to hardware and software of your PC as a 
result of the use of the CD-ROM.
• All or Any part of the information in the CD-ROM must not be copied, reproduced or 
republished without notice to our company.
CAUTION
►Only use the CD-ROM in a computer CD drive. The CD-ROM is designed for PC 
use only. NEVER INSERT THE CD-ROM INTO A NON-COMPUTER CD PLAYER! 
Inserting the CD-ROM into an incompatible CD drive may produce a loud noise, which 
in turn MAY RESULT IN EAR AND SPEAKER DAMAGE! 
►After using CD-ROM, please put it into CD case and keep it. Please keep the CD 
neither in direct sunlight nor in a high temperature and high humidity e\
nvironment. 
						

							14
Regulator y notices
WARNING: 
In the US   Declaration of Conformity
Trade name:  HITACHI
Model Number:  CP-X809W
Responsible Party:  Hitachi Home Electronics (America), Inc.
Address:  900 Hitachi way, Chula Vista, CA 91914-3556 U.S.A.
Telephone Number:  +1 –800-225-1741
This device complies with part 15 of the FCC Rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) This device must accept 
any interference received, including interference that may cause undesir\
ed operation.
This equipment has been tested and found to comply with the limits for a\
 Class B digital device, 
pursuant to Part 15 of the FCC Rules.
In Canada   NOTICE:  This Class B digital apparatus complies with Canadian ICES-003.
These limits are designed to provide reasonable protection against harmf\
ul interference in a 
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, 
if not installed and used in accordance with the instructions, may cause\
 harmful interference to radio 
communications. However, there is no guarantee that interference will not occur in a particular\
 
installation. If this equipment does cause harmful interference to radio\
 or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interface by one or more of the following measures: 
- Reorient or relocate the receiving antenna. 
- Increase the separation between the equipment and receiver. 
- Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected. 
- Consult the dealer or an experienced radio/TV technician for help.
INSTRUCTIONS TO USERS:
In the US    This equipment complies with the requirements of FCC (Federal Communication 
Commission) equipment provided that the following conditions are met.
Some cables have to be used with the core set. Use the accessory cable o\
r a designated-type cable 
for the connection. For cables that have a core only at one end, connect the core to the projector .
CAUTION:  Changes or modifications not expressly approved by the party responsible for 
compliance could void the user’s authority to operate the equipment.
Information for users applicable in European Union countries
This symbol on the product or on its packaging means that your electrica\
l and 
electronic equipment should be disposed at the end of life separately fr\
om your 
household wastes. There are separate collection systems for recycling in EU. 
For more information, please contact the local authority or the dealer where you 
purchased the product. 
						

							15
ENGLISH
ItemSpecifications
Product name Liquid crystal projector
Liquid Crystal Panel 1024 horizontal x 768 vertical
Lens Zoom lens F=1.7 ~ 1.9  f=24 ~ 29 mm (approx.)
Lamp 275W UHB
Audio output 4W x 4
Power supply AC 100-120V/5.0A, AC220-240V/2.1A
Power consumption 460W
Temperature range 5 ~ 35°C (Operating)
Weight (mass) 7.1kg (approx.)
Ports
RGB1  ..................................................... D-sub 15 pin mini x 1RGB2 G/Y, B/CB/PB, R/CR/PR, H, V ............................. BNC x 5S-VIDEO  ...................................................... mini DIN 4 pin x 1VIDEO  ........................................................................\
 RCA x 1Y, CB/PB, CR/PR (component video)  ............................ RCA x 3HDMI  ........................................................................\
 HDMI x 1AUDIO IN1 ....................................................... Stereo mini x 1AUDIO IN2 ....................................................... Stereo mini x 1AUDIO IN3 R/L  ........................................................... RCA x 2AUDIO IN4 R/L  ........................................................... RCA x 2RGB OUT ............................................... D-sub 15 pin mini x 1AUDIO OUT  ..................................................... Stereo mini x 1USB  ...................................................................... USB (B) x 1REMOTE CONTROL  ....................................... Stereo mini x 1CONTROL  ....................................................... D-sub 9 pin x 1LAN ....................................................................\
........ RJ45 x 1AUX I/O  ................................................................ USB (A) x 1SD CARD  ....................................................... SD card slot x 1
Size
[unit: mm]
Optional parts Lamp: 456-8949H
Air filter: MU05661
Wireless network card: VA0833x*
* For more information, please consult your dealer.
Specifications
154139
319
418 
						

							16
Warranty and after-ser vice
If an abnormal operation (such as smoke, strange odor or excessive soun\
d) should occur, stop 
using the projector immediately. Otherwise if a problem occurs with the projector, first refer to the 
“Troubleshooting ” of the “
Operating Guide ” in the CD and run through the suggested checks.
If this does not resolve the problem, please consult your dealer or serv\
ice company. They will tell 
you what warranty condition is applied.
Please check the following web address where you may find the latest information for this projector .
http://www.dukcorp.com/audiovisual or  
 Dukane Service Dept: 1.888.676.2487
NOTE• The information in this manual is subject to change without notice.
• The manufacture assumes no responsibility for any errors that may appear in this manual.
• The reproduction, transfer or copy of all or any part of this document is not permitted without 
express written consent.
TRADEMARK ACKNOWLEDGMENT
•  Microsoft and Internet Explorer Windows, Windows NT, Windows Me, Windows Vista are 
registered trademark of Microsoft Corporation.
• 
 PowerPC is a registered trademark of International Business Machines Corporation.
• VESA and DDC are trademarks of the Video Electronics Standard Association.
• Apple and Macintosh, Mac, Mac OS are registered trademarks of Apple Inc.
• Pentium is a registered trademark of Intel Corporation.
• JavaScript is a registered trademark of Sun Microsystems, Inc.
• DVI is a trademark of Digital Display Working Group.
• 
 HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered 
trademarks of HDMI Licensing LLC.
• 
  is a trademark of SRS Labs, Inc. WOW technology is incorporated under license from 
SRS Labs, Inc.
All other trademarks are the properties of their respective owners.