Dukane Imagepro 8929w Projector Users Manual

11
ENGLISH
Displaying the picture
1. Activate your signal source. Turn the 
signal source on, and make it send the 
signal to the projector.
2. Press the INPUT button on the projector.  Each time you press the button, the 
projector switches its input port in turn.
You can also use the remote control to 
select an input signal. Press the  VIDEO 
button for selecting an input signal from 
the HDMI, S-VIDEO or VIDEO port, or 
the COMPUTER button for selecting an 
input signal from the  COMPUTER IN1,...

12
Turning off  the power
1. Press the STANDBY/ON button on the 
projector or the remote control. 
The message “Power off?” will appear  
on the screen for about 5 seconds.
2. Press the STANDBY/ON button again 
while the message appears. 
The projector lamp will go off, and the 
POWER indicator will begin blinking in 
orange. Then the  POWER indicator will 
stop blinking and light in steady orange 
when the lamp cooling is complete.
3. Attach the lens cover, after the POWER 
indicator turns in steady...

13
ENGLISH
Replacing the lamp
A lamp has finite product life. Using the lamp for long periods of time\
 could cause 
the pictures darker or the color tone poor. Note that each lamp has a different 
lifetime, and some may burst or burn out soon after you start using them\
. 
Preparation of a new lamp and early replacement are recommended. To prepare 
a new lamp, make contact with your dealer and tell the lamp type number.Type number : 1 
1.  
Turn the projector off, and unplug the power cord....

14
 HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE
WARNING  ►The projector uses a high-pressure mercury glass lamp. The 
lamp can break with a loud bang, or burn out, if jolted or scratched, ha\
ndled 
while hot, or worn over time. Note that each lamp has a different lifetime, and 
some may burst or burn out soon after you start using them. In addition,\
 if the 
bulb bursts, it is possible for shards of glass to fly into the lamp h\
ousing, and 
for gas containing mercury and dust containing fine particles...

15
ENGLISH
Please check and clean the air filter periodically. When the indicators or a message 
prompts you to clean the air filter, comply with it as soon as possible. The air filter has two 
kinds of filters inside. Replace the filters when they are damaged o\
r too soiled. To prepare 
the new filters, make contact with your dealer and tell the following \
type number.
Type number : MU06481 (Filter set)
When you replace the lamp, please replace the air filter. An air 
filter of specified type will come...

16
NOTE  • The information in the CD-ROM is subject to change without notice.
Please check our website where you may find the latest information for\
 this 
projector.  (
 18)
• No responsibility is taken for any obstacle and defect to hardware \
and 
software of your computer as a result of the use of the CD-ROM.
• All or Any part of the information in the CD-ROM must not be copied,  reproduced or republished without notice to our company.
Using the CD manual
The other manuals for this product are...

17
ENGLISH
ItemSpecification
Product name Liquid crystal projector
Liquid Crystal 
Panel
1, , 8930, 8937:   
786,432 pixels (1024 horizontal x 768 vertical)
8929W, 8931W:   
1,024,000 pixels (1280 horizontal x 800 vertical)
Lamp 215 W UHP
Speaker 16 W mono (8 W x 2)
Power supply/
Rated current AC 100-120 V: 3.3 A, AC 220-240 V: 1.7 A
Power 
consumption AC 100-120 V: 310 W

, AC 220-240 V: 300 W
Temperature 
range 5 ~ 35 °C (Operating)
Size 317 (W) x 98 (H) x 288 (D) mm
* Not including protruding...

18
Troubleshooting - Warranty and after-ser vice
If an abnormal operation (such as smoke, strange odor or excessive sound) 
should occur, stop using the projector immediately. 
Otherwise if a problem occurs with the projector, first refer to “Troubleshooting” 
of User’s Manual - Operating Guide  and Network Guide, and run through the 
suggested checks. 
If this does not resolve the problem, please consult your dealer or service 
company. They will tell you what warranty condition is applied.
Please check...

1
ENGLISH
T- 1    8755N, 8928, 8930 (1024 x 768)   (±10%)
T- 2    8937  (1280 x 768)   (±10%)
   
Screen size
(diagonal)4 : 3 screen 16 : 9 screen
  
Projection distance 
Screen 
heightScreen 
height Projection distance 
Screen 
height Screen height 
min. max. min. max.
type 
(inch)m m inch m inch cm inch cm inch m inch m inch cm inch cm inch
30 0.8 0.8 32 1.0 39 39 15  7  3  0.9 35 1.1 43 36 14  1  0 
40 1.0 1.1 44 1.4 54 52 21  9  3  1.2 48 1.5 59 49 19  1  0 
50 1.3 1.4 56 1.7 68 65 26 11  4  1.6 61...

2
~Suspended from the ceiling~On a horizontal surface
F-1F-2
T- 3    8929W,  8931W  (1280 x 800)   (±10%)
Screen size
(diagonal)16 : 10 screen 4 : 3 screen
  
Projection distance 
Screen 
heightScreen 
height Projection distance 
Screen 
height Screen 
height 
min. max. min. max.
type 
(inch)m inch m inch cm inch cm inch m inch m inch cm inch cm inch
300.9 35 1.1 43 40 16 1 0 1.0 40 1.2 49 45 18  1 0
401.2 48 1.5 58 53 21 1 0 1.4 54 1.7 67 60 24  1 0
501.5 61 1.9 74 66 26 1 1 1.8 69 2.1 84 75 29  2 1...