Dukane Imagepro 8775 Portable Lcd Projector Users Manual

1
1. Introduction

 Whats in the Box?
Make sure your box contains everything listed. If any pieces are missing, contact your dealer.
Please save the original box and packing materials if you ever need to ship your Projector.
PC C AR DLA M PSTA TU SPO W ERSOURCEAUT O ADJU ST3D REFORMON/STAND BY
SELEC T
OFF
VID EO
S-VIDEO VIEW
ER
LAN
COM
PUTE RCOMPONENTONP O W ERPO W ER
LA SER
3D REFORM
AUTO  ADJ.ASPEC T
HELP
PICTUREPIC-MUTE
LAM
P MODER-C LIC K
L -C LIC K
MOUSE
F R EEZE
V O LU M E
MAG NIF Y P
AG E...

2
1. Introduction
 Introduction to the Projector
This section introduces you to the projector and describes key features and controls.
Congratulations on Your Purchase of the Projector
The 8774/8775 is a sophisticated XGA projector that produces an enhanced display. With the 8774/8775 you will
be able to project images up to 300” (measured diagonally). Enjoy crisp and sharp large screen display from your PC,
wo rkstation or Macintosh computer, DVD player, VCR, satellite hookup, HDTV source, ) and...

3
•Free downloadable Software Geometric Correction Tool 3.0.
Corrects the geometry of an image projected onto a cylindrical, spherical or corner screen via serial connection.
F or additional information visit:
US : www.dukcorp.com/av
Europe : http://www.neceurope.com/
Global : http://www.nec-pj.com/
About this users manual
The fastest way to get started is to take your time and do everything right the first time. Take a few minutes now to
review the users manual. This may save you time later on. At the...

4
1. Introduction
 Part Names of the Projector
PC C AR DLA M PS
TA TU SPO W E
RS O URCEAU TO  A DJU ST3D  R EFO RMON/S TA N D B Y
SE LECT
Controls
(→ page  6 )
Built-in Security Slot (  )*
V
entilation (inlet)
Lens Lens Cap
Adjustable Tilt Foot
(→ page 27 )
Remote Sensor
(
→ page  9 )
Focus Ring
(→ page  28 )Zoom Lever
(
→ page 
28 )
Adjustable Tilt Foot Lever(
→ page  27 )
*This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kensington
Microware Inc....

5
1. Introduction
PC C AR DCO MPO NE NT I NU SB LA N
AU DIO I N CO
MPU TE R 3  IN
C OM PUTE R 1 IN C
OM PUTER  2 IN
PC C ONTR OLM ON ITO R O UT
A U DI O O UT
S
-V IDE O IN V
ID EO  INAU DIO  INCb /Pb
L/M ONO R
Y
C
r/ Pr
PC CARDLAMPSTATUSPOWERO N/S TA N D B YSO URCE
A
UTO  ADJUS T
3D  RE FORM
SELEC T
Monaural Speaker (1W)
AC Input
Connect the supplied power cables two-pin plug here, and plug the other end into an active wall outlet.(
→ page  23 )
Main Power Switch
When you plug the supplied power cable...

6
1. Introduction
T op Features
PC CARDLAMPSTATUSPOWERON/STAND BY
SOURCE
AUTO ADJUST
3D REFORM
SELECT
12
145
2
3678
11
10
9
1. POWER Button (ON / STAND BY) (
→ page  24 ,  33 )
NOTE: To turn on the projector, press and hold this button
for a minimum of two seconds. To turn off the projector,
press this button twice.
2. POWER Indicator (  ) ( → page  24 ,  33 ,  107 )
3. STATUS Indicator ( → page 
107 )
4. LAMP Indicator ( → page 
104 ,  107 )
5. PC CARD Access Indicator ( → page 
22 )
6. SOURCE Button...

7
1. Introduction
Te rminal Panel Features
PC CARDCOMPONENT IN
USB LAN
AUDIO IN COMPUTER 3 IN
COMPUTER 1 IN COMPUTER 2 IN
PC CONTROLMONITOR OUT
AUDIO OUT
S-VIDEO IN VIDEO INAUDIO INCb/Pb
L/MONO R
Y
Cr/Pr
143
2
11
569108
7
1
4131215
1. COMPUTER 1 IN/Component Connector (Mini D-
Sub 15 Pin) ( → page 
13 ,  15 ,  16 )
2. COMPUTER 2 IN/Component Connector (Mini D- Sub 15 Pin) ( → page 
13 ,  16 )
3. COMPUTER 3 IN Connector (DVI-D 24 Pin) (HDCP compatible) ( → page 
14 ) (Not available on LT280)
4. AUDIO IN...

8
1. Introduction
 Part Names of the Remote Control
4. LED
Flashes when any button is pressed.
5. POWER ON Button ( → page 
24 )
NOTE: To turn on the projector, press and hold the POWER
ON button for a minimum of two seconds.
6. POWER OFF Button (→ page  33 )
NOTE: To turn off the projector, press the POWER OFF but-
ton twice.
7. COMPUTER 1 Button (→ page  26 )
8. COMPUTER 2 Button ( → page 
26 )
9. COMPUTER 3 Button ( → page 
26 )
(Not available on LT280)
10. VIDEO Button ( → page 
26 )
11. S-VIDEO...

9
1. Introduction
30°
30 °
30 °
30
°
Battery Installation
1Press the catch and remove
the battery cover.2Install new ones (AA). Ensure
that you have the batteries po-
larity (+/–) aligned correctly.3Slip the cover back over the bat-
teries until it snaps into place.
NOTE: Do not mix different types of
batteries or new and old batteries.
Remote sensor on projector cabinet
7m/22 feet
• The infrared signal operates by line-of-sight up to a distance of about 22 feet/7 m and within a 60-degree angle of
the...

10
This section describes how to set up your projector and how to connect PCs, video and audio sources.
2. Installation and Connections

 Setting Up the Screen and the Projector
The further your projector is from the screen or wall, the larger the image. The minimum size the image can be is
approximately 21 inches (0.5 m) measured diagonally when the projector is r\
oughly 28 inches (0.7 m) from the wall or
screen. The largest the image can be is 300 inches (7.6 m) when the projector \
is about 390...