Doss Touch Wireless Bluetooth V4.0 Portable Speaker User Manual

							Wireless P ortable Bluet ooth Speak er
Mode No.: SoundB ox
User Manual  
						

							Pack age c onten t
Pr oduct  over vie w
Thank  you  for pu rchasing the  DOSS SoundB ox Wir eless P ortable Blu etooth 
Spea ker
wir eless port able speaker .
• One wi reless port able speaker
• USB char ging cable
• Φ3.5mm auxilia ry c able
• T ra vel w aterpr oof pouch
• User manual, Warr anty c ard,Con tact c ard
1. Mode s witch: T ouch                to t oggle pl ay mode among  Blu etooth, 
2. In Blu etooth mode/TF mode,  touch           to skip back war d.
3. 
    • In Blu etooth mode ,t ouch             to an sw er or end a c all. Touch  for 3 
       sec onds to r eject a  call.
    • In Blu etooth mode,  touch             to pl ay/pause y our tune.  Touch  for 3 
       sec onds to dis connect with  your d evice.
    •  In TF mode,  touch            to pl ay/pause y our tune.
4. In Blu etooth mode/TF mode,  touch            to skip  for war d.
5. V olume c ontrol: 
1
2 3
5 4
introduction 
						

							Status indi cator s
6.  Long p ress        t o turn the d evice on and o ff.
7. Auxilia ry Φ3.5mm jack
     d evices.
8. TF c ard: Use it f or TF car d (with music) pl ayback. support mp3, wav,
     t o FAT32.
9. Char ging port:  Plug the supplied USB  cable i nto this port  to r echar ge 
10. LED char ging indicator .
    • Cha rging : St eady Red.
    • Fully cha rg ed : St eady G reen.
Cen ter indi cator/
indi cator Flashing blue 
St
eady blue 
St eady r ed
St eady g reen Indi
ca tes tha t the speak er 
has en ter ed in to the pairing 
mode and it is  ready t o be 
pai red
Indi ca tes tha t the de vice is 
success fully pai red
St eady r ed 
St eady G reen Indi
ca tes tha t the de vice has 
s wit ched t o the auxilia ry 
input mode
Indi ca tes tha t the de vice has 
s wit ched t o the TF mode 
678910 
						

							Pairing the wi reless speak er with your smart de vice
• Use the supplied USB  cable t o charg e y our por table spea ker dir ectly 
    fr om y our c ompu ter or de vice with a mic ro USB port.
•  Mak e sure tha t the speak er is fully cha rg ed be for e using it  for the 
    Not e

Remember to note the above point and fully charge your speaker 
prior to the first use. It will take approximately 2-3 hours to recharge 
after. 
Press & Hold the power button to turn on the speaker. Repeat the 
steps to turn the device off as well.  LED light will remain RED when charging and turn GREEN once charge 
completes. 
The speaker has a built-in battery saver mode where it will 
automatically power off if not in use for 15 minutes. This 
function can be removed with a firmware upgrade. For 
assistance, please contact: [email protected]
•
Preparation
1. Place your smart device and wireless speaker no more than one meter 
     away from each other.
2. Press the power button located on the back of the speaker for several 
     seconds to turn it on.
3. Set your smart device to “discover” the wireless speaker. Upon 
     powering on, a tone will be heard, the blue LED will start flashing, 
     accompanied by a prompt notifying that the speaker has entered into 
     the pairing mode.
4. Enabled Bluetooth on your device and choose 
DOSS SoundBox from
     the list.
5. If pairing is successful, the LED will change to steady blue and your
     phone will confirm that the connection has been established. If the 
     pairing process fails after 60 seconds, please repeat steps 1 through
     5 described above.
6. long press the button             , you can disconnect the Bluetooth.
     Note: If your smart device cannot discover the SoundBox,long press the 
                button 











and have a try again. 
						

							3. Speak with a clear voice righ t into the buil t-in mic rophone lo ca ted on 
     ma y also end the  call di rectly using the  command on  your cell phone.
5. When li stening  to music using  your smart phone, pl ayback will  resume 
     c all using the spea ker .
Using it with your Echo Dot
You can connect the Dot with the speaker using a 3.5 mm auxin cable or 
Bluetooth. Please use the following steps to set up using Bluetooth: 
Note: Download the Alexa APP, follow the standard setup procedure to 
get  the dot connected to your home Wi-Fi network.
1.
Switch the SoundBox speaker to Bluetooth mode,you can press the 
‘play/handsfree’ button for 5 seconds to keep it in pairing status.
2.
Run the Alexa app, tap Menu and then tap Settings.
3.
Tap the Echo Dot in your list of Alexa Devices, then tap Bluetooth.
4.
The SoundBox speaker should appear in the list of Bluetooth Devices. 
If not, press the "play/hands-free" button for 5 seconds and try again. 
Once listed, tap on The SoundBox speaker to complete the pairing 
process. To remove the device, return to Bluetooth -> tap the name of 
the speaker -> then tap "Forget Device". 
5.
Voice command will not be able to turn on/off the Soundbox no 
matter whether you connect it via Bluetooth / Aux cable. It can 
only translate sound signal. 
To remove the battery saver option, please contact our customer 
service at [email protected] to remove the function by 
upgrading the firmware. 
1.
2.
Ans
wering and ending a  call using  your spea ker or mobile 
phone
1. When ther e is an incoming  call, the spea ker will  gene ra te a t one and  
						

							BluetoothProblem
Solution
TF Card
other Cannot Pair with Bluetooth 
devices
Press Play/Pause button for 5 
seconds,then have a try to pair it 
again
Cannot play music after pairing Please select  'DOSS SoundBox' as 
the default playback device
The song cuts off during 
playback Please check if the Bluetooth 
distance is more than 33 feet or 
the battery level is low
There is noise during playback Maybe caused by the 
interference of charging,try to 
put it in another place and do not 
charge it during playback
Laptop prompts to install driver This driver is not special for 
SoundBox,its for your laptop 
Bluetooth function,please 
contact the computer company 
or windows
Not paired with transmitter
The speaker do not play when 
the card is inserted,and jump 
directly back to Bluetooth 
mode Check whether the card format is FAT 
or FAT32. If not, format it to FAT or 
FAT32.
Check the song format. The speaker 
only supports MP3, WAV, WMV
The song cuts off during 
playback
All the lights are lit and can not 
be turned off
Customer Service Email [email protected] Use the needle or wire to poke the 
reset button inside Auxin There may be a problem with the 
song's file, try deleting all the songs in 
the same file Please press Play/ Pause button 
for 5 seconds or contact with the 
transmitter's customer service 
for help
You can connect the Dot with the speaker using a 3.5 mm auxin cable or 
Bluetooth. Please use the following steps to set up using Bluetooth:  
						

							Product type: Wir eless Portable Blu etooth Spea ker with Buil t-in 
                          Mic rophone
Output p ow er: 6W x 2
Driv er unit: 1.5 inch spea ker x 2 + 2.6 inch passi ve r adi ator
Fr equency r esponse: 100Hz-18kHz
Unit weight: 560 g
Unit dimension: 6.6 x 2.7 x 2.9 inch
W arr anty: One -y ear limi ted
P o w er
W arning
Wir
eless/Ne tworking
• Input:5V 







1A
    Bluetooth  ver sions
• Pr ofiles suppor ted
• Do NO T drop, hit or sha ke the de vice.
• Do NO T disassemble,  repair or modi fy the Blue tooth spea ker  by y ourself .
• Do NO T use cleaning p roducts th at c on tain ben zene, solv ents or al cohol.
• Do NO T expose the Blu etooth spea ker  to e xcessiv e heat or to direct 
• Do NO T stor e the de vice in a place with high humidity or du st.
• Do NO T place he avy objects on  top of the Blu etooth spea ker .
• Do NO T use near a micr ow ave o ven or wir eless LAN pr oducts.
Product specifications 
						

							Wonder s Technology Co., Ltd
Email:Support@dossa v.c om
F ollo w us on F acebook: