Digital Projection Projector HIGHlite 660 WUXGA 3D Specifications

							Specification Sheet
HIGHlite 660 WUXGA 3D
8,000 ANSI Lumens | Contrast Ratio: 2,000:1 | Part No:113-137
Colour System: DMD Specification:
3-chip DLP®
Display Type:
3 x 0.67 DarkChip™ DMD™ 1920 x 1200 pixels native.
Fast transit pixels for smooth greyscale and improved contrast.
Aspect Ratio:
16x10
Fill Factor
87%
Key Features
Standard Inputs (1-8): Front End Video Capabilities
Video & Graphics Processing
High bandwidth digital & analog receiver with 10 bit A-D.
Automatic detection of interlaced video and implementation of 3:2 or 2:2 extraction as appropriate, with pixel 
based, motion adaptive interpolation and auto cadence correction.
Displayed image frame locked to input with as low as 1 frame total latency.
24p and 1080p native display.
Image enhancement for MPEG, Mosquito noise & color transients in composite sources.
Geometry Correction
Cornerstone, Vertical & Horizontal Keystone, Pincushion & Barrel, and Image Rotation.
Non-linear Warp adjustment by moving points on an interpolated grid.
Edge Blending 
Semi-automated multi projector tiling
Correction for non-active pixels at the edge of the display.
HDBaseT® Interface
Built in support for transmission of uncompressed High Definition Video over standard CAT5e/6 LAN cable.
Allows projector to be placed up to 100m from source with low cost cabling.
Super Image Clarity
Geometry correction and Edge Blending implemented in single stage process, retaining maximum image  
						

							resolution.
Picture in Picture
Two sources can be displayed either one within the other (PIP), or side by side, with original aspect ratios 
maintained.
ColorMax™
Accurate matching of projectors in tiled or blended applications.
User selection and storage of primary and secondary color targets.
High Bandwidth Inputs (9-11): Bypassing Front End for Minimal Latency
Pixel mapped to the display.
HDMI 1.4 for Side by Side, Frame Packing & Top Bottom formats.
Dual Flash Processing can be used to multiply the displayed frame rate for 3D sources (example 144Hz display).
FastFrame™ Smear Reduction.
Dual Pipe processing: two sources in parallel for left and right eyes.
Synchronisation of active glasses or polarising switcher.
Projector Controller Software
Intuitive user interface for network control
Simultaneous control of user-defined groups of projectors
At-a-glance monitoring of projector status
Source Compatibility:
3GSDI is SMPTE 292M, SMPTE 259M-C and SMPTE 424M compliant.
HDMI and DVI include Deep Color™ processing up to 36 bit.
DVI inputs are HDMI compatible.
Digital Audio Extraction via SPDIF for HDMI sources.
Graphics standards up to 1920 x 1200 at 60Hz via DVI or VGA.
Component Video (SD and HD) via YPrPb, RGB or RGBS.
S-Video (PAL, NTSC & SECAM)
Composite Video (PAL, NTSC & SECAM)
High Bandwidth, Pixel Mapped Path:
Dual Pipe accepts graphics standards up to 1920 x 1200 at 120Hz.
HDMI 1.4 including 3D Standards
Dual Pipe (2 x DVI) 
						

							Inputs/Outputs  
 Video & Computer
Type Connector Qty
DVI-D / DVI-A
HDMI 1.3
3G-SDI
HDBaseT
VGA / Analog RGB
Component Video
S-Video
Composite Video
Composite Video
High Bandwidth Ports
Dual Pipe
HDMI 1.4
Audio
SPDIF Digital Output DVI-I
HDMI
BNC
RJ45
15-pin D-Sub
4 x BNC
4-pin Mini DIN
RCA
BNC
DVI-D
HDMI
RCA 1
1
1
1
1
1
1
1
1
1
2
1  Communication & Control
Type Connector Qty
3D Sync Out
3D Sync In
LAN
RS232
Wired Remote In
Wired Remote Out
Service Port BNC
BNC
RJ45
9-pin D Sub
3.5mm Stereo Jack
3.5mm Stereo Jack
USB Type B 1
1
1
1
1
1
1
3D Formats Supported HDTV Formats Supported
Frame Packing
Dual Pipe
Frame Sequential
Side By Side (half) 
Top and Bottom 1080p (23.98Hz, 24Hz, 25Hz, 29.97Hz, 30Hz, 50Hz, 
59.94Hz, 60Hz), 1080i (50Hz, 59.94Hz, 60Hz), 1080sf 
(23.98Hz, 24Hz), 720p (50Hz, 59.94Hz, 60Hz)
Computer Compatibility Bandwidth
Up to 1920 x 1200 170 MHz on analog RGB
165 Megapixels per second on HDMI and DVI 
300 Megapixels per second on Dual Pipe DVI
Remote Control Automation Control
Addressable IR remote control, wireless and wired with 
loop-through. 
On-Board keypad RS232
LAN
Colour Temperature  
User selectable from 3200 to 9000K  
Lamp Type Typical Lamp Life
2 x 330W High Intensity Discharge Full Power: 1500 hours (up to 3000 hours in lamp 
sequential mode)
Eco Mode : 2000 hours (up to 4000 hours in lamp 
sequential mode)
Lenses
Lens Part No. Focus Range Lens Shift
0.77 : 1 fixed HB
1.16 : 1 fixed HB
1.45 - 1.74 : 1 zoom HB
1.74 - 2.17 : 1 zoom HB
2.17 - 2.90 : 1 zoom HB
2.90 - 4.34 : 1 zoom HB
4.34 - 6.76 : 1 zoom HB 110-808 
110-809 
110-803 
112-878 
113-852 
110-806
110-807 1.3m - 2.5m
1.4m - 6.2m
1.8m - 9.3m
2.2m - 11.8m
2.7m - 15.4m
3.6m - 22.5m
5.5m - 35m Vert: 0.2 (U) 0.2 (D) frame, Hor: 0.05 (L) 0.05 (R) frame
Vert: 0.2 (U) 0.2 (D) frame, Hor: 0.05 (L) 0.05 (R) frame
Vert: 0.6 (U) 0.6 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.6 (U) 0.6 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.6 (U) 0.6 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.6 (U) 0.6 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.6 (U) 0.6 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Lens Mount
Motorised shift, zoom and focus.
Mechanical Mounting Orientation
Front/Rear Table
Front/Rear Ceiling
Adjustable Front/Rear Feet
Optional RapidRig™ frame with integrated pitch, roll and 
yaw adjustments. Table Top or Inverted:  Yes 
Pointing Up:         Yes 
Pointing Down:    Yes 
Roll (Portrait):      Yes
Power Requirements Power Consumption 
						

							90 - 240VAC 50/60Hz single phase 840W
Thermal Dissipation Fan Noise
2866 BTU/Hour 39dBA
Operating/Storage Temperature Operating Humidity 
Operating: 0 to 40C (32 to 104F)
Storage: -20 to 60C (-4 to 140F) 20% to 90% non-condensing
Weight (Chassis Only) Dimensions
 27 kg 
60 lb  L: 66.5 cm W: 50 cm H: 22 cm
L: 26.2 in W: 19.7 in H: 8.7 in
Safety & EMC Regulations
CE, FCC Class A & B, UL, CCC, KC  
*Dimensions included for reference only and are subject to change. Please download the full set of CAD files for this 
display for more accurate information.
Downloads  
PDF CAD Drawings
AUTOCAD Drawings User Guides
Important Information
Specifications subject to change without notice. Digital Projection version: 1.7 - 14-Aug-13 ©2012 Digital Projection.
DLP®, Digital Light Processing™ and DMD are trademarks of Texas Instruments, Inc 
						

							DIGITAL PROJECTION, INC  55 CHASTAIN ROAD, SUITE 115 KENNESAW, GA. 30144
T: 770.420.1350 | F: 770.420.1360 |  www.digitalprojection.com
DIGITAL PROJECTION, LTD  GREENSIDE WAY, MIDDLETON MANCHESTER, UK. M24 1XX 
T: +44.161.947.3300 | F: +44.161.684.7674 |  www.digitalprojection.co.uk
DIGITAL PROJECTION, CHINA  TOWER C, RM C1202, CAI FU JIA YUAN, NO. 19 XIA0 YING STREET, CHAOYANG DISTRICT BEIJING, 
PR CHINA 100101 
T: +86.10.58239771 | F: +86 10 58239770
DIGITAL PROJECTION, ASIA  16 NEW INDUSTRIAL ROAD, #02-10 HUDSON TECHNOCENTRE SINGAPORE 536204
T: +65.6284.1138 | F: +65.6284.1238