Digital Projection Projector HIGHlite 660 3D Series User Manual

page 163
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
TRC (Throw ratio correction)
A special number used in calculating throw distances and throw ratios when the image does not fill the width of the DMD™.
TRC is the ratio of the DMD™ aspect ratio to the image source aspect ratio:
DMD™ aspect ratioSource aspect ratio
TRC =
TRC is only used in calculations if it is greater than 1.
UXGA
A display resolution of 1600 x 1200 pixels with a 4:3 screen aspect ratio. (Stands for Ultra Extended Graphics Array.)...

page 164
Reference Guide
APPENDIX F: GLOSSARY OF TERMS
Y
This is the luminance input (brightness) from an S-Video or Component Video signal.
YUV
See Pr, Pb.
ZScreen
A special kind of light modulator which polarizes the projected image for\
 3D viewing. It normally requires that images are projected onto a 
silver screen. The ZScreen is placed between the projector lens and screen. It changes \
the polarization of the projected light and switches 
between left- and right-handed circularly polarized light...

page 165
Reference Guide
TECHNICAL SPECIFICATIONS
Technical Specifications
Digital Projection reserves the right to change product specifications without prior notice.
Models
The specifications on these pages refer to the following projectors:
Series name(s)ResolutionPart numberLumensContrast ratio
HIGHlite 660 
WUXGA 3D
WUXGA113-1378,0002,000:1
HIGHlite 660 
1080p 3D
1080p113-1368,0002,000:1
Color system: 3-chip DLP®
Display type (WUXGA): 3 x 0.67” DarkChip™ DMD™
Display type (1080p):  3 x 0.65”...

page 166
Reference Guide
TECHNICAL SPECIFICATIONS
Inputs and outputs
TypeConnectorQtyTypeConnectorQty
Video & ComputerCommunication & Control
DVI-D / DVI-ADVI-I13D Sync OutBNC1
HDMI 1.3HDMI13D Sync InBNC1
3G-SDIBNC1LANRJ451
HDBaseTRJ451RS2329-pin D-Sub1
VGA / Analog RGB15-pin D-Sub1Wired Remote In3.5 mm Stereo Jack1
Component Video4 x BNC1Wired Remote Out3.5 mm Stereo Jack1
S-Video4-pin Mini DIN1Service PortUSB Type B1
Composite VideoRCA1
Composite VideoBNC1
High Bandwidth ports
Dual PipeDVI-I1
HDMI...

page 167
Reference Guide
TECHNICAL SPECIFICATIONS
Lamps
Lamp typePart numberTypical lamp life 
(full power)
Typical lamp life 
(Eco mode)
2 x 330 W 
High Intensity Discharge111-100 (lamp & housing)
1500 hours
Up to 3000 hours in 
lamp sequential mode
2000 hours
Up to 4000 hours in 
lamp sequential mode
Lenses
Detailed information about available lenses can be found in Appendix A: Lens Part Numbers.
Further information about lens offsets can be found in Positioning The Image > Maximum offset range.
Lens...

page 168
Reference Guide
TECHNICAL SPECIFICATIONS
Electrical and physical specifications
• Power requirements90-240 VAC, 50-60 Hz (single phase)
• Power Consumption840 W
• Thermal Dissipation2866 BTU/hr
• Fan Noise39 dBA
• Operating Temperature0°C to 40°C (32 to 104F)
• Storage Temperature-20°C to 50°C (-4 to 122F)
• Operating Humidity20% to 90% non-condensing
• Weight27 kg (60 lb)
• DimensionsL: 66.5 cm W: 50 cm H: 22 cm 
(L: 26.2 in W: 19.7 in H: 8.7 in;)
Safety & EMC regulations
• CE, FCC Class A & B,...

Reference Guide
   
Digital Projection HIGHlite 660 3D Series 
This page is intentionally left blank.  

Digital Projection Limited
Greenside Way, Middleton Manchester M24 1XX, UK
Registered in England No. 2207264 Registered Office: as above
Tel (+44) 161 947 3300 Fax (+44) 161 684 7674
[email protected] [email protected]
www.digitalprojection.co.uk
Digital Projection Inc.
55 Chastain Road, Suite 115 Kennesaw, GA 30144, USA
Tel (+1) 770 420 1350 Fax (+1) 770 420 1360
[email protected] www.digitalprojection.com
Digital Projection China
中国 北京市  朝阳区 芍药居北里101号...