Dell Spiron N5110 Service Manual

 
   
Notes, Cautions, and Warnings  
Information in this document is subject to change without notice.  
2010 -  
Trademarks used in this text: Dell™, the DELL logo, and Inspiron™ are trademarks of Dell Inc.. ;  Microsoft ® ,  Windows ® ,  and the  Windows   start button logo    are either 
trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries.  
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is...

Back to Contents Page    
 Battery   
 
   Removing the Battery   
   Replacing the Battery   
 
   
   
   
Removing the Battery   
   
1. Follow the instructions in  Before You Begin .   
 
     
2. Shut down the computer and turn it over.   
 
     
3. Slide the battery release latch and the battery lock latch to the unlock positions.   
 
     
4. Slide and lift the battery out of the battery bay.   
 
   
Replacing the Battery   
   
1. Follow the instructions in  Before You Begin .   
 
     
2....

Back to Contents Page    
 Before You Begin   
 
   Recommended Tools   
   Turning Off Your Computer   
   Before Working Inside Your Computer   
 
This manual provides procedures for removing and installing components in your computer. Unless otherwise noted, each procedure assumes that the 
following conditions exist:  
l   You have performed the steps in  Turning Off Your Computer  and  Before Working Inside Your Computer .  
 
l   You have read the safety information that shipped with your computer...

     
2. Turn off your computer (see  Turning Off Your Computer ) and all attached devices.   
 
   
   
3. Disconnect all telephone or network cables from the computer.   
 
     
4. Press and eject any installed cards from the 8 - in - 1 media card reader.   
 
     
5. Disconnect your computer and all attached devices from their electrical outlets.   
 
     
6. Disconnect all attached devices from your computer.   
 
   
   
7. Remove the battery (see  Removing the Battery ).   
 
     
8. Turn the...

Back to Contents Page    
 Flashing the BIOS   
 
 
The BIOS may require flashing when an update is available or when replacing the system board. To flash the BIOS:  
   
1. Turn on the computer.   
 
     
2. Go to  support.dell.com/support/downloads .   
 
     
3. Locate the BIOS update file for your computer:   
 
If you have your computers Service Tag:  
a.   Click  Enter a Tag .   
 
b.   Enter your computers Service Tag in the  Enter a service tag:  field, click  Go , and proceed to  step 4 ....

Back to Contents Page    
 Camera Module   
 
   Removing the Camera Module   
   Replacing the Camera Module   
 
   
   
   
Removing the Camera Module   
   
1. Follow the instructions in  Before You Begin .   
 
     
2. Remove the battery (see  Removing the Battery ).   
 
     
3. Follow the instructions from  step 3  to  step 9  in  Removing the Palm - Rest Assembly .   
 
     
4. Remove the display assembly (see  Removing the Display Assembly ).   
 
     
5. Remove the display bezel (see...

     
6. Follow the instructions from  step 2  to  step 7  in  Replacing the Palm - Rest Assembly .   
 
     
7. Replace the battery (see  Replacing the Battery ).   
 
   
Back to Contents Page  
      CAUTION:  Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may 
result in damage to the computer.  

Back to Contents Page    
 Coin - Cell Battery   
 
   Removing the Coin - Cell Battery   
   Replacing the Coin - Cell Battery   
 
   
   
   
Removing the Coin - Cell Battery   
   
1. Follow the instructions in  Before You Begin .   
 
     
2. Remove the battery (see  Removing the Battery ).   
 
     
3. Follow the instructions from  step 3  to  step 9  in  Removing the Palm - Rest Assembly .   
 
     
4. Use a plastic scribe and gently pry the coin - cell out of the battery socket on the system...

   
Back to Contents Page  
      CAUTION:  Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may 
result in damage to the computer.  

Back to Contents Page    
 I/O Board   
 
   Removing the I/O Board   
   Replacing the I/O Board   
 
   
   
   
Removing the I/O Board   
   
1. Follow the procedures in  Before You Begin .   
 
     
2. Remove the display assembly (see  Removing the Display Assembly ).   
 
     
3. Follow the instructions from  step 2  to  step 11  in  Removing the System Board .   
 
     
4. Remove the hinge cover (see  Removing the Hinge Cover ).   
 
     
5. Remove the Mini - Card(s) (see  Removing the Mini -...