Dell Se178wfp Users Guide

Dell SE178WFP Flat Panel Monitor Users Guide   
Notes, Notices, and Cautions  
Throughout this guide, blocks of text may be accompanied by an icon and printed in bold type or in italic type. These blocks are notes, notices, and cautions, 
and they are used as follows:  
Some warnings may appear in alternate formats and may be unaccompanied by an icon. In such cases, the specific presentation of the caution is mandated by 
regulatory authority.  
Information in this document is subject to change without...

Back to Contents Page  
About Your Monitor   
Dell SE178WFP Flat Panel Monitor Users Guide  
Front View  
Back View  
Side View  
Bottom View  
Monitor Specifications  
Caring for your Monitor  
Front View  
 
 
Back View  1   Menu selection button  
2    Brightness Contrast / Down( - ) button  
3   Auto - Adjust / Up(+) button
4   Power On/Off button with LED indicator    

 
 
 
 
Side View  1   Security lock slot   Attach a lock to secure your monitor.  
2   Dell Soundbar mounting brackets  Attach the optional Dell Soundbar.
3   Barcode serial number label Refer to this label if you need to contact Dell for technical support.
4   Regulatory rating label List the regulatory approvals.
5   Stand removal button  Press to release the stand.
6   VESA mounting holes ( 100mm  -  behind 
attached stand) Use to mount monitor.
7   Cable holder   Help organize cables by passing them...

Right side  
Left side  
Bottom View    
 
   
Monitor Specifications  1   AC power cord connector
2   VGA connector
General    

Model number   SE178WFP  
Flat Panel  
Screen type   Active matrix  -  TFT LCD  
Screen dimensions   17 inches (17 - inch diagonal viewable image size)  
Preset display area:  
Horizontal   367.2 mm (14.46 inches)  
Vertical   229.5 mm (9.04 inches)  
Pixel pitch   0.255 mm x  0.255 mm  
Viewing angle   Viewing angle 150 °  (vertical) typ, 160 °  (horizontal) typ (CR>10 ）  
Luminance output   250 cd/m  ² ( typ)  
Contrast ratio   600:1 (typ)   
Faceplate coating   Glossy with hard - coating 2H...

   
Power Management Modes  Video input signals   Analog RGB: 0.7 Volts +/ - 5ybRKPLQSXWLPSHGDQFH   
Synchronization input signals   D - sub: Detachable, Analog, 15pin, shipped attached to the monitor  
AC input voltage / frequency / current   100 to 240 VAC / 50 - 60 Hz /  0.6A  (100V)& 0.35A(240V)Max.  
Inrush current   120V: 30A  (Max.)  
240V: 60A  (Max.)   
Physical  Characteristics  
The following table lists the physical characteristics:  
Signal cable type   D - sub: Detachable, Analog,...

If you have VESAs DPMS compliance display card or software installed in your PC, the monitor automatically reduces its power consumption when not in use. 
This is referred to as Power Save Mode. If input from keyboard, mouse or other input devices is detected by the computer, the monitor automatically resumes 
functioning. The following table shows the power consumption and signaling of this automatic power - saving feature:  
Activate the computer and the monitor to gain access to the  OSD .  
Pin...

Plug and Play Capability  
You can install the monitor in any Plug and Play - compatible system. The monitor automatically provides the computer system with its Extended Display 
Identification Data (EDID) using Display Data Channel (DDC) protocols so the system can configure itself and optimize the monitor settings. Most monitor 
installations are automatic; you can select different settings, if required.  
LCD Monitor Quality & Pixel Policy   
During the LCD Monitor manufacturing process, it is not...

Back to Contents Page    
Appendix   
Dell SE178WFP Flat Panel Monitor Users Guide  
  FCC Notice (U.S. Only) and Other Regulatory Information  
  CAUTION: Safety Instruction  
  Contacting Dell  
   
   
FCC Notice (U.S. Only)  and Other Regulatory Information  
For FCC Notice and other regulatory information, see the regulatory compliance website located at  www.dell.com
egulatory_compliance .  
CAUTION: Safety Instruction s  
For information on safety instructions, refer to your  Product Information...

Back to Contents Page    
Setting Up Your Monitor  
Dell SE178WFP Flat Panel Monitor Users Guide  
  Connecting Your Monitor  
  Using the Front Panel Buttons  
  Using the OSD  
  Using the Dell Soundbar (Optional)  
Connecting Your Monitor  
 
1. Turn off your computer and unplug its power cable.   
2. Connect the blue (analog D - sub) display connector cable to the corresponding video port on the back of your computer. (The graphic is for illustration 
only. System appearance may vary).   
3. Connect...