Dell M210X Projector Users Guide

Connecting Your Projector11
Connecting a DVD Player Using a Composite Video Cable
 NOTE: The Composite Video cable is not shipped with your projector. You can 
purchase the Composite Video Extension (50 ft/100 ft) cable on the Dell website 
at dell.com. 1Po w e r  c o rd
2Composite video cable
1
2 

12Connecting Your Projector
Connecting a DVD Player Using a Component Video Cable
 NOTE: The VGA to Component Video cable is not shipped with your projector. 
You can purchase the VGA to Component Video Extension (50 ft/100 ft) cable on 
the Dell website at dell.com. 1Po w e r  c ord
2VGA to Component Video cable
1
2 

Connecting Your Projector13
Connecting a DVD Player Using an HDMI Cable
 NOTE: The HDMI cable is not shipped with your projector. 1Powe r cord
2HDMI cable
1
2 

14Using Your Projector
3
Using Your Projector
Turning Your Projector On
 NOTE: Turn on the projector before you turn on the source (computer, DVD 
player, etc.). The Power button light blinks blue until pressed.
1Remove the lens cap. 
2Connect the power cord and appropriate signal cables. For information about 
connecting the projector, see Connecting Your Projector on page 8. 
3Press the Po w e r button (see Using the Control Panel on page 18 to locate the 
Po w e r button). 
4Turn on your source...

Using Your Projector15
3To power off the projector quickly, press the Po w e r button and hold for 1 
second while the projector’s cooling fans are still running.
 
NOTE: Before you turn on the projector again, wait for 60 seconds to allow the 
internal temperature to stabilize. 
4Disconnect the power cord from the electrical outlet and the projector. 
Adjusting the Projected Image 
Raising the Projector Height 
1Press the Elevator button. 
2Raise the projector to the desired display angle, and then...

16Using Your Projector
Adjusting the Projector Zoom and Focus 
 CAUTION: To avoid damaging the projector, ensure that the zoom lens and 
elevator foot are fully retracted before moving the projector or placing the 
projector in its carrying case.
1Rotate the zoom tab to zoom in and out.
2Rotate the focus ring until the image is clear. The projector focuses at distances 
ranging between 3.28 ft to 39.37 ft (1 m to 12 m).
1Zoom tab
2Fo c u s  r i n g
1
2 

Using Your Projector17
Adjusting Projection Image Size
275
(698.50 cm)
206
(523.24 cm)
160
(406.40 cm)
11 5 
(292.10 cm)
69
(175.26 cm)
22.89(58.14 cm)
302.8(769.11 cm)
227(576.58 cm)
177(449.58 cm)
126(320.04 cm)
76(193.04 cm)
25(63.50 cm)Projector to screen distance
39.37(12.0m)29.53(9.0m)22.97(7.0m)16.40(5.0m)9.84(3.0m)3.28(1.0m) 

18Using Your Projector
Using the Control Panel
Screen 
(Diagonal)
Max. 25 
(63.50 cm)76 
(193.04 cm)126 
(320.04 cm)177 
(449.58 cm)227 
(576.58 cm)302.8 
(769.11 cm)
Min. 22.89 
(58.14 cm)69 
(175.26 cm)115 
(292.10 cm)160 
(406.40 cm)206 
(523.24 cm)275 
(698.50 cm)
Screen 
Size 
Max.  
(WxH)20.08 X 
14.9660.63 X 
45.28100.79 X 
75.59141.34 X 
105.91181.89 X 
136.22242.13 X 
181.89
(51 cm X  
38 cm)(154 cm X 
115 cm)(256 cm X 
192 cm)(359 cm X 
269 cm)(462 cm X 
346 cm)(615 cm X 
462 cm)
Min.  
(WxH)...

Using Your Projector19
1LAMP warning light If the LAMP amber indicator is on or blinking, 
one of the following problems could be occurring:
• Lamp is reaching its end of usable life
• Lamp module is not properly installed
• Lamp driver failure
• Color wheel failure
For more information, see Troubleshooting Your 
Projector on page 41 and Guiding Signals on 
page 45.
2TEMP warning light If the TEMP amber indicator is on or blinking, 
one of the following problems could be occurring:
• Internal temperature...

20Using Your Projector
7Down   / Keystone 
adjustment Press to navigate through the On-Screen Display 
(OSD) Menu items.
Press to adjust image distortion caused by tilting 
the projector (+40/-35 degrees).
8Menu  Press to activate the OSD. Use the directional 
keys and the Menu button to navigate through 
the OSD.
9Left   / Source Press to navigate through the On-Screen Display 
(OSD) Menu items.
Press to toggle through Analog RGB, Composite, 
Component (YPbPr via VGA), HDMI, and  
S-video sources when...