dell latitude x300 User Manual

							Dell Diagnostics: Dell Latitude X300 Service Manual 
test, press ; to retest the component that failed, press . 
l     If failures are detected during the Pre-boot System Assessment, write 
down the error code(s) and contact Dell before continuing on to the De\
ll 
Diagnostics.
If the Pre-boot System Assessment completes successfully, you receive th\
e 
message Booting Dell Diagnostic Utility Partition. Press any key to 
continue.
6.  Press any key to start the Dell Diagnostics from the diagnostics utility\
 partition  on your hard drive. 
7.  When the Dell Diagnostics Main Menu appears, select the test you want to run. 
Dell Diagnostics Main Menu 
1.  After the Dell Diagnostics loads and the Main Menu screen appears, click the  button for the option you want. 
Option Function 
Express Test Performs a quick test of devices. This test typically takes 10 to 20 
minutes and requires no interaction on your part. Run Express Test 
first to increase the possibility of tracing the problem quickly.
Extended Test Performs a thorough check of devices. This test typically takes an 
hour or more and requires you to answer questions periodically.
Custom Test Tests a specific device. You can customize the tests you want to run.
Symptom Tree Lists the most common symptoms encountered and allows you to 
select a test based on the symptom of the problem you are having.
2.  If a problem is encountered during a test, a message appears with an err\
or code  and a description of the problem. Write down the error code and problem \
description and follow the instructions on the screen. 
If you cannot resolve the error condition, contact Dell. See your Users Guide or 
file:///F|/Service%20Manuals/Dell/Latitude/x300/diag.htm (3 of 4) [2/2\
8/2004 8:26:25 AM] 
						

							Dell Diagnostics: Dell Latitude X300 Service Manual 
Owners Manual for contact information.
NOTE: The Service Tag for your computer is located at the top of each test 
screen. If you contact Dell, technical support will ask for your Service\
 Tag. 
3.  If you run a test from the Custom Test or Symptom Tree option, click the  applicable tab described in the following table for more information. 
Tab Function 
Results Displays the results of the test and any error conditions encountered.
Errors Displays error conditions encountered, error codes, and the problem 
description.
Help Describes the test and may indicate requirements for running the 
test.
Configuration Displays your hardware configuration for the selected device.
The Dell Diagnostics obtains configuration information for all devices 
from the system setup program, memory, and various internal tests, 
and it displays the information in the device list in the left pane of t\
he 
screen. The device list may not display the names of all the 
components installed on your computer or all devices attached to 
your computer.
Parameters Allows you to customize the test by changing the test settings.
4.  When the tests are complete, close the test screen to return to the Main Menu  screen. To exit the Dell Diagnostics and restart the computer, close the\
 Main 
Menu screen. 
Back to Contents Page
 
file:///F|/Service%20Manuals/Dell/Latitude/x300/diag.htm (4 of 4) [2/2\
8/2004 8:26:25 AM] 
						

							System Components: Dell Latitude X300 Service Manual 
Back to Contents Page 
System Components 
Dell™ Latitude™ X300 Service Manual 
NOTICE: Only a certified service technician should perform repairs on your 
computer. Damage due to servicing that is not authorized by Dell is not \
covered 
by your warranty. 
NOTICE: Unless otherwise noted, each procedure in this manual assumes that a 
part can be replaced by performing the removal procedure in reverse orde\
r. 
file:///F|/Service%20Manuals/Dell/Latitude/x300/system.htm (1 of 2) [2\
/28/2004 8:26:26 AM] 
						

							System Components: Dell Latitude X300 Service Manual 
 
1 display  8speakers (2) 7C552
2 hinge covers (2)
see Mini RSL 9reserve battery W2662
3 keyboard tray  10Bluetooth™ module 2U381
4 battery M027011system board
see Mini RSL
5 cooling fan D258912palm rest G0808
6 hard drive
see Mini RSL 13keyboard 5Y730
7 bottom case
see Mini RSL     
Back to Contents Page
 
file:///F|/Service%20Manuals/Dell/Latitude/x300/system.htm (2 of 2) [2\
/28/2004 8:26:26 AM] 
						

							Battery: Dell Latitude X300 Service Manual 
Back to Contents Page 
Battery 
Dell™ Latitude™ X300 Service Manual 
  Removing a Battery
  Installing the Battery
Removing a Battery
 CAUTION: Before performing these procedures, disconnect the modem 
from the telephone wall jack.
 CAUTION: Before you begin any of the procedures in this section, follow 
the safety instructions in the System Information Guide.
NOTICE: If you choose to replace the battery with the computer in standby 
mode, you have up to 1 minute to complete the battery replacement. The 
computer will shut down shortly after this. 
1.  Ensure that the computer is turned off, suspended in a power management \
 mode, or connected to an electrical outlet. 
2.  If the computer is connected to a media base (docked), undock it. See \
the  documentation that came with your media base for instructions. 
3.  Slide the battery latch releases on the bottom of the computer and remov\
e the  battery from the bay. 
file:///F|/Service%20Manuals/Dell/Latitude/x300/battery.htm (1 of 3) [\
2/28/2004 8:26:26 AM] 
						

							Battery: Dell Latitude X300 Service Manual 
 
1 battery latch release (2) G0767
Installing the Battery
To install the battery, slide the battery or the optional extended batte\
ry into the bay 
until the latch release clicks.
file:///F|/Service%20Manuals/Dell/Latitude/x300/battery.htm (2 of 3) [\
2/28/2004 8:26:26 AM] 
						

							Battery: Dell Latitude X300 Service Manual 
 
1 optional extended battery Y0037
Back to Contents Page
 
file:///F|/Service%20Manuals/Dell/Latitude/x300/battery.htm (3 of 3) [\
2/28/2004 8:26:26 AM] 
						

							Memory, Modem, and Mini PCI Card Modules: Dell Latitude X300 Service Man\
ual 
-cBack to Contents Page 
Memory, Modem, and Mini PCI Card 
Modules 
Dell™ Latitude™ X300 Service Manual 
  Adding Memory
  Replacing a Modem
  Adding a Mini PCI Card
Adding Memory
You can increase your computer memory by installing a memory module on t\
he 
system board. See the Specifications section in your System Information Guide for 
information on the memory supported by your computer. Be sure to add onl\
y a 
memory module that is intended for your computer.
NOTE: Memory modules purchased from Dell are covered under your computer 
warranty. 
 CAUTION: Before you begin any of the procedures in this section, follow 
the safety instructions in the System Information Guide.
1.  Ensure that the work surface is flat and clean to prevent scratching\
 the  computer cover. 
2.  Save and close any open files, exit any open programs, and shut down\
 the  computer. 
3.  If the computer is connected to the media base (docked), undock it\
. See the  documentation that came with your media base for instructions. 
4.  Disconnect the computer from the electrical outlet. 
5.  Wait 10 to 20 seconds, and then disconnect any attached devices. 
6.  Remove any installed PC Cards and battery. 
file:///F|/Service%20Manuals/Dell/Latitude/x300/upgrades.htm (1 of 14)\
 [2/28/2004 8:26:28 AM] 
						

							Memory, Modem, and Mini PCI Card Modules: Dell Latitude X300 Service Man\
ual 
NOTICE: Handle components and cards by their edges, and avoid touching pins 
and contacts. Ground yourself by touching a metal connector on the back \
of the 
computer. Continue to ground yourself periodically during this procedure\
. 
7.  Turn the computer over, unscrew both captive screw(s) from the mem\
ory  module/Mini PCI/modem cover, and remove the cover. 
 
1 captive screw (2)  
2 memory module cover H0164
NOTICE: To prevent damage to the memory module connector, do not use 
tools to spread the memory module securing clips. 
file:///F|/Service%20Manuals/Dell/Latitude/x300/upgrades.htm (2 of 14)\
 [2/28/2004 8:26:29 AM] 
						

							Memory, Modem, and Mini PCI Card Modules: Dell Latitude X300 Service Man\
ual 
8.  If you are replacing a memory module, remove the existing module. 
NOTICE: Handle components and cards by their edges, and avoid touching pins 
and contacts. Ground yourself by touching a metal connector on the back \
of the 
computer. Continue to ground yourself periodically during this procedure\
. a.  Use your fingertips to carefully spread apart the securing clips on \
each end  of the memory module connector until the module pops up. 
b.  Remove the module from the connector. 
 
1 memory module
see Mini RSL
2 securing clips (2)  
file:///F|/Service%20Manuals/Dell/Latitude/x300/upgrades.htm (3 of 14)\
 [2/28/2004 8:26:29 AM]