Dell 2009wfp Users Guide

Back to Contents Page    
 
Setting Up the Monitor   
2009W  Flat Panel Monitor Users Guide  
   Attaching the Stand  
   Connecting the Monitor  
   Organizing the Cables  
   Attaching the  Dell Soundbar (optionalyf  
   Removing the Stand    
Attaching the Stand  
 
Place the s tand  on a flat surface and  follow these steps to attach the monitor stand:  
1. Fit the groove on the back of the monitor to the two tabs on the upper part of the stand.  
2. Lower the monitor so that the monitor mounting...

 
After you have completed connecting the DVI/VGA cable, follow the procedure below to connect the USB cable to the computer and complete your monitor 
setup:  
l Connect the upstream USB port (cable supplied) to an appropriate USB port on your computer.   
l Connect USB peripherals to the downstream USB ports (rear or side) on the monitor. (See  rear  or  bottom  view for details.)   
l Plug the power cables for your computer and monitor into a nearby outlet.   
l Turn on the monitor and the computer....

 
Removing the Stand  
Complete the following steps to remove the stand:  
 
1. Rotate the stand to allow access to the stand release button.  
2. P ress and hold the Stand release button.  
3. Lift the stand up and away from the monitor .   
Back to Contents Page    NOTICE:  Do not use with any device other than the Dell Soundbar. 
NOTE: Soundbar Power Connector +12V DC output is for optional Dell Soundbar only. 
1. Working from the rear of the monitor, attach the Dell Soundbar by aligning the two slots...

Back to Contents Page    
 
Solving Problems    
 
   Troubleshooting Your Monitor  
   Common Problems  
   Product Specific Problems  
   Universal Serial Bus Specific Problems  
   Dell™ Soundbar Troubleshooting  
   
Troubleshooting Your Monitor  
Self - Test Feature Check  
Your monitor provides a self - test feature that allows you to check whether your monitor is functioning properly. If your monitor and computer are properly 
connected but the monitor screen remains dark, run the monitor self -...

Missing Pixels LCD screen has 
spots l Cycle power on - off.  
l Pixel that is permanently off is a natural defect that can occur in LCD technology .    
Stuck - on Pixels LCD screen has 
bright spots l Cycle power on - off.  
l Pixel that is permanently off is a natural defect that can occur in LCD technology .    
Brightness Problems Picture too dim or 
too bright l Reset the monitor to Factory Settings.  
l Auto Adjust via OSD.  
l Adjust brightness & contrast controls via OSD.    
Geometric...