Dell 1355cn User Guide

Loading Paper59
8
Loading Paper
 NOTE: To avoid paper jams, do not remove the priority sheet inserter while a 
printing is in progress.
 
NOTE: Use only laser print media. Do not use ink jet paper in your printer.
 
NOTE: For printing envelopes, see Loading Print Media on page 201.
Loading Print Media in the Multipurpose Feeder 
(MPF)
1Open the front cover by pulling out the instruction sheet.
2Pull the priority sheet inserter (PSI) out.
 

60Loading Paper
3Remove the instruction sheet attached to the PSI with adhesive tape.
 NOTE: Read the instruction sheet before you use the PSI.
4Pull the length guide forward until it stops.
 

Loading Paper61
5Pull the MPF extension forward until it stops.
6Adjust the paper width guides to their maximum width.
 

62Loading Paper
7Before loading the print media, flex the sheets back and forth, and then 
fan them. Straighten the edges of the stack on a level surface.
8Load paper on the MPF with the top edge first and with the recommended 
print side facing up.
 

Loading Paper63
9Adjust the width guides and length guides until they rest lightly against 
the edges of the stack of print media.
10Slide the length guide towards the printer until it touches the print media.
 

64Loading Paper
 NOTE: Depending on the size of print media, first slide the MPF extension 
backward until it stops, and then pinch the length guide and slide it backward 
until it touches print media.
 

Loading Paper65
11Insert the PSI into the printer and then align the PSI to the marking on 
the paper tray.
 

66Loading Paper
12Select the paper type from the printer driver if the loaded print media is 
not standard plain paper. If a user-specified print media is loaded in the 
MPF, you must specify the paper size setting by using the printer driver.
Loading Print Media in the Priority Sheet Inserter 
(PSI)
1Open the front cover.
2Slide the PSI forward, and then align the PSI to the marking on the paper 
tray.
 

Loading Paper67
3Before loading the print media, flex the sheets back and forth, and then 
fan them. Straighten the edges of the stack on a level surface.
4Load print media on the PSI with the top edge first and with the 
recommended print side facing up.
 

68Loading Paper
5Adjust the width guides until they rest lightly against the edges of the 
stack of print media.
6Select the paper type from the printer driver if the loaded print media is 
not standard plain paper. If a user-specified print media is loaded in the 
PSI, you must specify the paper size setting by using the printer driver.