D-Link Router DIR-826L User Manual

56D-Link DIR-826L User Manua\f
Section 3 - Confi\buration
IPv6 Internet Conne\ftion Setup Wizard
On this pa\be, the user can confi\bure the IPv6 Connection type usin\b the IPv6 Internet Connection Setup Wizard.
C\fick the IPv6.Internet. Connection. Setup.Wizard button and the router wi\f\f \buide 
you throu\bh a few simp\fe steps to \bet your network up and runnin\b.
C\fick Next to continue to the next pa\be. C\fick Cance\b to discard the chan\bes made 
and return to the main pa\be.
The  router  wi\f\f...

57D-Link DIR-826L User Manua\f
Section 3 - Confi\buration
However,  if  the  automatic  detection  fai\fs,  the  user  wi\f\f  be  prompt  to  either Try.
again.or to c\fick on the Guide.me.through. the.IPv6. settings button to initiate the 
manua\f continua\f of the wizard.
There  are  severa\f  connection  types  to  choose  from.  If  you  are  unsure  of  your 
connection method, p\fease contact your IPv6 Internet Service Provider. 
Note: If  usin\b  the  PPPoE  option,  you  wi\f\f  need  to  ensure...

58D-Link DIR-826L User Manua\f
Section 3 - Confi\buration
IPv6.over.PPPoE
After  se\fectin\b  the  IPv6  over  PPPoE  option,  the  user  wi\f\f  be  ab\fe  to  confi\bure  the 
IPv6  Internet  connection  that  requires  a  username  and  password  to  \bet  on\fine. 
Most DSL modems use \uthis type of connection.
The fo\f\fowin\b parameters wi\f\f be avai\fab\fe for confi\buration:
PPPoE.Session:Se\fect  the  PPPoE  Session  va\fue  used  here.  This 
option  wi\f\f  state  that  this  connection...

59D-Link DIR-826L User Manua\f
Section 3 - Confi\buration
Static.IPv6.Address.Connection
This mode is used when your ISP provides you with a set IPv6 addresses that does not chan\be. The IPv6 information is manua\f\fy entered in your 
IPv6  confi\buration  settin\bs. You  must  enter  the  IPv6  address,  Subnet  Prefix  Len\bth,  Defau\ft  Gateway,  Primary  DNS  Server,  and  Secondary  DNS 
Server. Your ISP provides you with a\f\f this information.
Use.Link-Loca\b.
Address:
IPv6.Address:...

60D-Link DIR-826L User Manua\f
Section 3 - Confi\buration
The fo\f\fowin\b parameters wi\f\f be avai\fab\fe for confi\buration:
6rd IPv6 Prefix:Enter the 6rd IPv6 address and prefix va\fue used 
here.
IPv4 Address:Enter the IPv4 address used here.
Mask Length:Enter the IPv4 mask \fen\bth used h\uere.
Assigned IPv6 Prefix:Disp\fays the IPv6 assi\bned prefix va\fue here.
6rd Border Relay IPv4 
Address:
Enter the 6rd border re\fay IPv4 address used here.
IPv6 DNS Server:Enter the primary DNS Server address...

61D-Link DIR-826L User Manua\f
Section 3 - Confi\buration
IPv6 Manual Setup
There are severa\f connection types to choose from: Auto Detection, Static IPv6, Autoconfi\buration (SLAAC/DHCPv6), PPPoE, 
IPv6 in IPv4 Tunne\f, 6to4, 6rd, and Link-\foca\f. If you are unsure of your connection method, p\fease contact your IPv6 Internet 
Service Provider. 
Note: If usin\b the PPPoE option, you wi\f\f need to ensure that any PPPoE c\fient software on your computers has been removed 
or disab\fed.
Auto Dete\ftion...

62D-Link DIR-826L User Manua\f
Section 3 - Confi\buration
Stati\f IPv6
Se\fect Static.IPv6 from the drop-down menu.
Enter the address settin\bs supp\fied by your Internet provider 
(ISP). 
Enter the LAN (\foca\f) I\uPv6 address for the router. 
Disp\fays the Router’s LAN Link-Loca\f Address.
Check to enab\fe the Autoconfi\buration feature.
Se\fect Statefu\b.(DHCPv6), SLAAC .+ .RDNSS  or SLAAC .+.
State\bess.DHCPv6. 
Enter the start IPv6 Address for the DHCPv6 ran\be for your 
\foca\f computers.
Enter...

63D-Link DIR-826L User Manua\f
Section 3 - Confi\buration
Auto\fonfiguration
Se\fect Autoconfiguration.(State\bess/DHCPv6)  from  the 
drop-down menu.
Se\fect either \fbtain. DNS.server. address. automatica\b\by or 
Use.the.fo\b\bowing.DNS.Address.
Enter the primary and secondary DNS server addresses. 
Enter the LAN (\foca\f) I\uPv6 address for the router. 
Disp\fays the Router’s LAN Link-Loca\f Address.
Check to enab\fe the Autoconfi\buration feature.
Se\fect Statefu\b.(DHCPv6), SLAAC .+ .RDNSS  or...

64D-Link DIR-826L User Manua\f
Section 3 - Confi\buration
PPPoE
Se\fect PPPoE from the drop-down menu.
Enter  the  PPPoE  account  settin\bs  supp\fied  by  your  Internet 
provider (ISP). 
Se\fect Static if your ISP assi\bned you the IP address, subnet mask, 
\bateway, and DNS server addresses. In most cases, se\fect Dynamic.
Enter the IP address (Static PPPoE on\fy).
Enter your PPPoE user name.
Enter your PPPoE password and then retype the password in the 
next box.
Enter the ISP Service Name...

65D-Link DIR-826L User Manua\f
Section 3 - Confi\buration
Auto\fonfiguration Type:
IPv6 Address Range Start:
IPv6 Address Range End:
IPv6 Address Lifetime:
Se\fect Statefu\b.(DHCPv6), SLAAC.+.RDNSS or SLAAC.+.State\bess.DHCPv6.
Enter the start IPv6 Address for the DHCPv6 ran\be for your \foca\f computers.
Enter the end IPv6 Address for the DHCPv6 ran\be for your \foca\f computers.
Enter the IPv6 Address Lifetime (in minutes).