Compaq hp pavilion ze4200 notebook pc User Manual
Here you can view all the pages of manual Compaq hp pavilion ze4200 notebook pc User Manual. The Compaq manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 41
Removing the Hard Disk Drive (User-Replaceable) Required Equipment • #1 Phillips screwdriver. Removal Procedure Important If you are installing a new hard disk drive, load the factory software and operating system on the drive as described in “Recovering the Factory Software,” as shown on the next page. 1. 2. 3. Unplug the AC adapter, if present, and then remove the battery. On the bottom of the notebook, remove the hard drive rubber screw plugs and retaining screws. Carefully pull the...
Page 42
4. 5. Remove the screws from the drive and drive tray, then lift the drive out of the tray. Remove the connector from the hard disk drive. Figure 2-6. Removing the Hard Disk Drive Tray Recovering the Factory Software The following procedure describes how to recover the notebook’s original software and operating system. This process can take up to 15 minutes to complete. (For more information about recovering the factory software installation, see the readme.txt file in the root directory of...
Page 43
Replacing Small Parts (User-Replaceable) The user can replace the following small parts. Table 2-4. Replacing Small Parts (User-Replaceable) Part Replacement Procedure Rubber screw plugs, display (on display bezel) Insert a small flat-blade screwdriver under the rubber screw plug and pry it loose. To replace, firmly press the adhesive side of the screw plug into the recess. Door, mini-PCI On the bottom of the notebook, loosen the screws that secure the mini-PCI door to the bottom case and...
Page 44
Removing the Keyboard Cover (User-Replaceable) Required Equipment • #1 Phillips screwdriver. • Small flat-blade screwdriver. Removal Procedure 1. 2. 3. Unplug the AC adapter, if present, and then remove the battery. Remove the two hinge cover screws that secure the keyboard cover to the rear of the notebook. Carefully insert a flat-blade screwdriver blade under the keyboard cover near the right end, then near the center, then near the left end, and then gently lift up the center of the...
Page 45
4. If necessary, while holding the center of the cover, carefully insert the flat-blade screwdriver under the right side of the display assembly hinge, gently pry up, and then lift the cover out. This procedure might need to be repeated on the left side of display assembly hinge to completely remove the cover. Screw, M2.5×4mm (2) Figure 2-7. Removing the Keyboard Cover Reassembly Note • Insert the tabs on the left- and right-center of the panel into the mating slots under the keyboard,...
Page 46
Removing the Speaker Assembly (User-Replaceable) Note: The following speaker assembly removal procedures apply only to Compaq Evo Notebook N1010v and Compaq Presario 1100 Series notebooks. The Pavilion ze4100 Series notebook speakers are integrated into the top case. Refer to the “Removing the Top Case” section later in this chapter for procedures on removing the top case and speakers on the Pavilion ze4100 Series notebook. Required Equipment • #1 Phillips screwdriver. Removal Procedure 1....
Page 47
Removing the Keyboard (User-Replaceable) Required Equipment • #1 Phillips screwdriver. Removal Procedure 1. 2. 3. 4. 5. 6. Unplug the AC adapter, if present, and remove the battery. Remove the keyboard cover (page 2-10). Remove the screws that secure the keyboard to the top case. Lift up on the keyboard at the switchboard PCA end and then pull it toward the display assembly to release the tabs from the top case. Turn the keyboard over and disconnect the motherboard cable. Remove the...
Page 48
Screw, M2.5×4mm (4) Figure 2-9. Removing the Keyboard 2-14 Removal and Replacement Service Manual
Page 49
Removing the Switchboard PCA (User-Replaceable) Required Equipment • #1 Phillips screwdriver. Removal Procedure 1. 2. 3. 4. 5. Unplug the AC adapter, if present, and then remove the battery. Remove the keyboard cover (page 2-10). Disconnect both the 2-wire and 4-wire cables that connect the switchboard PCA to the top case and speaker assembly, respectively. Remove the screws that secure the keyboard and switchboard PCA to the top case (page 2-13). Gently lift up on the keyboard,...
Page 50
Removing the CD/DVD Drive (User-Replaceable) Required Equipment • #1 Phillips screwdriver. Removal Procedure 1. 2. 3. 4. 5. Unplug the AC adapter, if present, and remove the battery. Remove these additional assemblies: • Keyboard cover (page 2-10). • Keyboard (page 2-13). Remove the screws that secure the CD/DVD drive to the top case and motherboard. Place your index finger in the top case opening and push out on the CD/DVD drive to release it from the motherboard. Remove the CD/DVD...