Cisco Router 860, 880 Series User Manual

      System Message Logging
Configuring System Message Logging
7
Cisco 800 Series Integrated Services Routers Wireless Software Configuration Guide
xx-xxxxx-xx
NoteSpecifying a level causes messages at that level and numerically lower levels to be displayed at the 
destination.
To disable logging to the console, use the no logging console command in global configuration mode. 
To disable logging to a terminal other than the console, use the no logging monitor command in global 
configuration mode. To...

      System Message Logging
Configuring System Message Logging
8
Cisco 800 Series Integrated Services Routers Wireless Software Configuration Guide
xx-xxxxx-xx
Limiting Syslog Messages Sent to the History Table and to SNMP
If you have enabled syslog message traps to be sent to an SNMP network management station by using 
the snmp-server enable trap command, you can change the level of messages sent and stored in the 
access point history table. You can also change the number of messages that are stored...

      System Message Logging
Configuring System Message Logging
9
Cisco 800 Series Integrated Services Routers Wireless Software Configuration Guide
xx-xxxxx-xx
Setting a Logging Rate Limit
You can set a limit on the number of messages that the access point logs per second. You can enable the 
limit for all messages or for messages sent to the console, and you can specify that messages of a specific 
severity are exempt from the limit.
To enable a logging rate limit, follow these steps, beginning in...

      System Message Logging
Configuring System Message Logging
10
Cisco 800 Series Integrated Services Routers Wireless Software Configuration Guide
xx-xxxxx-xx
Step 3Ensure the syslog daemon reads the new changes by entering this command:
$ kill -HUP `cat /etc/syslog.pid`
For more information, see the man syslog.conf and man syslogd commands on your UNIX system.
Configuring the UNIX System Logging Facility
When sending system log messages to an external device, you can cause the access point to...

      System Message Logging
Configuring System Message Logging
11
Cisco 800 Series Integrated Services Routers Wireless Software Configuration Guide
xx-xxxxx-xx
Displaying the Logging Configuration
To display the current logging configuration and the contents of the log buffer, use the show logging 
command in privileged EXEC mode. For information about the fields in this display, refer to the Cisco 
IOS Configuration Fundamentals Command Reference for Release 12.2.
To display the logging history file,...

      System Message Logging
Configuring System Message Logging
12
Cisco 800 Series Integrated Services Routers Wireless Software Configuration Guide
xx-xxxxx-xx 

 
F-1
Book Title
OL-xxxxx-xx
APPENDIXF
Radio Channel Settings
This appendix lists the radio channels supported by Cisco access products in the regulatory domains of 
the world. 
 IEEE 802.11n (2.4-GHz Band), page F-2 

 
F-2
Book Title
OL-xxxxx-xx
Appendix F      Radio Channel Settings
  IEEE 802.11n (2.4-GHz Band)
IEEE 802.11n (2.4-GHz Band)
Ta b l e F-1 lists the channel identifiers, channel center frequencies, and regulatory domains for IEEE 
802.11n 2.4GHz radio.
Ta b l e F-1 Channels for IEEE 802.11n 2.4-GHz Radio Band
Channel 
IdentifierCenter Frequency 
(MHz)
Regulatory Domains
Americas 
(–A)EMEA 
(–E)
Japan 
(–P)
12412XXX
22417XXX
32422XXX
42427XXX
52432XXX
62437XXX
72442XXX
82447XXX
92452XXX
102457XXX...