Cisco Router 860, 880 Series User Manual

17-33
Book Title
OL-xxxxx-xx
Chapter 17      Administering the Wireless Device
  Configuring the Authentication Cache and Profile
The following commands that support this feature are included in Cisco IOS Release 12.3(7):
cache expiry
cache authorization profile
cache authentication profile
aaa cache profile
NoteSee the Cisco IOS Command Reference for Cisco Aironet Access Points and Bridges, Versions 
12.4(10b)JA and 12.3(8)JEC for information about these commands.
The following is a configuration...

17-34
Book Title
OL-xxxxx-xx
Chapter 17      Administering the Wireless Device
  Configuring the Authentication Cache and Profile
aaa cache profile admin_cache all 
! 
aaa session-id common ! 
! 
! bridge irb 
! 
! interface Dot11Radio0 
no ip address 
no ip route-cache shutdown 
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0 
station-role root bridge-group 1 
bridge-group 1 subscriber-loop-control 
bridge-group 1 block-unknown-source no bridge-group 1...

17-35
Book Title
OL-xxxxx-xx
Chapter 17      Administering the Wireless Device
  Configuring the Access Point to Provide DHCP Service
! ! 
! 
line con 0 transport preferred all 
transport output all 
line vty 0 4 transport preferred all 
transport input all 
transport output all line vty 5 15 
transport preferred all 
transport input all transport output all 
! 
end
Configuring the Access Point to Provide DHCP Service
These sections describe how to configure the wireless device to act as a DHCP server:...

17-36
Book Title
OL-xxxxx-xx
Chapter 17      Administering the Wireless Device
  Configuring the Access Point to Provide DHCP Service
To configure an access point to provide DHCP service and specify a default router, follow these steps 
beginning in privileged EXEC mode:
Use the no form of these commands to return to default settings.
This example shows how to configure the wireless device as a DHCP server, exclude a range of IP 
address, and assign a default router:
AP# configure terminal
AP(config)# ip...

17-37
Book Title
OL-xxxxx-xx
Chapter 17      Administering the Wireless Device
  Configuring the Access Point to Provide DHCP Service
Monitoring and Maintaining the DHCP Server Access Point
These sections describe commands you can use to monitor and maintain the DHCP server access point:
 Show Commands, page 17-37
 Clear Commands, page 17-37
 Debug Command, page 17-38
Show Commands
In privileged EXEC mode, enter the commands in Ta b l e 17-4 to display information about the wireless 
device as DHCP...

17-38
Book Title
OL-xxxxx-xx
Chapter 17      Administering the Wireless Device
  Configuring the Access Point for Secure Shell
Debug Command
To enable DHCP server debugging, use this command in privileged EXEC mode:
debug ip dhcp server { events | packets | linkage }
Use the no form of the command to disable debugging for the wireless device DHCP server.
Configuring the Access Point for Secure Shell
This section describes how to configure the Secure Shell (SSH) feature. 
NoteFor complete syntax and usage...

17-39
Book Title
OL-xxxxx-xx
Chapter 17      Administering the Wireless Device
  Configuring Client ARP Caching
Configuring Client ARP Caching
You can configure the wireless device to maintain an ARP cache for associated client devices. 
Maintaining an ARP cache on the wireless device reduces the traffic load on your wireless LAN. ARP 
caching is disabled by default.
This section contains this information:
 Understanding Client ARP Caching, page 17-39
 Configuring ARP Caching, page 17-39
Understanding...

17-40
Book Title
OL-xxxxx-xx
Chapter 17      Administering the Wireless Device
  Configuring Multiple VLAN and Rate Limiting for Point-to-Multipoint Bridging
This example shows how to configure ARP caching on an access point:
AP# configure terminalAP(config)# dot11 arp-cache
AP(config)# end
Configuring Multiple VLAN and Rate Limiting for 
Point-to-Multipoint Bridging
This feature modifies the way point-to-multipoint bridging can be configured to operate on multiple 
VLANs with the ability to control...

 
PART 4
Additional Information