Christie Digital Systems M Series User Manual

M-Series User Manual6-5020-100009-01 Rev.1 (07/08)
6.1.12Pixel Defects
6.1.13Image Artifacts
6.1.14Picture Centering
6.2 FEATURE SET
6.2.1Airflow 
6.2.2Air Filters (Optional)
6.2.3Dust Sealing
Red  0 bright, 1 dark
Green 0 bright, 0 dark
Blue  0 bright, 2 dark non-adjacent
Evaluate on multi-burst or fine grid test pattern No visible artifacts with observer at 1 full screen 
height from image 
1080p centering error  ±5% of vertical offset (32 pixels)
SXGA+ centering error ±5% of vertical offset (26...

Section 6: Specifications
M-Series User Manual6-6020-100009-01 Rev.1 (07/08)
6.2.4ILS (Intelligent Lens System)
6.2.5Projection Lens Compatibility
6.2.6Dynamic Iris 
Motorized lenses and lens mount with position 
encoding              Zoom, focus, horizontal and vertical offsets
Accuracy ±2 pixel
Manual control 1/3 pixel fine movement control per button press on 
any applicable User Interface (e.g., remote).
Calibration
User Configurable Calibration Modes Automatic calibration on lens change detection...

M-Series User Manual6-7020-100009-01 Rev.1 (07/08)
6.2.7Automatic Fans
6.2.8Automatic Color Filtering
6.2.9Constant Lamp Output Management
6.2.10Shutter 
6.2.11Lamps
Temperature sensitive fan speed control Fans automatically adjust to required speed to 
maintain projector at proper operating range as 
function of outside ambient temperature
Standby All fans are off when projector is in standby and not 
running active loop-through on a Twin HDMI 
option card
Temperature range for variable fan speed  5 to...

Section 6: Specifications
M-Series User Manual6-8020-100009-01 Rev.1 (07/08)
6.2.12Status LED
6.2.13Electronics/SW 
Status LED’s               Located at back of projector
LED STATES
Lamp 1, Lamp 2Off – Lamps are off
Yellow – Lamp time has expired and lamp should be replaced
Green – Lamp is on and operating correctly
Flashing red – Lamp has malfunctioned
PowerOff – AC power is off
Yellow – AC is present but projector is in standby
Green – Projector is powered up and operating normally
Flashing...

M-Series User Manual6-9020-100009-01 Rev.1 (07/08)
6.3 IMAGE PROCESSOR PERFORMANCE
6.4 INPUT (SOURCE SIGNAL) COMPATIBILITY 
6.4.1Analog (Only) Input
6.4.2Twin HDMI Input
Min input pixel rate 13 Mpix/s
Max input pixel rate 165 Mpix/s Standard mode Single image processor (SIPC)
Max input resolution 2048x1536 (QXGA)
Min input resolution 640x400
Max input frame rate with 
Single Image Processor 
Card50Hz at 2048x1536 (QXGA) * * With sources that can output minimum 
blanking, otherwise lower vertical rates...

Section 6: Specifications
M-Series User Manual6-10020-100009-01 Rev.1 (07/08)
6.4.3Dual Link DVI Input
6.4.4Video Decoder Input
6.4.5Dual Standard Definition, High Definition or Serial Digital Input
6.5 CONTROL SIGNAL COMPATIBILITY 
6.5.1Remote Dual Frequency
Connectors 1 dual link DVI-I
1 analog 15-pin VGA
Color spaces/signal types HDCP support
A/D conversion 10 bits for single link DVI input
8 bits for dual link DVI inputs
Frequency 165 MPixel/s analog
300 Mpix/s Dual link DVI (requires DIPC)...

M-Series User Manual6-11020-100009-01 Rev.1 (07/08)
6.5.2Control Receiver
6.5.3RS232
6.5.4RS422
6.5.5Ethernet
6.5.6USB 2.0 Device Port 
6.5.7GPIO
6.5.8DMX512 Interface 
6.5.9Built-In Keypad and Display
Number of sensors 1 front, 1 rear 
Coverage 130 degrees coverage in-line with lens at 3 m 
distance
Modulation (carrier) frequency  Dual frequency (38 kHz, 455 kHz)
Number of ports 2
Connector 1 female 9-pin Dsub (IN)
1 male 9-pin Dsub (OUT)
Max bit rate 115.2 kbps
Flow control Xon/Xoff
Number of ports 1...

Section 6: Specifications
M-Series User Manual6-12020-100009-01 Rev.1 (07/08)
6.5.10 AMX/Crestron Support
6.6 POWER REQUIREMENTS
AMX Device Discovery Partner
Crestron Integrated Partner
Rated voltage  100 VAC – 240 VAC
Rated Current (dual lamp operation)
370W 1080p 12 A @ 100 VAC
200 W 1080p 9 A @ 100 VAC
370W SXGA+ 12 A @ 100 VAC
200W SXGA+ 9 A @ 100 VAC
Line frequency 50/60 Hz
AC Input Coupler 15 A, 250 VAC
Type of connector IEC 320-C14 with wire cable clamp
Line Cord 14AWG type FT1 with plug, NEMA...

M-Series User Manual6-13020-100009-01 Rev.1 (07/08)
6.6.1Lamp Specification
6.7 PHYSICAL SPECIFICATIONS
6.7.1Size
6.7.2Adjustment
6.7.3Weight
6.7.4Operating Position
6.7.5Cosmetics
PAINT AND COLORS
Type Mercury Lamp (Hg)
Power
350 W HD/350 W SX+ 300 W min, 370 W max (software adjustable)
200 W HD/200 W SX+ 150 W min, 200 W max (software adjustable)
350W Lamp rated lamp life to 50% 
brightness (2 hrs on, 15 min off duty cycle)1300 hrs typical @ 370W
1500 hrs typical @ 350W
2000 hrs typical @ 300W
200W...

Section 6: Specifications
M-Series User Manual6-14020-100009-01 Rev.1 (07/08)
6.8 RELIABILITY AND SERVICEABILITY
6.8.1Reliability
6.8.2Serviceability
6.9 ENVIRONMENT
6.9.1Temperature/Humidity/Altitude
6.10 ACCESSORIES AND SERVICE COMPONENTS
MTBF – excluding consumable components 15,000 hrs
Consumable components Air filters, fans, lamps
Time to replace any option card 1 minute 
Time to replace lamp 1 minute
Time to replace projection lens 30 seconds 
Time to replace air filter 1 minute 
Operating...