Casio Exilim EX Z690 User Manual

21Quick Start Basics
NOTE
• Each country controls its local time offset and the use of summer time, and so they 
are subject to change.
• Removing the battery from the camera too soon after configuring time and date 
settings for the first time can cause the settings to be reset to their factory defaults. 
Do not remove the battery for at least 24 hours after configuring settings.
Though the camera has built-in memory that can be used to store images and 
movies, you probably will want to purchase a...

22Quick Start Basics
1.Press [ON/OFF] (Power) to turn off 
the camera and then open the 
battery cover.
Slide the battery cover slider towards 
OPEN and then open it as indicated by 
the arrows in the illustration.
2.Load a memory card.
Positioning the memory card so its front 
is facing upwards (towards the monitor 
screen side of the camera), slide it into 
the card slot all the way in until you hear 
it click securely into place.
3.Close the battery cover.
Close the battery cover and then shift the...

23Quick Start Basics
To replace the memory card
Press the memory card and then release it. This 
will cause it to pop out of the memory card slot 
slightly. Pull the card out the rest of the way and 
then insert another one.
• Never remove a card from the camera while 
the back lamp is flashing green. Doing so can 
cause the image save operation to fail and 
even damage the memory card.
Before using a memory card for the first time with the camera, you must format it.
IMPORTANT!
• Formatting a memory...

24Quick Start Basics
Pressing [ON/OFF] (Power) enters the REC mode so 
you can record images. Pressing [p] (PLAY) while in 
the REC mode enters the PLAY mode, which you can 
use to view snapshots and movies (pages 29, 67).
•Pressing [r] (REC) while in the PLAY mode returns 
to the REC mode.
• Take care to ensure that nothing is restricting or 
coming into contact with the lens as it extends. 
Holding the lens with your hand so it cannot extend 
creates the risk of malfunction.
• About 10 seconds after...

25Quick Start Basics
Your images will not come out clearly if you move the camera when you press the 
shutter button. When pressing the shutter button, be sure to hold the camera as 
shown in the illustration below, and keep it still by pressing your arms firmly against 
your sides as you shoot.
Holding the camera still, carefully press the shutter button and take care to avoid all 
movement as the shutter releases and for a few moments after it releases. This is 
especially important when available...

26Quick Start Basics
You can select one of two auto recording modes (Auto or Premium Auto) according to 
your digital imaging needs.
1.Press [ON/OFF] (Power) to turn on the camera.
The camera will enter the REC mode.
• If the camera is in the PLAY mode, press [r] (REC).
• You also can configure the camera to turn on when you press [r] (REC) or 
[p] (PLAY) (page 109).
2.Press [SET].
3.Use [8] and [2] to select the bottom Control Panel option (BS) and 
then press [SET].
This will display a menu of BEST...

27Quick Start Basics
1.Point the camera at the subject.
If you are using Premium Auto, text will appear in the lower right corner of the 
monitor screen describing the type of shot the camera has detected.
• You can zoom the image, if you want.
To shoot a snapshot
2.Half-press the shutter button to 
focus the image.
When focus is complete, the camera 
will beep, the back lamp will light 
green, and the focus frame will turn 
green.
When you half-press the shutter button, the 
camera automatically adjusts...

28Quick Start Basics
3.Continuing to keep the camera still, press the shutter button the rest of 
the way down.
This records the snapshot.
.If the image does not focus...
If the focus frame stays red and the back lamp is flashing green, it means that the 
image is not in focus (because the subject is too close, etc.). Re-point the camera at 
the subject and try to focus again.
.Shooting with Auto
If the subject is not in the center of the frame...
“Focus lock” (page 58) is the name of a technique you can...

29Quick Start Basics
.Shooting with Premium Auto
• In addition to shutter speed, aperture, and ISO sensitivity, the camera 
automatically executes the following operation as required when shooting with 
Premium Auto.
– Auto Focus is normally performed until you half-press the shutter button.
– Face Detection (page 41)
• Shooting with Premium Auto can cause vibration and noise to occur due to lens 
operation. This does not indicate malfunction.
• When Shooting with Premium Auto, the message “Processing...

30Quick Start Basics
If memory becomes full, you can delete snapshots and movies you no longer need in 
order to free up storage and record more images.
• In either the REC mode or PLAY mode, you can delete files 
simply by pressing [ ] (Delete).
IMPORTANT!
• Remember that a file (image) delete operation cannot be 
undone.
• Deleting an audio snapshot (page 77) deletes both the 
snapshot and the audio file.
• You cannot delete files while movie or audio recording is in progress.
• The delete menu will...