Casio Exilim EX Z5 User Manual

GETTING READY
31
Power Requirements
Your camera is powered by a rechargeable lithium ion
battery (NP-20).
The battery is not fully charged when you use the
camera for the first time after purchasing it. You need
to charge the battery before using the camera for the
first time.
To charge the battery
1.Correctly positioning the positive and
negative terminals of the battery, load the
lithium ion battery into the battery charger.
T-+
Making sure that the positive and negative contacts
are aligned...

GETTING READY
32
2.Plug the battery charger into a household
power outlet.
This will cause the [CHARGE] lamp to turn red.
Charging will take about 90 minutes.
[CHARGE] lamp
AC power cord Battery Charger
 NOTE 
The battery charger is designed for operation with
any power supply in the range of 100V to 240V AC.
Note, however, that the shape of the AC power cord
plug varies according to country or geographic area.
If you plan to use the battery charger in a geographic
area where the power receptacle...

GETTING READY
33
3.The [CHARGE] lamp goes out when charging
is complete.
4.After charging is complete, unplug the battery
charger from the power outlet, and remove
the battery from it.
Always unplug the battery charger from the power
outlet and remove the battery whenever you are not
charging.
 IMPORTANT! 
If the battery or battery charger is very hot or cold
when you start charging or if it becomes hot during
charging, the battery charger will enter a standby
state, which is indicated when its...

GETTING READY
34
To load the battery
1.Slide the battery cover on the bottom of the
camera in the direction indicated by the
arrow, and then swing it open.
2.With the EXILIM logo on the battery facing
upwards (in the direction of the monitor
screen), hold the stopper in the direction
indicated by the arrow as you slide the
battery into the camera.
NP-20 Stopper
(–) marks
Push the bottom of the battery, and make sure that
the stopper securely locks the battery in place.
Downloaded From...

GETTING READY
35
3.Swing the battery cover closed, and then slide
it in the direction indicated by the arrow.
 IMPORTANT! 
Use only the special NP-20 rechargeable lithium ion
battery to power this camera. Use of any other type
of battery is not supported.

 If the camera does not work normally
This can mean there is a problem with how the battery is
loaded. Perform the following steps.
1.Remove the battery from the camera and
check the battery contacts for dirt. If the
contacts are dirty, wipe them...

GETTING READY
36
Low Battery Indicator
The following shows how the battery capacity indicator on
the monitor screen changes as battery power is used. The
 indicator means that remaining battery power is low.
Note that you will not be able to record images while the
battery indicator is 
. Charge the battery immediately
whenever either of these indicators appears.
 IMPORTANT! 
See page 250 for information about battery life.
Due to differences in the power requirements of each
mode, the battery...

GETTING READY
37
To replace the battery
1.Open the battery cover.
2.Pull the stopper in the direction indicated by
the arrow.
This will cause the battery to come part way out of
the slot.
Stopper
3.Release the stopper and pull the battery from
the camera.
Take care so you do not drop the battery.
4.Load a new battery into the camera (page 34).
Downloaded From camera-usermanual.com Casio Manuals 

GETTING READY
38
Power Supply Precautions
Note the following precautions when handling or using the
battery and the charger.

 Battery Handling Precautions
SAFETY PRECAUTIONS
Be sure to read the following Safety Precautions before
using the battery for the first time.
 NOTE 
The term “battery” in this manual refers to the CASIO
NP-20 Rechargeable Lithium Ion Battery.
Use only the battery charger (BC-11L) that comes
with the camera or the optionally available USB
cradle (CA-32) to charge the special...

GETTING READY
39
PRECAUTIONS DURING USE
This lithium ion battery is intended for use with a
CASIO Digital Camera only. For details about the
camera models that this battery can be wed with, see
the user documentation that comes with your camera.
Use of a battery in cold environments shortens the
operating time you can expect on a full charge. Charge
the battery in a location where the temperature is in the
range of 10°C to 35°C (50°F to 95°F). Charging outside
this temperature range can cause charging...

GETTING READY
40
BATTERY STORAGE PRECAUTIONS
Make sure you remove the battery from the camera
when you do not plan to use it for a long time. A battery
left in the camera discharges very small amounts of
power even when power is turned off, which can lead to
a dead battery or the need for longer charging before
the next use.
Store the battery in a cool, dry place (20°C (68°F) or
lower).
USING THE BATTERY
When transporting a battery, keep it either loaded in
the camera or stored in its case.
 Battery...