Canon scanner CanoScan 5600F User Manual

							Scanning Film
9
35 mm Slides 
cPush the Film Holder on the Film Guide inward to 
open it in order (1) and (2) as shown in the figure on 
the right. With the Film Holder being opened and 
lifted, remove the film strip frame.
dAlign the Film Guide’s tab with the FILM symbol on 
the document glass of the scanner.
ePlace a slide or slides face down (correctly viewed 
from below) in the Film Guide as shown in the figure 
on the right.
3Close the document cover.
4Start MP Navigator EX.
Follow the step 2 in Try Scanning on page 5. How to put the film strip frame after slide scanning is done
(A)
Align the  S marks on the film strip frame and the 
T  marks on the Film Guide, and then insert each 
tab on the top of the film strip frame into the Film 
Guide.
(B) Push the edges of the Film Holder inward with your 
fingers to close it firmly.
If the Film Holder does not fit into the Film Guide, press down the whole of it.
(1)
(2)
Calibration Slot
(A)
(B) 
						

							Scanning Film
10
5Click [Film].
6Click [Scan].
7When the preview is displayed, place a check 
mark beside the number(s) of the frame(s) you 
want to scan, and then click [Scan] to start 
scanning.
8When prompted that the scanning completed, click 
[Exit].
9Click [Save] to save the images and close MP 
Navigator EX.
Do not move the scanner while it is 
operating.
Do not move the scanner while it is 
operating.
• Do not leave the film strip in the Film Guide for an extended period of time as heat from the 
unit may damage the film.
• For more information on scanning film, see “Scanning Film” in the Scanning Guide (on-screen 
manual). 
						

							Specifications
11
Specifications
*1Optical Resolution represents the maximum sampling rate based on ISO 14473.*2For film scanning only.*3The fastest speed in Hi-Speed USB mode on Windows PC. Transfer time is not included. Scanning
speed varies according to the document types, scan settings, or specifications of the computer.
*4USB connection to PC
• Specifications are subject to change without notice.
Model Name: K10319 (CanoScan 5600F)CanoScan 5600F
Scanner TypeFlatbed
Sensor TypeCCD 6-line color
Light SourceWhite LED/Cold cathode fluorescent lamp
Optical Resolution 
*14800 x 9600 dpi
Selectable Resolution25-19200 dpi (ScanGear)
Scanning Bit DepthColor
48 bit input (16 bit input for each color (RGB))
48 bit or 24 bit output (16 bit or 8 bit output for each color (RGB))
Grayscale48 bit input (16 bit for each color)
16 bit *2 or 8 bit output 
Scanning Speed 
*3
(Photo or Document)Color14.6 msec./line (4800 dpi), 14.6 msec./line (2400 dpi), 
9.7 msec./line (1200 dpi), 3.7 msec./line (600 dpi), 
1.8 msec./line (300 dpi) Grayscale, B&W
Scanning Speed 
*3 (Film)1.8-58.4 msec./line
Interface
Hi-Speed USB 
*3
Maximum Document SizeA4/Letter: 216 x 297 mm
Film Type/Number of Frames35 mm strip (6 frames max)/35 mm slide (4 frames max)
Scanner Buttons7 buttons (PDF x 4, COPY, SCAN, E-MAIL)
Operating RangeTemperature
10 
°C to 35 °C (50 °F to 95 °F)
Humidity10 % to 90 % RH, 20 % to 80 % RH for film scanning 
without condensation formation
Power RequirementsAC 100-240 V, 50/60 Hz
Power ConsumptionIn operation: 19 W maximum, 
Stand-by: 3.2 W 
*4, Off: 0.4 W *4
Exterior Dimensions (W) x (D) x (H)272 x 491 x 97 mm (10.7 x 19.4 x 3.8 in.)
WeightApproximately 4.3 kg (9.5 lbs.) 
						

							Safety Precautions
12
Safety Precautions
Please read and take note of the following precautions before using the scanner and accessories.
WARNINGIndicates a warning concerning operations that may lead to death or injury to persons if not 
performed correctly. In order to use the scanner safely, always pay attention to these warnings.
CAUTIONIndicates a caution concerning operations that may lead to injury to persons or damage to 
property if not performed correctly. In order to use the scanner safely, always pay attention to these cau-
tions.
About Locations
WARNING• Do not place the scanner near flammable liquids such as alcohol or thinners. If the internal electrical 
parts come in contact with flammable liquids, fire or electrical shock may result.
CAUTION• Do not place the scanner in areas with high humidity, areas subject to direct sunlight, areas with high 
temperatures and areas near flame sources. Fire or electrical shock may result.
• Do not place the scanner on shaky stands, unstable surfaces or surfaces subject to frequent 
vibrations. If the scanner falls, it may cause injuries.
• Do not place heavy objects on the scanner. Objects may fall and cause injuries.
• Do not push the scanner into a narrow cabinet or put a tablecloth on it or place on a thick rug. If the 
scanner has heat, it may cause fire or damage.
About the Power Supply
WARNING• Do not plug the power cord into outlets with voltages other than the specified voltages. Incorrect 
voltages may result in fire or electrical shock.
• Do not place heavy objects on, pull or excessively bend, twist or tie the power cord. Damaged wires 
may cause fire or electrical shock.
• Unplug the power cord from the outlet periodically and use a dry cloth to clean the area around the 
base of the outlet to ensure that all dust is removed. Also do not plug in/unplug the power cord with 
wet hands. Fire or electrical shock may result.
• Do not connect excessive numbers of plugs into one electrical outlet. Fire or electrical shock may 
result.
• Always plug the power cord in all the way. If it is not plugged in completely, fire or electrical shock 
may result.
• Do not use cables other than the one supplied. Fire or electrical shock may result.
CAUTION• When unplugging the power cord, always pull on the main body. Pulling the cord may damage the 
wires and lead to fire or electrical shock.
• Do not place objects around the power cord in case it needs to be unplugged during emergencies.
• If you hear thunder, do not touch the scanner, power cord and cables. Otherwise the lightning stoke 
may cause electrical shock. 
						

							• Microsoft is a registered trademark of Microsoft Corporation.
• Windows is a trademark or registered trademark of Microsoft Corporation in the U.S. and/or other countries.
• Windows Vista is a trademark or registered trademark of Microsoft Corporation in the U.S. and/or other countries.
• Macintosh and Mac are trademarks of Apple Inc., registered in the U.S. and other countries.
• Adobe, Adobe RGB and Adobe RGB (1998) are either registered trademarks or trademarks of Adobe Systems Incorporated 
in the United States and or other countries.
•
©ArcSoft, Inc. All rights reserved for PhotoStudio.• Other names and products not mentioned above may be registered trademarks or trademarks of their respective companies.
FCC Notice (U.S.A. Only)
For 120V, 60Hz model
Model Number : K10319
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 
This device may not cause harmful interference, and (2) this device must accept any interference received, including 
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. 
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of a shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC Rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such changes or 
modifications should be made, you could be required to stop operation of the equipment.
Canon U.S.A., Inc.
One Canon Plaza
Lake Success, NY 11042
1-516-328-5600
WarningWhen you use this product, you should pay attention to the following legal issues:
• Scanning of certain documents, such as bank notes (bank bills), government bonds and public certificates, may be 
prohibited by law and may result in criminal and/or civil liability.
• You may be required under law to obtain authorization from a person possessing copyrights or other legal rights to the 
item being scanned. 
If you are uncertain of the legality of scanning any particular item, you should consult your legal adviser in advance.
General Handling Precautions
WARNING• Do not take apart or modify the scanner and supplies. Fire or electrical shock may result from 
improper handling of its components.
• If you hear unusual noises, see smoke, feel excessive heat or smell anything unusual, immediately 
unplug the power cord and contact your retailer or Canon Customer Support Help Desk. Continued 
use of the scanner may result in fires or electrical shock.
• Do not use flammable sprays near the scanner. Also do not enter metallic objects or spill water, 
liquids, or flammable materials on the scanner. If they enter and contact the inner electrical parts, fire 
or electrical shock may result.
• When cleaning the scanner, always unplug the power cord. Wipe with a soft dry cloth. When it is still 
dirty, use a cloth damped with water and wrung well, and then wipe off moisture with a soft dry cloth. 
Do not use flammable liquids such as alcohol, benzene or thinners. If a flammable liquid enters the 
inner electrical parts or the cables are damaged by plugging/unplugging, fire or electrical shock may 
result.
If anything enters the scanner, immediately unplug the power cord. Then contact your retailer or Canon
Customer Support Help Desk.
CAUTION• Do not release the document cover until it completely opens/closes. If the document cover falls, it 
may lead to pinch your hands or damage the scanner and result in injury.
• Do not place items that weigh 4.4 lbs. (2.0 kg) or more on the document glass. Also, do not press 
heavily (i.e., more than 4.4 lbs. (2.0 kg)) on the document cover or the document glass. The 
document glass may break and cause personal injury.
• Do not bump the document glass or drop heavy books or objects on it. The document glass may 
break and injure you.
• When not in use for extended periods, unplug the power cord for safety.
• When transporting the scanner, always unplug the cables. Damaged cables could cause fire or 
electrical shock.
• Do not use the supplied CD-ROM in regular CD players. It produces excessively loud sound that may 
cause hearing damage.
Setup and Operating Conditions
• Do not set up in areas where there are excessive fluctuations in temperature. Also do not move the 
scanner from low-temperature areas to high-temperature areas. Condensation may cause image 
errors. Leave the scanner enough time to gradually adapt to the new conditions before use.
• Do not place the scanner in areas subject to direct sunlight or strong room light. It may cause 
damage to the scanner or decrease image quality. If you have to place it in direct sunlight, make sure 
to use a thick curtain to block the light.
• Leave enough space (approximately 8 in. (20 cm)) around the scanner when setting up.
Safety Precautions 
						

							The socket-outlet shall be installed near the equipment and shall be easily accessible.
LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE RECYCLED OR 
DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS.
As an 
ENERGY STA R® Partner, Canon Inc. has determined that this product 
meets the 
ENERGY STA R® guidelines for energy efficiency.
Quick Start Guide Quick Start Guide
QT5-1576-V01 ©CANON INC. 2008 PRINTED IN THAILANDXXXXXXXX
Please read this guide before operating this scanner. After you finish reading this guide, 
store it in a safe place for future reference.
Table of Contents
Package Contents............................... 1 Scanning with MP Navigator EX ......... 7
Installing the Software......................... 2 Scanning Film ..................................... 8
Preparing the Scanner ........................ 4 Specifications ...................................... 11
Try Scanning ....................................... 5 Safety Precautions.............................. 12
Using the Scanner Buttons ................. 6