Canon printer MAXIFY MB5020 User Manual

Paper Source to Load PaperAdjusting the cassette according to the PaperThe cassette can be adjusted to three lengths. Press down the lock (A) on the cassette to extend the
cassette.
B: Lock position for stowing the cassette
When not using this machine for long period of time or moving it, set it to the position B. The cassette will fit into the width of the machine. Paper cannot be loaded while in this position.
C: Lock position for A4 or Letter-sized paper or smaller For A4 or Letter-sized paper or...

Note
•
When printing, be sure to select the correct page size and media type. If the wrong page size andmedia type are selected, the machine may feed paper from the wrong paper source or may not print
with the proper print quality.
For details on loading paper in a cassette, see below.
Loading Plain Paper / Photo Paper
Loading Envelopes
162 

Loading Plain Paper / Photo PaperYou can load paper in the cassette.
Important
•
If you cut plain paper into small size such as 4" x 6" (10 x 15 cm) or 5" x 7" (13 x 18 cm) to perform trial
print, it can cause paper jams.
Note
•
We recommend Canon genuine photo paper for printing photos.
For details on the Canon genuine paper, see 
Media Types You Can Use .
•
You can use general copy paper.
•
For the page size and paper weight you can use for this machine, see Media Types You Can Use.
•...

3.
Slide the paper guide (A) in front and (B) on the right to open the guides.
4.
Load the paper stack WITH THE PRINT SIDE FACING DOWN, and place it in the center of
the cassette.
Important
•
Always load paper in the portrait orientation (C). Loading paper in the landscape orientation (D) can cause paper jams.
Note
•
If paper has print side (front or back), such as photo paper, load it with the whiter side (or glossyside) facing down.
•
Align the paper stack with the edge of the cassette as shown in the...

•
To load 5" x 7" (13 x 18 cm) size paper or smaller, raise the tab (F) of the paper guide.
•
To load paper larger than A4 size in the cassette, press down the lock (G) on the cassette, thenextend the cassette all the way out.
5.
Align the paper guide (A) in front with the paper stack.
For standard sizes, set the paper guide (A) to where it clicks into place.
6.
Slide the paper guide (B) on the right to align the right and left guides with both sides of the
paper stack.
Do not slide the paper...

Note
•
Do not load sheets of paper higher than the load limit mark (H).
•
Keep the paper stack height below the tabs (I) of the paper guides.
7.
Insert the cassette into the machine.
Push the cassette into the machine until it stops.
After inserting the cassette into the machine, the paper information registration screen for the cassette is
displayed on the touch screen.
Note
•
When A4 or Letter-sized paper or smaller is loaded, the cassette stops at the same position as the extended paper output tray,...

8.Select the size and type of the loaded paper in the cassette at Page size and Type , then
tap  Register .
If a message is displayed on the screen, follow the directions in the message to complete registration.
Paper setting for Printing
9.
Extend the output tray extension (J), then open the paper output support (K).
Note
•
When printing, select the size and type of the loaded paper on the print settings screen of the operation
panel or printer driver.
167 

Loading EnvelopesThe address is automatically rotated and printed according to the envelope's direction by specifying with the
printer driver properly.
Important
•
Printing of envelopes from the operation panel is not supported.
•
Do not use the following envelopes. They could jam in the machine or cause the machine to malfunction.
•
Envelopes with an embossed or treated surface
•
Envelopes with a double flap
•
Envelopes whose gummed flaps are already moistened and adhesive
1.
Prepare envelopes.
•...

3.
Slide the paper guide (A) in front and (B) on the right to open the guides.
4.
Load the envelopes WITH THE PRINT SIDE FACING DOWN, and place them in the center
of the cassette.
The folded flap of the envelope will be faced up as shown in the figure below (C).
C: Rear side
D: Address side
Up to 10 envelopes can be loaded at once.
Note
•
Align the envelope stack with the edge of the cassette as shown in the figure below.
If the envelopes are in contact with the protrusion (E), the envelopes may not be...

5.
Align the paper guide (A) in front with the envelopes.
6.
Slide the paper guide (B) on the right to align the right and left guides with both sides of the
envelopes.
Do not slide the paper guides too hard against the envelopes. The envelopes may not be fed properly.
Note
•
Do not load envelopes higher than the load limit mark (F).
•
Keep the envelope stack height below the tabs (G) of the paper guides.
7.
Insert the cassette into the machine.
Push the cassette into the machine until it stops.
After...