Canon 70d W User Manual

181
P Multiple Exposures N
 Are there any restrictions on the image-recording quality?
All JPEG image-recording qualit y settings can be selected. If 41 
or  61  is set, the merged multiple-exposure will be a  1 image.
  Can I merge images recorded on the card?
With [Select image for multi. expo. ], you can select the first single 
exposure from the images recorded on the card (p.179). Note that 
you cannot merge multiple images already recorded on the card.
  Are multiple exposures possible with Live...

182
Although using the self-timer or a remote switch can prevent camera 
shake, using mirror lockup to prevent camera vibrations (mirror shock) 
can also help when you use a super  telephoto lens or shoot close ups 
(macro photography).
1 Set [Mirror lockup] to [Enable].
 Under the [z2] tab, select [Mirror lockup ], then press .
 Select [Enable ], then press .
2 Focus the subject, then press the shutter button 
completely.
X The mirror will swing up.
3 Press the shutter button completely again.
XThe...

183
When you use the self-timer, bulb, or a remote switch and do not look 
through the viewfinder, stray light en tering the viewfinder can cause the 
image to look dark. To prevent th is, use the eyepiece cover (p.27) 
attached to the camera strap.
During Live View shooting and movi e shooting, attaching the eyepiece 
cover is unnecessary.
1Detach the eyecup.
 Push the bottom of the eyecup to 
detach.
2Attach the eyepiece cover.
 Slide the eyepiece cover down into 
the eyepiece groove to attach it....

184
You can connect Remote Switch RS-60E3 (sold separately) to the 
camera and shoot (p.416).
For detailed instructions, refer to the remote switch’s instruction 
manual.
1Open the terminal cover.
2Connect the plug to the remote 
control terminal.
F Using a Remote Switch
R Remote Control Shooting
With Remote Controller RC-6 (sold separately), you 
can shoot remotely up to approx. 5 meters/16.4 feet 
from the camera. You can either shoot immediately or 
use a 2-sec. delay.
You can also use Remote...

185
R Remote Control Shooting
 4Select the self-timer.
 Look at the LCD panel and turn the 
 dial to select < Q> or < k>.
5Press the remote controllers 
transmit button.
 Point the remote c ontroller toward the 
camera’s remote control sensor and 
press the transmit button.
X The self-timer lamp lights up and the 
picture is taken.
Remote
control
sensor
  Fluorescent or LED lighting may ca use camera misoperation by 
triggering the shutter inadvertently.  Try to keep the camera away from 
such light...

186
MEMO
COPY  

187
Flash Photography
This chapter explains how to use the built-in flash and 
external Speedlites (EX-series, sold separately), how to 
set flash settings with th e menu, and how to use the 
built-in flash for wireless flash shooting.
Flash cannot be used  with movie shooting. (It will not fire.)
COPY  

188
In Creative Zone modes, just press the 
 button to raise the built-in flash for 
flash photography. To retract the built-in 
flash, push it back down with your fingers.
In Basic Zone modes (except   
< 5 >  modes), the built-in flash will 
be raised and fire automatically in low-light and backlit conditions.
In the < A>     modes, you have the option to fire 
the flash or not.
The table below shows the shutter  speed and aperture settings that will 
be used with flash.
D  Using the Built-in Flash...

189
D Using the Built-in Flash
Effective Range of Built-in Flash[Approx. in meters/feet]
ISO Speed
EF-S18-55mm f/3.5-5.6 IS STM
EF-S18-135mm f/ 3.5-5.6 IS STM
EF-S18-200mm f/3.5-5.6 IS
Wide Angle: f/3.5Telephoto: f/5.6
100 1-3.4/3.3-11.2 1-2.1/3.3-7.0
200 1-4.8/3.3-15.9 1-3.0/3.3-9.9
400 1-6.9/3.3-22.5 1-4.3/3.3-14.1
800 1.2-9.7/4.0-31.8 1-6.1/3.3-19.9
1600 1.7-13.7/5.6-45.0 1.1-8.6/3.5-28.1
3200 2.4-19.4/8.0-63.6 1.5-12.1/5.0-39.8
6400 3.4-27.4/11.2-90.0 2.1-17.1/7.0-56.2
12800 4.8-38.8/15.9-127.3...

D Using the Built-in Flash
190
Using the red-eye reduction lamp  before flash photography can reduce 
red eye.
Red-eye reduction will function  in any shooting mode except , 
, < 5>, and < G>.
1Select [Red-eye reduc.].
  Under the [ z2] tab, select [Red-eye 
reduc.], then press < 0>.
2Select [Enable].
  Select [Enable ], then press .
  For flash photography, when you 
press the shutter button halfway, the 
red-eye reduction lamp will light up.
Set flash exposure compensation if  the flash exposure of the...