Candy Gow 485 D Manual

							User instructionsEN
GO W 485 D 
						

							2
EN
OUR COMPLIMENTS
With the purchase of this Candy household appliance, you have shown that you will not accept compromises: you wantonly the best. 
Candy is happy to present their new washing machine, the result of years of research and market experience throughdirect contact with Consumers. You have chosen the quality,durability and high performance that this washing machineoffers. 
Candy is also able to offer a vast range of other household appliances: washing machines, dishwashers, washer-dryers,cookers, microwave ovens. Traditional ovens and hobs,refrigerators and freezers. 
Ask your local retailer for the complete catalogue of Candy products. 
Please read this booklet carefully as it provides important guide lines for safe installation, use and maintenance andsome useful advise for best results when using your washingmachine. 
Keep this booklet in a safe place for further consultation. 
When contacting Candy or a Customer Services Centre always refer to the Model,No., and G number (if applicable of the appliance seepanel). 
						

							CHAPTER 
1 
2 
3 
4 
5 
6
7
8
9
10 
11 
12
13 
14 
15 
3
EN
INDEX
Introduction 
General points on delivery 
Guarantee 
Safety Measures 
Technical Data 
Setting up and Installation 
Control Description
Table of Programmes
Selection
Detergent drawer
The Product 
Washing 
Drying cycle
Automatic washing/Drying cycle 
Cleaning and routine maintenance 
Faults Search 
						

							EN
CHAPTER 2
GUARANTEE
The appliance is supplied with a guarantee certificate which allows free use of the Technical Assistance Service.
4
EN
CHAPTER 1
GENERAL POINTS ON DELIVERY
On delivery, check that the following are included with the machine:
A) INSTRUCTION MANUAL 
B) CUSTOMER SERVICE ADDRESSES 
C) GUARANTEE CERTIFICATES 
D) CAPS 
E) BEND FOR OUTLET TUBE 
KEEP THEM IN A SAFE PLACE
Check that the machine has not incurred damage during transport. If this is the case, contact your nearest CandyCentre.
E 
AB 
C
D 
						

							5
EN
CHAPTER 3
SAFETY MEASURES
IMPORTANT: FOR ALL CLEANING AND MAINTENANCE WORK
●Remove the plug
●Turn off the water inlet tap.
●All Candy appliances are earthed. Ensure that the mainelectricity circuit is earthed. Contact a qualified electricianif this is not the case. 
Appliance complies with European Directives 73/23/EEC and 89/336/EEC, replaced by 2006/95/EC and2004/108/EC, and subsequent amendments.
●Do not touch the appliance with wet or damp hands orfeet.
●Do not use the appliance when bare-footed.
●Extreme care should be taken if extension leads are usedin bathrooms or shower rooms. Avoid this where possible.
WARNING: DURING THE WASHING CYCLE, THE WATER CANREACH A TEMPERATURE OF 90°C.
●Before opening the washing machine door, ensure thatthere is no water in the drum. 
						

							6
EN
● Do not use adaptors or multiple plugs.
● This appliance is not intended for use by persons (including children) with reduced physical, sensory or mentalcapabilities, or lack of experience and knowledge, unlessthey have been given supervision or instruction concerninguse of the appliance by a person responsible for their safety. 
Children should be supervised to ensure that they do not play with the appliance.
● Do not pull the mains lead or the appliance itself toremove the plug from the socket.
● Do not leave the appliance exposed to atmosphericagents (rain, sun etc.)
● In the case of removal, never lift the appliance by theknobs or detersive drawer.
● During transportation do not lean the door against the trolley. 
Important! When the appliance location is on carpet floors, attentionmust be paid so as to ensure that there is no obstruction tothe bottom vents.
● Lift the appliance in pairs as illustrated in the diagram.
● In the case of failure and/or incorrect operation, turn the washing machine off,close the water inlet tap and do not tamper with theappliance. Contact a Candy Technical Assistance Centre forany repairs and ask for original Candy spare parts.Avoidance of these norms may compromise the safety of theappliance.
● Should the supply cord (mains cable) be demaged, this isto be replaced by a specific cable available from the aftersales service centre. 
						

							7
EN
CHAPTER 4
MAXIMUM WASH  LOAD DRY 
NORMAL WATER LEVEL 
POWER INPUT 
ENERGY CONSUMPTION (PROG. 90°C) 
POWER CURRENT FUSE  AMP 
SPIN r.p.m. 
WATER PRESSURE 
SUPPLY VOLTAGE 
TECHNICAL DATA 
kg 5 
6÷15 
2150 
1,8 
13 
min. 0,05 max. 0,8 
220 - 240 
l 
W
kWh
A
S SEEEE  RRAATTIINNGG  PPLLAATTEE
MPa 
V 
8
Washing Drying 
54 cm60 cm 
85  
cm 
						

							8
EN
CHAPTER 5
SETTING UP INSTALLATION
Move the machine near its permanent position without the packaging base. 
Carefully cut the securing strap that holds the main cord and the drain hose. 
Remove the 3 fixing screws marked ( A) and remove the 3 spacers marked ( B) 
Remove the screw  ( C). A spacer will fall inside the machine. 
By tilting the machine, remove the above mentioned spacer. 
Cover the 4 holes using the caps provided in the instruction booklet pack.
WARNING: DO NOT LEAVE THE PACKAGING IN THE REACH OFCHILDREN AS IT IS A POTENTIAL SOURCE OF DANGER. 
						

							9
min 50 cm max 85 cm 
+2,6 mt max
max 100 cm
min 4 cm
EN 
Fix the sheet of corrugated material on the bottom as shown in picture. 
Connect the fill hose  to the tap. 
The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused.
IMPORTANT: DO NOT TURN THE TAP ON AT THIS TIME.
Position the washing machine next to the wall. Hook the outlet tube to the edge of the bath tub, paying attentionthat there are no bends or contractions along the tube. 
It is better to connect the discharge hose to a fixed outlet of a diameter greater than that of the outlet tube and at aheight of min. 50 cm. If is necessary to use the plastic sleevesupplied. 
The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side tothat of the washer dryer. 
						

							10
EN 
Use the 4 feet to level the machine with the floor: 
a) Turn the nut clockwise to release the screw adjuster of the foot. 
b)   Rotate foot to raise or lower it until it stands firmly on the ground. 
c)   Lock the foot in position by turning the nut anti-clockwise until it comes up against the bottom of the machine. 
Ensure that the knob is on the “OFF” position and the load door is closed 
Insert the plug. 
ATTENTION: should it be necessary to replace the supply cord, connectthe wire in accordance with the following colours/codes:
BLUE - NEUTRAL (N) 
BROWN - LIVE (L)
YELLOW-GREEN - EARTH (           )
After installation, the appliance must be positioned so that the plug is accessible.
A 
B 
C