Home > Brinkmann > Light > Brinkmann Maxfire Dual Xenon Rechargeable Owners Manual And Operating Instructions

Brinkmann Maxfire Dual Xenon Rechargeable Owners Manual And Operating Instructions

    Download as PDF Print this page Share this page

    Have a look at the manual Brinkmann Maxfire Dual Xenon Rechargeable Owners Manual And Operating Instructions online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 6 Brinkmann manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							OWNER’S MANUAL & OPERATING INSTRUCTIONS
    WARNING
    READ AND FOLLOW ALL WARNINGS
    AND INSTRUCTIONS IN THIS
    MANUAL TO AVOID PERSONAL
    INJURY OR PROPERTY DAMAGE.
    • Never place spotlight face down when light is on or is still hot
    from recent use. Doing so could burn/ignite surfaces such as
    seats, carpeting, etc. and cause major property damage.
    Always turn spotlight off when not in use.
    • To prevent serious damage to eyesight, never look into
    spotlight when light is on. Do not shine light into the face of
    someone else.
    • Do not touch lens of spotlight when light is on or if it was
    recently on. The lens will be hot and could cause serious
    burns.
    • Do not place spotlight in water. Keep all components dry and
    out of water at all times.• Do not allow children to handle or operate this spotlight.
    • Do not use this product for other than its intended use.
    • Do not operate in close proximity of combustible or
    flammable materials.
    • Do not attempt to operate spotlight if cord, plug, bulb or any
    part of the spotlight is damaged or corroded.
    • Only use AC charger and DC lighter plug that are provided
    with the Dual Xenon spotlight or their replacements.
    • A damaged battery can leak acid. Avoid contact with eyes
    and skin. If contact occurs, flush immediately with large
    amounts of water. DO NOT ingest. If contact with eyes or
    ingestion occurs, consult physician immediately.
    IMPORTANT SAFETY WARNINGS
    READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL 
    BEFORE OPERATING SPOTLIGHT.
    WARNING
    USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR SPOTLIGHT.
    FAILURE TO ADHERE TO THE SAFETY WARNINGS AND GUIDELINES IN THIS MANUAL
    COULD RESULT IN BODILY INJURY OR PROPERTY DAMAGE.
    SAVE THIS MANUAL FOR FUTURE REFERENCE.
    ®
    ™
    INSTR-800-2200-0_Dual Xenon.qxd  6/24/03  3:23 PM  Page 2 
    						
    							Step 1:Make sure trigger switch is not locked in the ON position.
    Step 2:Plug the AC charger or DC charger/adapter into the socket located on
    the base of the spotlight handle as illustrated.
    Step 3: For DC Charger/Adapter:
    Plug the other end of the DC charger/adapter into a cigarette lighter
    receptacle.
    For AC Charger:
    Plug the other end of the AC charger into a wall outlet.
    Parts List
    1Dual Xenon spotlight
    2120-volt AC charger
    312-volt DC charger/adapter lighter plug
    Owner’s Manual
    OPERATING INSTRUCTIONS
    READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL 
    BEFORE OPERATING SPOTLIGHT.
    Inspect contents of the box to ensure all parts are included and undamaged.
    Step 1: Depress trigger switch in handle to turn spotlight ON.
    Step 2:Release trigger switch to turn spotlight OFF.
    Continuous Beam Using Lock Button:
    Step 1: For a continuous beam, depress trigger switch and slide the lock button
    to the LOCKED position.
    Step 2:  To unlock and turn spotlight OFF, slide the lock button to the
    UNLOCKED position.
    NOTE:To lock the Dual Xenon in the OFF position, release trigger switch, then
    slide the lock button to the LOCKED position.
    WARNING:Always turn spotlight off when not in use.
    Switching Between Single and Dual Beams:
    Step 1:For single beam, slide switch on back of light to one dot, as illustrated.
    Step 2:For dual beam, slide switch on back of light to two dots, as illustrated.
    NOTE:The Dual Xenon will burn for approximately 40 minutes if using both
    beams, or approximately 85 minutes if using only one beam.
    1
    23
    To Operate
    2
    Trigger
    Switch
    LED Indicator
    Lock
    Button
    Beam
    Switch
    Single
    Beam
    Dual
    Beam
    Unlocked
    Locked
    To Charge
    INSTR-800-2200-0_Dual Xenon.qxd  6/24/03  3:23 PM  Page 3 
    						
    							Step 4:Allow the spotlight to charge for at least 8 hours. Do not allow to
    charge more than 12 hours.
    Note:LED indicator on base of handle turns off automatically when battery
    is fully charged.
    Step 5:Remove spotlight from the charger before operating.
    See chart for recommended charge times.
    3
        40
    4812     85
    Battery Charge
    USAGE (Minutes)
    CHARGE TIME (Hours)
    Charge TimesCharge time is dependent on usage of the 
    product. See chart below for recommended charge time.
    IMPORTANT:The EPA
    Certified RBRC®Battery
    Recycling Seal on the lead
    acid (Pb) battery
    contained in our product
    indicates The Brinkmann
    Corporation is voluntarily
    participating in an industry program to collect
    and recycle these batteries at the end of their
    useful life, when taken out of service in the
    United States or Canada. The RBRC
    ®program
    provides a convenient alternative to placing
    used Pb batteries into the trash or the municipal
    waste stream, which may be illegal in your
    area. Please call 1-800-8-BATTERY™ for 
    information on Pb battery recycling and
    disposal bans/restrictions in your area. The
    Brinkmann Corporation’s involvement in this
    program is part of our commitment to
    preserving our environment and conserving our
    natural resources.
    Glass
    RetainerRubber
    Cap
    To Replace BulbOnly use Brinkmann xenon bulb that is designed for the Dual Xenon
    spotlight as a replacement. Use of any other bulb may result in poor
    performance and may damage your spotlight.
    NOTE:Handling the bulb can leave oil from your fingers on the bulb. To
    extend the life of the new bulb and maximize brightness, gently
    clean off bulb with soft cloth or tissue. Make sure the reflector
    does not touch or bend the bulb while replacing spotlight head.
    Step 1:Disconnect spotlight from charger.
    Step 2:Remove front rubber cap from barrel of spotlight.
    Step 3:Pinch the wings of the glass retainer together and lift as illustrated.
    Step 4:Pull glass and reflector away from rear housing.
    Step 5:Pull old bulb straight out of bulb holder.
    Step 6:Make certain that legs on new bulb are straight. Insert legs
    into the two holes in the bulb holder.
    Step 7:Gently push bulb straight in until fully seated and centered.
    Step 8:To reassemble, place the glass and reflector on the rear housing.
    Insert the glass retainer into the rear housing.
    Step 9:Replace rubber cap.
    WARNING:Do not touch the lamps when light is on or if it was recently
    on. The lamps will be hot and could cause serious burns.
    Glass &
    Reflector
    Rear
    Housing
    INSTR-800-2200-0_Dual Xenon.qxd  6/24/03  3:23 PM  Page 4 
    						
    							For 1-year from date of purchase, The Brinkmann Corporation warrants the Dual Xenon spotlight against defects due to workmanship or
    materials to the original purchaser. The Brinkmann Corporation’s obligations under this warranty are limited to the following guidelines:
    • This warranty does not extend to the bulb or batteries.
    • This warranty does not cover spotlights that have been altered or damaged due to: normal wear, abuse, improper maintenance, improper
    use, disassembly of parts and/or attempted repair by anyone other than an authorized employee of The Brinkmann Corporation.
    • This warranty does not cover surface scratches or weathering as this is considered normal wear.
    • Warranty service is limited to repair or replacement of spotlights which prove defective under normal use and which upon examination
    shall indicate to Brinkmann’s satisfaction, they are defective. If Brinkmann confirms the defect and approves the claim, Brinkmann will
    elect to repair or replace the spotlight as covered by the terms of this warranty.
    • This warranty extends to the original purchaser only and is not transferable or assignable to subsequent purchasers.
    The Brinkmann Corporation requires reasonable proof of purchase.Therefore, we strongly recommend that you retain your sales receipt
    or invoice.To obtain repair or replacement of your Dual Xenon spotlight under the terms of this warranty, please call Customer Service
    Department at 1-800-527-0717 for a Return Authorization Number and further instructions.A receipt will be required. A Return
    Authorization Number must be clearly marked on the outside of the box.Spotlights returned to Brinkmann must include your name,
    address and telephone number. Please make sure the light is properly packed, postage prepaid, and insured. The Brinkmann Corporation will
    not be responsible for any spotlights forwarded to us without a Return Authorization Number.
    EXCEPT AS ABOVE STATED, THE BRINKMANN CORPORATION MAKES NO OTHER EXPRESS WARRANTY.
    THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION TO 1-YEAR FROM
    THE DATE OF PURCHASE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE
    LIMITATION MAY NOT APPLY TO YOU.
    ANY LIABILITY FOR INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM THE FAILURE OF THE DUAL XENON SPOTLIGHT TO
    COMPLY WITH THIS WARRANTY OR ANY IMPLIED WARRANTY IS EXCLUDED. CUSTOMER ACKNOWLEDGES THAT THE PURCHASE PRICE
    CHARGED IS BASED UPON THE LIMITATIONS CONTAINED IN THE WARRANTY SET OUT ABOVE. SOME STATES DO NOT ALLOW THE EXCLUSION
    OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU. THIS
    WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
    1-YEAR LIMITED WARRANTY
    140-2200-1
    6/03For Model 800-2200-0
    Tips to Avoid Damage to Your
    Dual Xenon Spotlight• Never attempt to wipe or clean the inner reflective surface of the reflector.
    Touching or wiping the surface will damage it permanently.
    • The lens is made of tempered glass. Avoid dropping or sharp impact on
    spotlight to prevent damage.
    • Do not allow hot lens to come in contact with water or materials subject to
    heat damage.
    • The spotlight is weather resistant. It is not waterproof. Do not use the
    spotlight under water or store outdoors.
    • Use only Brinkmann xenon bulb that is designed for your Dual Xenon
    spotlight. Use of any other bulb may result in poor performance and may
    damage your spotlight.
    • After months of use, cigarette lighters can build up corrosion that may
    prevent the DC lighter plug from making good contact. It may be necessary
    to clean the inside of your cigarette lighter receptacle with a fine emery
    cloth. Before cleaning receptacle, remove the fuse to prevent it from
    shorting out.
    The retractable hanging ring allows spotlight to hang while in use or
    during storage.To Hang/Store Dual Xenon
    © 2003 The Brinkmann Corporation
    Dallas, TX 75244
    www.brinkmanncorp.com
    INSTR-800-2200-0_Dual Xenon.qxd  6/24/03  3:23 PM  Page 1 
    						
    All Brinkmann manuals Comments (0)

    Related Manuals for Brinkmann Maxfire Dual Xenon Rechargeable Owners Manual And Operating Instructions