Home > Briggs & Stratton > Engines > Briggs & Stratton Engine Model 120000 Intek 823/850/875, Intek Edge 825/850, Intek Pro 825 Operating And Maintenance Instructions

Briggs & Stratton Engine Model 120000 Intek 823/850/875, Intek Edge 825/850, Intek Pro 825 Operating And Maintenance Instructions

Here you can view all the pages of manual Briggs & Stratton Engine Model 120000 Intek 823/850/875, Intek Edge 825/850, Intek Pro 825 Operating And Maintenance Instructions. The Briggs & Stratton manuals for Engines are available online for free. You can easily download all the documents as PDF.

Page 1

Operating & Maintenance Instructions
Betriebsanleitung & Wartungsvorschriften
Drifts- og vedligeholdelsesvejledning
Instrucciones de Mantenimiento & Operación
Instructions d’utilisation et de maintenance
Ïäçãßåò Ëåéôïõñãßáò & ÓõíôÞñçóçò
Istruzioni per l’uso e la manutenzione
Anvisninger for bruk og vedlikehold
Gebruiksaanwijzing
Instruções de operação e de manutenção
Instruktionsbok
Käyttö & Huolto-ohjeetGB
D
E
DK
F
I
NL
P
SF
S
N
GR
BRIGGSandSTRATTON.com Copyright Briggs & Stratton Corporation...

Page 2

Fig. 1
Fig. 2
Fig. 4
432
6
7
8
5
9
10
1211
1
°C-30°F-20 020 40 60 80 100
-20 -10 0 10 20 30 40
*
**
32



Fig. 5Fig. 6
0.15
LITERS
Fig. 3 
 
 




 

 

Page 3

GB
GB
1
Note: (This note applies only to engines used in the U.S.A.) Maintenance, replacement or repair of the emission control devices and systems may be performed
by any nonroad engine repair establishment or individual. However, to obtain no charge repairs under the terms and provisions of the Briggs & Stratton
warranty statement, any service or emission control part repair or replacement must be performed by a factory authorized dealer.
ENGINE COMPONENTS
 Fig. 11Engine Model Type Code
xxxxxx xxxx xx...

Page 4

GB
2
WARNING
Gasoline and its vapors are extremely
flammable and explosive.
Fire or explosion can cause severe burns or
death.
WHEN ADDING FUEL
•Turn engine OFF and let engine cool at least 2 minutes
before removing gas cap.
•Fill fuel tank outdoors or in well-ventilated area.
•Do not overfill fuel tank. Fill tank to approximately
1-1/2 inches below top of neck to allow for fuel
expansion.
•Keep gasoline away from sparks, open flames, pilot
lights, heat, and other ignition sources.
•Check fuel lines,...

Page 5

GB
3
 
FRESH START FUEL CAPFig. 3
Your engine may be equipped with a Fresh Start™ fuel
cap.
Contents are HARMFUL OR FATAL IF
SWALLOWED. Avoid contact to eyes, skin,
or clothing. Do not take internally. Avoid
breathing the mist or vapor. Overexposure to
eyes or skin can cause irritation. Keep
stabilizer out of the reach of children.
Fuel stabilizer is a hazardous chemical.**
** Fuel stabilizer contains 2,6-di-tert-butylphenol
(128-39-2) and aliphatic petroleum distillate
(64742-47-8).
DANGER
The Fresh...

Page 6

GB
4
FUEL SYSTEM
WARNING
Replacement parts for fuel system (tank, hoses, valves, etc.)
must be the same quality as original parts, otherwise fire can
occur.
Replacing Fuel Filter
•Remove the engine cover. Replace fuel filter. Check filter for
water or debris. If found, clean fuel system. Reinstall the
engine cover.
 
SPARK PLUGFig. 9
WARNING
DO NOT check for spark with spark plug removed. Use only
Briggs & Stratton Spark Tester , to check for spark.
•The electrodes on the spark plug must be clean and...

Page 7

GB
5
Briggs & Stratton Corporation (B&S), 
the California Air Resources Board (CARB)
and the United States 
Environmental Protection Agency (U.S. EPA)
Emissions Control System Warranty Statement 
(Owner’s Defect Warranty Rights and Obligations)Briggs & Stratton Emissions Control
Defects Warranty Provisions
Engines that are certified to meet the California Air
Resources Board (CARB) Tier 2 Emissions Standards must
display information regarding the Emissions Durability
Period and the Air Index. Briggs &...

Page 8

GB
6
BRIGGS & STRATTON ENGINE OWNER WARRANTY POLICY
Effective 12/06
LIMITED WARRANTYBriggs & Stratton Corporation will repair or replace, free of charge, any part(s) of the engine that is defective in material or workmanship or both.
Transportation charges on parts submitted for repair or replacement under this warranty must be borne by purchaser. This warranty is effective for
and is subject to the time periods and conditions stated below. For warranty service, find the nearest Authorized Service Dealer...

Page 9

Document: - page 1 (Black)
Screen angle and frequency: 45.0000, 150.0000

 
 


ÑÑÑÑ ÑÑÑÑ
ÑÑÑÑ
ÑÑÑÑ




 








  	
 

Page 10


				            
Start reading Briggs & Stratton Engine Model 120000 Intek 823/850/875, Intek Edge 825/850, Intek Pro 825 Operating And Maintenance Instructions

Related Manuals for Briggs & Stratton Engine Model 120000 Intek 823/850/875, Intek Edge 825/850, Intek Pro 825 Operating And Maintenance Instructions

All Briggs & Stratton manuals