Bose Wave radio Sold from 1997 to 2000 User Manual

11
CD player, tape deck,
or VCRAudio output jacks
If there are two sets of
outputs (fixed and
variable), use fixed so
that the volume can
be controlled from the
radio.AUX IN jacks
Television Audio output jacks
If there are two sets of
outputs (fixed and
variable), use fixed so
that the volume can
be controlled from the
radio.AUX IN jacks
Stereo cable with
male-to-male RCA
plugs.AUX IN jacks Bose
® Lifestyle®
music system
Powered Bose
speakersSpeaker system input
(as described in the
speaker owner’s...

12
TIMEALARMSLEEP
TUNINGSTA.
VOLUMEMUTE
AUXAM
FM
ON/OFF
WAVE RADIO REMOTE CONTROL
1
23
4
5
6PRESET STATIONS
Operating Your Wave® Radio
Operating the remote control
Aim the remote control at the display of your Wave radio. Use the remote buttons in the same
way you use the radio control panel. The remote normally works up to 20 feet in front of the
radio, and 6 feet to either side. Replace the remote control batter y when it stops operating,
or its range seems reduced (normally every year or two). Keep in...

13
Operating Your Wave® Radio
Listening to the radio
Function
To turn on/off - Press once to turn on (to the last source played) or
off. Or, press AM/FM or any PRESET to turn the radio on.
To adjust the volume - While the radio is either on or off, press and
hold either button to reset the volume. The display shows the volume
level, from 0 (soft) to 99 (loud).
To select AM or FM - If the radio is off or in AUX mode, press to
select the radio. Press again to change between AM and FM.
To tune in a station...

14
Reading the clock display
Figure 8
The clock display
SLEEP
PM
ALARM
ALARM 2
Lights to indicate
sound selected for
Alarm 1. Lights to indicate
Alarm 1 is on.
AM
One will light to
indicate AM or PM.Lights to indicate
Alarm 2 is on. Lights to indicate
sound selected for
Alarm 2.
Reading the radio display
Figure 9
The radio display
AUX FM
STEREO
VOL AM
SEEK
PRESET
123456
Lights when you
preset a station.Lights when you select
a preset station.
Shows station
frequency, current
time, wakeup time,
time...

15
Customizing the display
AM/PM (12 hour)
or
Military (24 hour)
time
Clock or radio
mode
Press ON/OFF once to turn your Wave
radio off.
Hold down CLOCK SET and press ON/OFF
to switch between AM/PM (12 HR) or military
(24 HR) formats.
In clock mode, the display shows the time
while the radio is on; in radio mode, the display
shows the selected radio station.
With the radio turned on, hold down the
CLOCK SET button and press the AM/FM
but ton to switch bet ween clock and r adio modes.
In low light...

16
Operating Your Wave® Radio
Setting Alarm 1
Note: You can set the alarm with the radio on or off.
Function
To set the Alarm 1 time - On the control panel, hold down ALARM
SET and press TUNING up or down. The time display changes slowly at
first, then more quickly. Release TUNING to stop.
On the remote, press TIME. The ALARM indicator flashes. Press
TUNING up or down. The time display changes slowly at first, then
more quickly. Release TUNING to stop. Press TIME to return the display
to the current...

17
Operating Your Wave® Radio
Setting Alarm 2
Note: You can set the alarm with the radio on or off.
The ALARM 2 indicator must be flashing to set Alarm 2 time or sound.
The ALARM 2 indicator continues flashing for 10 seconds after the
Alarm 2 wakeup time or sound is set.
Function
To set the Alarm 2 time
On the control panel:
1. Hold down ALARM SET and press ALARM MODE 
 until the
ALARM 2 indicator flashes. You have 10 seconds to begin setting the
time.
2. Hold ALARM SET and press TUNING up or down. The...

18
Using the alarms
Function
To stop the alarm - Press ON/OFF. The indicators remain lit.
Or, if you do not press ON/OFF, the tone 
 alarm shuts off in 30 min-
utes, the radio 
 alarm shuts off in 60 minutes.
The alarm automatically resets to repeat daily.
To pause the alarm for 10 minutes - Press SLEEP⁄SNOOZE or
SLEEP to have the radio 
 or tone  alarm repeat in 10 minutes. When
the alarm is in both radio and tone 
 mode, press SLEEP⁄SNOOZE
or SLEEP to pause the tone for 10 minutes and turn on the...

19
Maintaining Your Wave® Radio
Taking care of your Wave radio
The only necessary maintenance is periodic battery replacement and cleaning.
Replacing the batteries
To protect your Wave radio’s memory and backup alarm system, replace the 9V battery every
year and when you have an extended power loss. A dead battery may leak and cause
damage. Do not unplug your Wave radio from the power outlet while replacing the battery. If
you do unplug it, you will need to reset the clock, alarm settings, and station...

20
Troubleshooting
Problem What to do
Radio does not function • Make sure the power connector is inserted securely into the radio, matching the flat side of
the connector to the flat side of the jack, and the power cord is plugged fully into an
operating AC wall outlet.
No sound • Increase the volume.
• Press the MUTE button on the remote control to unmute the sound.
• Check the connections for any auxiliary component.
• Select AUX to hear a source connected to the AUX IN jacks.
• Be sure that the...