Bose Pace 6 Manual

21
2.6 Installing a surface-mount loudspeaker
Wall construction and material must be sturdy enough to support the loudspeaker weight of 21/2 lb (1.2 kg). Bose® is
not responsible for loudspeakers mounted in or on unsuitable surfaces.
The type and length of fastener depends upon the mounting surface selected. To mount to hollow gypsum board or
plaster wall, use wall anchors with a load rating in shear of at least 25 pounds PER FASTENER. Direct attachment to
more substantial material also should meet this...

22
163
13
4
12
759
10
2
JN95540   PN180084
Uppteckna inställningarna och datumet med en blyertspenna. Use un lápiz para la posición fijada y la fecha. Usare una matita per annotare le regolazioni e la data.Mit einem Bleistift die Einstellungen und das Datum notieren.Utilisez un crayon à papier afin de noter les réglages et la date. Gebruik een potlood om de opstellingen en de datum te noteren.Nedskriv indstillingerne og datoen med en blyant.Use a pencil to record the settings and the date.
TM
D
ie
 
cu...

23
8 1/2
217 mm 7 3/4
197 mm9 
1/2
241 mm  
10 5/8
(270 mm) 3 1/2
(89 mm)
13
(330 mm)
2.9.1 Wall mounting
WARNING
Do not use the system electronics as a drill guide; personal injury could result. Be sure to observe all other safety
precautions while drilling or installing the mounting hardware.
Attach the system electronics to a vertical surface using at least four of the ten mounting holes. In the U.S., #10 sheet
metal or machine screws, or 
3/16 inch diameter wood screws (or 4 mm diameter metric...

24
2.9.3 Connections
Note: To prevent excessive mechanical stress on the wire connections, use cable ties or other strain relief for the
signal and loudspeaker cables.
If using a push-to-talk microphone, be sure the push-to-talk switch is properly wired so that it places a short circuit
across the microphone output except when the user presses the switch.
CAUTION
Improper connection can damage both the source equipment and the FreeSpace® 6 system. Be sure to review this
guide for information on nominal...

25
Output connections Instructions
PageThe Page Output provides a line-level signal consisting of the paging announcements
only. This can be fed to power amplifiers and loudspeakers (or a powered loudspeaker)
for a zone such as a valet parking station. The Page Output is muted until a paging
signal triggers it. It puts out about 2V. The Remote Control unit DOES NOT control this
output.
Line Out L and RComplex, extended systems can be created originating with the FreeSpace
® 6 system
electronics. The two...

26
Figure 1
0 dB+30 dB
0
1
9
3
LRL
R
5
L
R
L
R
L + R
678
B
A
PAGE ENABLE
ONON
OFFOFF
B AL
RA
–+–+–+–+
4PAGE
TRIGGER
LEVEL
+30 dB
B A
2
REMOTE
S ELECT1
67
4
5
8
9
3
2
POWER /AC MAINS ON
BUSINESS MUSIC SYSTEMFreeSpace® 6
11
REMOTE
VOLUME
LR
10
L
L
LR
R
–+–+
Bass Treble
13
-6  dB  0 dBL
R
–+–+–+–+
+
RL+R
1212
11
13
10
3.0 System Setup
English 

27
Use the electronic system card (found in the documentation kit) to mark the settings of the zones used in this installa-
tion. See page 20. This card is to be stored inside the electronic system cover as an aid in troubleshooting problems.
3.1 Power on/off
The on/off switch is on the right side of the system electronics. If desired, the switch can stay in the ON position.
Power consumption without a signal input is typically less than 10 Watts.
3.2 Opti-voice® compressor
The Opti-voice compressor...

28
3.4.1 Music sources (cont’d)
Play a test CD or tape. Choose a passage representing the loudest music to be played regularly.
If the... Then...
Music Input Source A has Use it. If not, set the variable level output to maximum.
a fixed level output
Music compressor is ON Adjust the Music Input Source A Trim so the music compressor LED glows green
for Music Input Source A during the loudest passages.
If the LED changes to red, the level is too high. Lower the trim control until the LED
stays green.
Music...

29
3.4.2 Paging source (cont’d)
2.While speaking into the microphone, slowly turn down (to the left) the Page Trigger Level control (block 3) until
the amplifier disables paging and the LED in block 3 goes out.
Turn the control back to the right until the paging comes ON again.
3.Have the person stop speaking, but keep the push-to-talk button ON. The LED in block 3 should go out and the
music source should fade in.
4.Have the person resume speaking with the push-to-talk button ON. The paging source...

30
3.6 Dual zone, single source system
The FreeSpace® 6 business music system can be used to create a two-zone single source installation using the same
monaural music source. Each zone can have different loudness levels and a choice of page overrides. There is no
provision for independent page sources for the two zones—there is only one page input on the system electronics.
3.6.1 L zone trim (block 13)
This trim adjusts the level of the “left” zone relative to the “right” zone in mono installations,...