Bisell Pet Hair Eraser Multi Cyclonic Vacuum 10N6 User Manual

To maximize your cleaning performance and extend the life of your vacuum, it is very important that you empty your dirt container and check and clean your filters frequently. Perform the following maintenance steps:
1. Empty the dirt container when the dirt reaches the “Full” line on the container, or more frequently to prevent overfills. For best performance, empty after each use. 
2. Check the pre-motor filter and post-motor HEPA media filter at least once a month, clean or replace as needed. 
3....

1. Unplug the vacuum from electrical outlet.
2. The pre-motor filter protects the motor from dirt particles. It is located in the slide out tray underneath the dirt container. If the filter becomes dirty, pull out the tray, lift out the foam filter pad and clean it. 
NOTE: The pre-motor filter may be hand washed in cold water with mild detergent. Rinse well and air dry thoroughly before replacing. 
3. The post-motor HEPA media filter assists in the filtration process to return clean air to the room. It...

13w w w . b i s s e l l . c o m 
Maintenance and care
7. Check drive belt carefully for wear, cuts or stressed areas.  
8. Check air passageway for obstructions. Remove debris from this area.    
9. Insert front edge of the brush cover and rotate into place. Snap the latches and replace the two screws.
Replace drive belt
1. Unplug the vacuum from electrical outlet.
2. With rotating floor brush removed from vacuum cleaner (Steps 1-4 of check rotating floor brush and drive belt), grasp old drive belt and...

14w w w . b i s s e l l . c o m 
Maintenance and care
Replace lightbulb
1. Unplug the vacuum from electrical outlet.
2. Using a screwdriver, first remove 2 screws on either side of lens and pull out to remove the lens. 
3. Remove the bulb from the socket by grasping the bulb and pulling gently. Install the new bulb by pushing it gently into the socket until the bulb snaps into place. 
4. Reposition the lens place cover back over headlight and reinsert 2 screws.
Maintaining TurboBrush™ Pet
The TurboBrush...

15w w w . b i s s e l l . c o m 
Maintenance and care
Clearing clogs
Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor, check for clogs. 
1. Unplug the vacuum from electrical outlet.
2. Empty dirt container.
3. Check upper tank for build up or clogs.
4. If you notice a clog in the upper tank, remove the inner cyclone (see section "Cleaning the upper tank" on page 16).  
5. Grasp the hose wand and separate it from the hose wand...

16w w w . b i s s e l l . c o m 
Troubleshooting
Vacuum cleaner won’t run
Possible causes  Remedies
1. Power cord not plugged in  1. Check electrical plug
WARNING:  To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or trouble-shooting.
Maintenance and care
Cleaning the upper tank
1. Grasp the inner cyclone and twist to the left until the locking tabs stop the rotation. Pull down from the upper tank to remove it.
2. Wipe out the...

17w w w . b i s s e l l . c o m 
Troubleshooting
Vacuum cleaner won’t run (continued)
Possible causes  Remedies
2. Damaged power cord  2. Unplug, check for damage, replace     as necessary
Vacuum cleaner and tools won’t pick up dirt
Possible causes   Remedies
1. Incorrect height adjustment  1. Adjust powerfoot to correct height
2.  Hose not attached to suction opening  2. Firmly push hose wand into hose     wand base
3. Twist 'n Snap hose not securely attached  3. Make sure Twist 'n Snap hose is...

16w w w . b i s s e l l . c o m 18
BISSELL Consumer Services
If your BISSELL product should require service:In the UK, Australia or New Zealand call BISSELL Consumer Services at the numbers below and we will give you the location of a BISSELL Authorized Service Center in your area. For all other countries, contact your local in country distributor for questions, service, or repair. 
If you have questions about your warranty or need replacement parts please contact the numbers below.
Or visit the BISSELL...

16w w w . b i s s e l l . c o m 19
1
1
2
2
3
3
4
4
5
5
67
Item Part No.  Part Name
1  203-1056  Crevice Tool
2 203-1059  Dusting Brush/Upholstery Tool
3 203-1290  TurboBrush Pet
4 203-1291  Pet Contour Tool
5 203-1068  Extension Wand 
6 203-1216  Twist 'n Snap Vacuum Hose (clear)
7 203-1292  Pet Hair Lifter
Additional accessories
Replacement parts - BISSELL vacuum
Item Part No.  Part Name
1  32074  Style 7/9/10/12/14 Drive Belt (2-Pack)
2 203-1297  Headlight Bulb
3 203-1283  Wide Window Foot Brush...

16w w w . b i s s e l l . c o m 20
©2009 BISSELL Homecare, IncGrand Rapids, MichiganAll rights reserved. Printed in KoreaPart Number 110-4129Rev 7/09Visit our website at:www.bissell.com
Warranty - BISSELL Pet Hair Eraser™  Multi Cyclonic Vacuum
For UK inquiries:
Monday - Thursday 9 am — 5 pm  
 Friday  9 am — 4 pm 
BISSELL Homecare (Overseas) Inc.
The Boat Yard  
105 Straight Road  
Old Windsor  
Berkshire, SL4 2SE 
United Kingdom  
Telephone: 0844-888-6644 
For Australian inquiries:
Monday - Friday...