Bisell CleanView Power Cyclonic 80E7E User Manual

							www.bissell.com 11
Maintenance and care
 
You should check your vacuum cleaner’s 
rotating floor brush and drive belt regu-
larly for wear or damage. You should 
also clean the brush and brush ends of 
string, hair and carpet fibers. These can 
wrap around the brush and hamper its 
ability to effectively clean your carpet.
 Also remove any debris that has accu-
mulated under the brush cover.
1. Unplug cleaner from electrical outlet.
2.  Place handle in low position and turn 
vacuum cleaner over so bottom side is up.
3.  Remove the two screws from the brush 
cover (as shown) with a Phillips head  
screwdriver. Lift the brush cover off.
4.  Grasp rotating floor brush at both ends 
and lift.
5.  Clean strings, hair and other debris 
from rotating floor brush, paying par -
ticular attention to brush ends.
6.  Clean strings, hair and other debris from 
motor pulley and drive belt areas.
7.  Check drive belt carefully for wear, cuts 
or stressed areas. Replace if worn or 
damaged.
8.  Check air passageway for obstructions. 
Remove debris from this area.
Replace drive belt
1. Unplug cleaner from electrical outlet.
2.  With rotating floor brush removed from vac-
uum cleaner (Steps 1-4 of "Check rotating 
floor brush and drive belt"), grasp old drive 
belt and remove from motor pulley. Discard 
old drive belt.
3.  Place new drive belt over motor pulley 
and stretch other end over rotating floor 
brush in the space between the bristles.
4.  Place ends of rotating floor brush down 
into slots on sides as shown.
5.  Turn rotating floor brush by hand several 
times in direction of motor pulley. If prop-
erly installed, drive belt will center itself on 
rotating brush.
6.  Reposition brush cover and replace two 
screws. Make sure end of brush cover is 
snapped into place.
Check rotating floor brush and drive belt
Motor 
Pulley
Air Passageway
Brush 
Cover
Brush 
Cover  
						

							www.bissell.com 
Maintenance and care
12
Clearing clog
Low suction, poor pickup or no suction 
may be due to a clog in the vacuum 
cleaner. If you notice a change in 
the sound of the vacuum motor or a 
reduction in the spinning action in the 
dirt container, check for clogs.
1. Unplug cleaner from electrical outlet.
2.  Empty dirt container.
3.  Check upper tank and primary separa-
tor for build up or clogs. Check to make 
sure primary separator is installed cor -
rectly. To unlock the primary separator, 
grasp the rim and turn toward the left. 
Pull straight down to remove. If the pri-
mary separator is missing or not locked 
into place, check and clear the tube in 
the center of the dirt container and prop-
erly install primary separator.
4.  Remove the Twist ‘n Snap hose from the 
vacuum by turning to the left. Check the 
suction inlet, hose and hose wand for 
clogs. Remove any clogs from the hose 
using a long, narrow object such as a 
broomstick.
5.  Check the foot hose for clogs. If need-
ed, remove the screw attaching the hose 
wand base to the vacuum. Straighten 
the foot hose and unclog with a long, 
narrow object such as a broomstick.
6.  If the clog persists, follow the instructions 
for checking the rotating floor brush on 
page 11 and inspect the air passageway 
for obstructions.
Air Passageway
Primary 
Separator
Suction Inlet
Hose Wand 
Base  
						

							www.bissell.com 13
TroubleshootingWARNING:  To reduce the risk of electric 
shock, turn power OFF and dis-
connect plug from electrical   
outlet before performing   
maintenance or troubleshooting.
Vacuum cleaner won’t turn on
Possible causes  Remedies
1. Power cord not firmly plugged in  1. Check electrical plug
Vacuum cleaner won't pick up dirt
Possible causes   Remedies1. Incorrect height adjustment  1. Adjust powerfoot to correct height setting
2.  Hose not attached to suction opening  2. Grasp Quick Release handle and firmly push   
    hose wand onto the suction opening.
3.  Twist 'n Snap hose not securely attached  3. Make sure Twist 'n Snap hose is snapped   
    into locked position
4.  Crack or hole in hose  4. Check hose and replace if needed
5.  Broken or worn drive belt  5. Replace drive belt, see page 11
6.  Rotating floor brush bristles worn  6. Replace brush
7.  Rotating floor brush jammed  7. Remove brush and clean debris from brush ends
8.  Clog in vacuum  8. Follow instructions for clearing clogs on page 12
9.  Dirt container full  9. Empty dirt container
10.  Dirt container not installed properly  10. Position correctly and lock in place
11.  Filters are dirty  11.Check and clean inner and outer circular filters and ,  
    pre-motor filter, replace post-motor filter
12.  Primary separator missing or installed incorrectly  12. Check for a clog in the tube in the center of the dirt   
    container, clear and properly install primary separator
Tools won't pick up dirt
Possible causes  Remedies1. Crack or hole in hose  1. Check hose and replace if needed
2.  Vacuum hose, wand or tools clogged  2. Follow instructions for clearing clogs on page 12
3.  Dirt container full  3. Empty dirt container
4.  Dirt container or upper tank not installed properly  4. Position correctly and lock in place
5.  Filters are dirty  5. Check and clean inner and outer circular filters and ,   
    pre-motor filter, replace post-motor filter
6.  Primary separator missing or installed incorrectly  6. Check for a clog in the tube in the center of the dirt   
    container, clear and properly install primary separator
Vacuum cleaner difficult to push
Possible causes   Remedies1. Incorrect height adjustment  1. Adjust powerfoot to correct height setting
2.  Rotating floor brush not rotating  2. Check drive belt and brush
Visible dirt escaping from cleanerPossible causes   Remedies1. Dirt container full  1. Empty dirt container
2.  Filters missing or installed incorrectly  2. Check inner and outer circular filter and post-motor   
    filter for correct installation  
						

							Item Part No.  Part Name
 1 32074  Style 7/9/10/12/14 Drive Belt (2-Pack)
 2  203-1056  Crevice Tool
 3  203-1059  Combination Dusting Brush/Upholstery Tool 
 4  203-1068  Extension Wand
 5   203-1216  Twist ‘n Snap Vacuum Hose 
(Select Models Only)
 6  203-5624  Brush Roll
 7   32064  Style 9/10/12 Inner & Outer Circular Filter Set
 8  32065  Style 9/10/12 Inner Circular Filter only
 9  3205  Style 12 HEPA Media Filter*
10  203-1215  Pre-Motor Filter
11  203-1429 TurboBrush
www.bissell.com 
Troubleshooting
14
1
6
11
2
7
  3
8
 4
9
 5
10
 
Visible dirt escaping from cleaner continued
Possible causes  
Remedies3. Dirt container installed incorrectly  3. Position correctly and lock into place
4.  Filter cup installed incorrectly  4. Remove dirt container and make sure filter   
    cup is fully attached
Other maintenance or service not included in the manual should be 
performed by an authorized service representative.
Thank you for selecting a BISSELL product.
  Please  do  not  return  this  product  to  the  store.               
Replacement parts - 
*The Filter Media, not the vacuum as a whole, complies with the High Efficiency 
Particulate Air (HEPA) filter specification (EN 1822-1:2009).  
						

							www.bissell.com 15
Warranty 
 This warranty gives you specific legal rights, and you may also have oth\
er rights which may 
vary from country to country. If you need additional instruction regarding this warranty or have 
questions regarding what it may cover, please contact BISSELL Consumer Services by  
telephone, or regular post as described below, or contact your local in country distributor.
Limited One Year Warranty
 Subject to the *EXCEPTIONS AND EXCLUSIONS identified below, BISSELL Homecare, Inc., 
will replace (with new or remanufactured components), at BISSELL’s option, free of charge 
from the date of purchase by the original purchaser, for one year any defective or   
malfunctioning part do to manufacturers defect. 
  This warranty applies to product used for personal, and not commercial o\
r rental service. This 
warranty does not apply to fans or routine maintenance components such a\
s filters, belts, or 
brushes. Damage or malfunction caused by negligence, abuse, or use not i\
n accordance with 
the User’s Guide is not covered.
BISSELL HOMECARE INC. IS NOT LIABLE FOR INCIDENTAL OR CONSEQUENTIAL   
DAMAGES OF ANY NATURE ASSOCIATED WITH THE USE OF THIS PRODUCT.   
BISSELL’S LIABILITY WILL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT. 
*EXCEPTIONS AND EXCLUSIONS FROM THE TERMS OF THE LIMITED WARRANTY
THIS WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES EITHER ORAL OR 
WRITTEN. ANY IMPLIED WARRANTIES WHICH MAY ARISE BY OPERATION OF LAW, INCLUDING 
THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE 
LIMITED TO THE ONE YEAR DURATION FROM THE DATE OF PURCHASE AS DESCRIBED ABOVE.
For UK inquiries:
Monday - Thursday  9 am — 5 pm 
  Friday  9 am — 4 pm 
BISSELL Homecare (Overseas) Inc.
Ground Floor 
226 Berwick Avenue 
Slough 
Berkshire, SL1 4QT 
United Kingdom  
Telephone: 0844-888-6644   For spare parts and accessories:
Monday - Friday 
   9 am — 5:30 pm 
Exserve Ltd.
550, Peterborough
Cambridgeshire, PE2 6WH
Telephone: 01733-362415   
						

							©2011 BISSELL Homecare, Inc
Grand Rapids, Michigan
All rights reserved. Printed in China
Part Number 110-4353
Rev 3/11
Visit our website at:
www.bissell.com
BISSELL consumer services
www.bissell.com 16
If your BISSELL product should require service:Call BISSELL Consumer Services at the numbers below and we will give you the location of a 
BISSELL Authorized Service Center in your area. For all other countries, contact your local in\
 
country distributor for questions, service, or repair. 
If you have questions about your warranty or need replacement parts please contact the  
numbers below.
Or visit the BISSELL website - www.bissell.com
When contacting BISSELL, have model number of cleaner available.
Please record your Model Number: ___________________
Please record your Purchase Date:  ___________________
NOTE: Please keep your original sales receipt. It  
provides proof of purchase date in the event of a  
warranty claim. See Warranty on page 15 for details.  
For UK inquiries:
Monday - Thursday 9 am — 5 pm 
  Friday  9 am — 4 pm 
BISSELL Homecare (Overseas) Inc.
Ground Floor 
226 Berwick Avenue 
Slough 
Berkshire, SL1 4QT 
United Kingdom  
Telephone: 0844-888-6644   For spare parts and accessories:
Monday - Friday 
   9 am — 5:30 pm 
Exserve Ltd.
550, Peterborough
Cambridgeshire, PE2 6WH
Telephone: 01733-362415