Home
>
Bissell
>
Vacuum Cleaner
>
Bisell BISSELL PowerGlide Cordless Vacuum Cleaner 1538A User Manual
Bisell BISSELL PowerGlide Cordless Vacuum Cleaner 1538A User Manual
Here you can view all the pages of manual Bisell BISSELL PowerGlide Cordless Vacuum Cleaner 1538A User Manual. The Bissell manuals for Vacuum Cleaner are available online for free. You can easily download all the documents as PDF.
Page 2
www.BISSELL.com 2 IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING YOUR VACUUM. When using an electrical appliance, basic precautions should be observed, including the following: WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY: » This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction...
Page 3
www. BISSELL.com3 Thanks for buying a BISSELL vacuum We’re glad you purchased a BISSELL vacuum. Everything we know about floor care went into the design and construction of this complete, high-tech home cleaning system. Your BISSELL vacuum is well made, and we back it with a limited two-year guarantee. We also stand behind it with a knowledgeable, dedicated Consumer Care department, so, should you ever have a problem, you’ll receive fast, considerate assistance. My...
Page 4
Product View www.BISSELL.com 4 1 2 5 7 10 8 9 14 346 11 13 12 1 Handle 2 Extension Wand 3 Brush On/Off 4 Power Hi/Lo 5 Dirt Tank Release Button 6 Power Button 7 Pre-Motor Filter 8 Dirt Tank 9 Battery 10 Power Brush 11 Hose 12 2-in-1 Accessory 13 Hose Connector 14 Diverter Switch
Page 5
www. BISSELL.com5 Assembly Your vacuum comes in five easy-to-assemble components: Handle and Hose Extension Tube Battery Base Unit Foot + Charging Base 1. Insert the handle into the extension wand and click into place. 2. Slide the extension wand into the base unit. 3. Insert the hose end into the hose connector on the back of the base unit, making sure both tabs click into place and the notch is aligned. 4. The 2-in-1 accessory can be stored in the clip on the side of...
Page 6
Operations www.BISSELL.com 6 PowerBrush switch 1. Press the button with brush bar icon to run the PowerBrush. 2. The PowerBrush will not run when vacuum is locked in upright position 3. If debris is keeping the vacuum from operating, turn off power switch, remove debris, and then turn power switch on to resume vacuuming. NOTE: Turn off the PowerBrush when vacuuming hard surfaces, such as hard wood or tiled floors, as well as when cleaning smaller rugs that may be caught by the...
Page 7
Above floor cleaning 1. Twist diverter switch to horizontal position to direct suction to the vacuum hose. 2. Push down on the handle release button and pull the handle and extension tube out of the body. 3. The 2-in-1 accessory can be attached to the end of the extension tube. 4. The extension wand can be removed by pressing the release button and pulling it off. The 2-in-1 accessory can also be attached to the handle end. 5. The portable canister vacuum can be released by...
Page 8
www.BISSELL.com 8 Maintenance & Care Emptying the dirt container 1. Press the dirt tank release button and pull dirt tank away from body by the handle 2. Holding the Dirt Container over a trash bin, press the Release Button on back. Snap the bottom back into place. Cleaning the dirt container 1. Release dirt tank as above, then twist the top right to separate. 2. Remove filter by pulling up on the fabric tab, then pull out the cyclone system. 3. Empty dirt container in trash bin. It...
Page 9
www. BISSELL.com9 Maintenance & Care Replacing the Brush 1. Turn power switch off, turn over and use a coin or a flathead screwdriver to open the 2 locking screws on either side of the brush bar. 2. Remove both brush plates to access brush bar. 3. Grasp the roller from the bottom, dislodge by pulling, and then thread it through the belt. 4. Replace roller and reverse the order to reassemble. Disposal of batteries If your vacuum is to be disposed of, the batteries should be...
Page 10
www.BISSELL.com 10 Replacement Parts These items are available for your BISSELL vacuum. Call 1-800-237-7691 or visit www.BISSELL.com PART # PART NAME PART #PART NAME 160-6691 Battery 160-6697 Hose and Handle 160-6187Battery Charger160-6698 Extension Wand 160-70582-in-1 Accessory Tool160-6359 Filter 160-6689 Brush Roll