Beko Wmd 25080 T Users Manual

							Washing Machine
User’s Manual
WMD 25080 R  WMD 25100 R  WME 25080 T
Стиральная машина
Руководство по эксплуатации
 
						

							3
Dear Customer,
We wish that this product, manufactured at modern facilities with total \
quality notions, will deliver you 
the best performance. In order to guarantee this, please read this instr\
uction manual thoroughly and 
keep it for your future reference.
 
						

							4
Technical Features of Your Washing Machine   5
Warning  7
Preparation  9
Program Selection and Starting Machine  13
Care and maintenance  18
Installation  20
Helpful tips on stain removal  23
Before calling service  241
Contents
2
3
4
5
6
7
8
 
						

							5
Technical Features of Your Washing Machine  
ModelsWMD 25080 R WMD 25100 R WME 25080 T
Maximum dry  laundry capacity (kg.) 55 5
Height (cm.) 8484 84
Width (cm.) 6060 60
Depth (cm.) 5454 54
Net  Weight (kg.) 6263 62
Electricity (V/Hz.) 230/50230/50 230/50
Total Current (A) 1010 10
Total Power (W) 23002300 2300
Washing -rinsing cycle  (cyc/min) 5252 52
Spinning cycle  (max cyc/min) 8001000 800There may be changes in the 
technical features without 
prior notice in order to enhance 
product quality. 
The figures in the manual 
are schematic and may not 
represent your actual machine 
one-to-one. 
Labelling on your product and 
ones declared in the docu-
ments accompanying product 
are the values obtained under 
laboratory conditions with given 
standards. These values may 
vary according to usage and 
environmental conditions.  
1
 
						

							6
1Top Lid
2Front Panel
3Handle
4Kick Plate Cover
5Front door
6Kick Plate
1
2
46
53
Your Washing Machine
 
						

							7
• This product is designed for home use. 
•  Your washing machine is adjusted to 230V. 
•  If the fuse in your house is less than 16A  than have a 
certified electrician deploy an 16A fuse. 
•  In case of transformer or non-transformer use, ground-
ing installation must be performed with a licensed 
electrician. Any use before grounding is not our respon-
sibility. 
•  Never place your machine over a carpet covered floor. 
Otherwise electrical parts of your machine may over-
heat. This may cause malfunction of your machine. 
•  Make sure hot and cold taps are connected correctly. 
Otherwise your laundry may come out hot and torn . 
•  Please call certified service for a failure of electric plug / 
cable. 
•  Be careful about your water hoses are not old. Do not 
use old / torn water hoses. This may cause stain in your 
laundry .
•  At first use, washing must be performed at Cotton 90°C 
program without loading with laundry for getting your 
machine ready for washing. 
•  Performance of your washing machine depends on the 
quality of water and hygiene compound used. If low  quality and unfitting cleaning material is used the stains 
will be fixed. Before washing your laundry with stain 
keep your attention on cleaning the laundry as explained 
in following pages. 
•  This is period of keeping spare parts for your machine 
to operate. Because of quality control procedures there 
might be little amount of water in your machine. This 
does not have any damage to your machine. 
•   Your machine is programmed for starting operation  again when electricity is off and on afterwards. You can 
not press On / Off button to cancel program. Machine 
will go on program when electricity is on. To CANCEL 
the program press >Start/Pause/Cancel<  button for 
three seconds. (See. Cancelling a program)
  If “Door” led on program progress display is blinking 
program selection knob is middle position. In this case 
turn the knob and adjust it again. If the warning contin-
ues call authorized service. 
•  After your machine starts operation, if Start/Pause/
Cancel key starts blinking than door is not locked. Open 
and close the door again begin washing program again. 
•  If the “washing” led on the program progress display 
is blinking either there is no water or tap is off. Check 
2Warning
 
						

							8
your taps. Turn your machine off and on. If the problem 
persists unplug your machine, turn off tap water and call 
authorized service. 
•  If program is started and program selection can not be 
performed your machine might be in protection mode 
due to infrastructure problem (voltage, water pressure, 
etc.) Press and hold the > Start/Pause/Cancel < button 
for 3 seconds in order to switch machine to factory set-
tings. 
•  Most of the warnings resulting in calling an authorized 
service are due to infrastructure problems. For this rea-
son applying to an Authorized Service is recommended. 
 
						

							9
Before starting your machine please beware 
of below mentioned points:
Did you plug the cable?
Did you connect draining hose correctly? 
Did you close front door?
Did you open tap water? 
If you haven’t installed your machine please read to 
“Installation” section. 
Sorting the Laundry 
Sort laundry according to type of fabric, color, level of dirti-
ness and allowed washing temperature. Do not wash white 
laundry together with colored ones. Remove hard parts like 
belt, wrist button, curtain buttons, etc. or place laundry in a 
cloth bag. Empty pockets. Zip up and button up. Very tiny 
laundry like baby clothes may get into inside of drum, midst 
of bellow, pump filter, hose, etc. in order to prevent this it 
is advised to place such laundry in a special laundry string 
bag or large laundry. See practical and useful information 
section for soiled laundry. Your machine can wash “Ma-
chine Wash” or “No-matting” labeled woolen with special 
woolen program. Delicate laundry with “Do not wash” or 
“hand wash” label (silk, cashmere, pure wool, etc.) can be washed in the special hand-wash program. 
Opening front door
Pull the handle to open the front door. Your machine’s front 
door is designed for opening  during only machine is not 
operating. If the led displays “door” than door can open. 
Loading machine with laundry 
Fill the machine by unfolding and not squeezing laundry. 
Place hand-woven garments inside-out to the machine. 
Make sure there is no laundry jammed between bellow and 
front-door.
Close the loading door by pushing. If loading door is not 
properly closed machine will not start. 
Selection of detergent and softener
Quantity of the detergent used depends on hardness of 
water and how soiled laundry is. Recommended values are 
indicated on the package. If your laundry is low soiled and/
or hardness of water is low use less detergent as indicated 
on the package. Otherwise it may result in excessive foam.
You should use detergent specially designed for automatic 
washing machines. Avoid using bleach product contain-
ing sulfur or chlorine. Place powder detergent and softener 
in appropriate drawer compartment and close detergent 
3       Preparation
 
						

							10
dispenser. 
a. Compartment I, powder detergent drawer for pre-wash.
b. Compartment II, powder detergent drawer for main 
wash.
c. Softener dispenser
d. Siphon
Fill the softener as indicated (usually