BEKO WMB 51011 F User Manual

WMB 51011 F
WMB 50811 F
WMB 51011 FS
WMB 51211 F
Washing Machine 
Перална машина 
Perilica rublja 
Plně automatická pračka
 

2 - EN
1 Warnings
General Safety•	 Never	place	your	machine	on	a	carpet	covered	floor.	Otherwise,	lack	of	airflow	from	below	of	your	machine	may	cause	electrical	parts	to	overheat.	This	may	cause	problems	with	your	washing	machine.•	 If	the	power	cable	or	mains	plug	is	damaged	you	must	call	Authorized	Service	for	repair.•	 Fit	the	drain	hose	into	the	discharge	housing	securely	to	prevent	any	water	leakage	and	to	allow	machine	to	take	in	and	discharge	water	as	required.	It	is	very	important	that	the	water...

3 - EN
2 Installation
Removing packaging reinforcementTilt	the	machine	to	remove	the	packaging	reinforcement.	Remove	the	packaging	reinforcement	by	pulling	the	ribbon.
Opening the transportation locks
A	Transportation	safety	bolts	must	be	removed	before	operating	the	washing	machine!	Otherwise,	the	machine	will	be	damaged!1.	 Loosen	all	the	bolts	with	a	spanner	until	they	rotate	freely	(“C”)2.	 Remove	transportation	safety	bolts	by	turning	them	gently.3.	 Fit	the	covers	(supplied	in	the	bag	with	the...

4 - EN
•		 The	specified	voltage	must	be	equal	to	your	mains	voltage.•		 Connection	via	extension	cords	or	multi-plugs	should	not	be	made.
B	A	damaged	power	cable	must	be	replaced	by	a	qualified	electrician.
B	The	appliance	must	not	be	operated	unless	it	is	repaired!	There	is	the	risk	of	electric	shock!
3 Initial preparations for washing
Preparing clothes for washingLaundry	items	with	metal	attachments	such	as,	bras,	belt	buckles	and	metal	buttons	will	damage	the	machine.	Remove	metal	attachments	or...

5 - EN
4  Selecting a program and operating your machine
Control panel
1	-	Spin	Speed	Adjustment	Knob	*
2	-	Temperature	Adjustment	Knob	*
3	-	Start/Pause/Cancel	Button
4	-	Auxiliary	Function	Buttons
5	-	Program	Selection	Knob
Turning the machine onYou	can	prepare	the	machine	for	program	selection	by	pressing	the	“On/Off”	button.	When	the	“On/Off”	button	is	pressed,	the	“Ready”	light	illuminates	indicating	that	the	door	is	ulocked.	Press	the	“On/Off”	button	again	to	shut	down	the	machine.
Program...

6 - EN
program.	Gentler	washing	movements	and	a	shorter	washing	cycle	is	used	compared	to	the	“Cottons”	program.	It	is	recommended	for	your	synthetic	clothes	(such	as	shirts,	blouses,	synthetic/cotton	blended	garments,	etc.).	For	curtains	and	lace,	the	“Synthetic	40”	program	with	pre-wash	and	anti-creasing	functions	selected	is	recommended.
• WoollensYou	can	wash	your	machine-washable	woolen	garments	on	this	program.	Wash	by	selecting	the	proper	temperature	according	to	the	labels	of	your	clothes.	It	is...

7 - EN
Program selection and consumption table
•	:	Selectable
*	:	Automatically	selected,	not	cancellable.
**:	Energy	Label	programme	(EN	60456)
Water	and	power	consumption	and	programme	duration	may	differ	from	the	table	shown,	subject	to	changes	in	water	pressure,	water	hardness	and	temperature,	ambient	temperature,	type	and	amount	of	laundry,	selection	of	auxiliary	functions,	and	fluctuations	in	the	supply	voltage.
C	 The	auxiliary	functions	in	the	table	may	differ	according	to	the	model	of	your...

8 - EN
Auxiliary functionsAuxiliary function selection keysSelect	the	required	auxiliary	functions	before	starting	the	program.
C	 Auxiliary	function	buttons	may	differ	according	to	the	model	of	your	machine.
Auxiliary function selectionIf	an	 auxiliary	 function	 that	should	 not	be	selected	together	with	a	previously	selected	function	is	chosen,	the	first	selected	function	will	be	cancelled	and	the	last	auxiliary	function	selection	will	remain	active.
For	example:	If	you	want	to	select	pre-wash	first...

9 - EN
The	machine	is	switched	to	child-lock	by	pressing	the	1st	and	2nd	auxiliary	functions	from	the	left	for	3	sec.	1st	auxiliary	function	light	will	flash	continuously.	To	deactivate	the	child-proof	lock,	press	the	same	buttons	for	3	sec.
Ending the program through cancelingIn	order	to	cancel	the	selected	program,	press	the	“Start/Pause/Cancel”	button	for	3	seconds.	The	machine	starts	to	discharge	the	water.	“Wash”	and	“Program	Finished”	lights	will	light	up.	“Start/Pause/Cancel”	and	“Wash”	lights...

10 - EN
by	pulling	out	the	plug	at	the	end	of	the	hose.	If	the	amount	of	water	to	be	drained	off	is	greater	than	the	volume	of	the	container,	replace	the	plug,	pour	the	water	out,	then	resume	the	draining	process.•		 After	draining	process	is	completed,	replace	the	plug	into	the	end	of	the	hose	and	fit	the	hose	back	into	its	place.If	your	 product	 is	not	 supplied	 with	an	emergency	drain	hose,	do	the	following	as	shown	in	the	figure	below:
•		 Place	a	large	container	in	front	of	the	filter	to	receive...