Beko Wma 510 W Instruction Manual

 Programme
Max.Load (kg)
Programme Duration(~min)
Water Consumption (l)
Energy Consumption (kWh)
Prewash
Rinse Plus
Rinse Hold
Spin speed reduction
No Spin
 Cottons 905133 451.65 •••••
 Cottons 60**5145 490.73 •••••
 Cottons 405142 490.69 •••••
 Super 405165 450.78 ••
 Synthetics 602.5 113 520.92 •••••
 Synthetics 402.5 125 520.56 •••••
 Synthetics 302.5 95 520.30 •••••
Delicate 30265 450.36 ••••
 Woollens 401.5 60 450.36 ••••
Hand wash 30145 320.21 ••
 Mini 302.5 30 430.17 ••
Exxtra Rinse
A Class 40
• :...

22EN
Auxiliary function selection
Select the desired auxiliary functions before 
starting the programme. Furthermore, you 
can also select or cancel auxiliary functions 
that are suitable to the running programme 
without pressing the Start / Pause / Cancel 
button when the machine is operating. For 
this, the machine must be in a step before 
the auxiliary function you are going to 
select or cancel.
If the auxiliary function cannot be selected 
or cancelled, light of the relevant auxiliary 
function...

23EN
simultaneously after washing programme 
light flashes continuously.
To deactivate the Child Lock:
Child lock must be deactivated to start a 
new programme after the programme has 
finished or to interrupt a running programme. 
st and 2nd
Function buttons for 3 seconds 
simultaneously to disable child lock. 
Progress of programme
Progress of a running programme can 
be followed from the Programme Follow-
programme step, the relevant indicator light 
will turn on and light of the completed step 
will...

EN
Cancelling the programme
Press and hold Start / Pause / Cancel 
button for 3 seconds to cancel the current 
machine can drain the water inside it or 
can take in and drain water up to 3 times 
to cool down the laundry. Washing and End 
lights turn on. 
Once draining is complete, Start / Pause 
/ Cancel and Washing lights turn off, and 
Loading Door light starts flashing. 
When the Loading Door is unlatched, 
Loading Door light turns on and remains lit. 
In this case, you can select and start the 
new...

EN
6 Maintenance and cleaning
Service life of the pr oduct extends and 
fr equently faced pr oblems decrease if 
cleaned at r egular intervals.
Cleaning the detergent drawe r
Clean the detergent drawer at regular 
as shown below in order to prevent 
accumulation of powder detergent in time.
in the softener compartment and pull 
towar ds you until the compartment is 
r emoved fr om the machine.
  If mor e than normal amount of water 
and softener mixtur e starts to gather in 
the softener compartment, the...

26EN

 $MPTF
UIF
UBQT

 3FNPWF
UIF
OVUT
PG
UIF
XBUFS
JOUBLF

hoses to access the filters on the water 
intake valves. Clean them with an 
appropriate brush. If the filters are too 
dirty, take them out by means of pliers 
and clean them.
3.  Take out the filters on the flat ends of 
the water intake hoses together with 
the gaskets and clean thoroughly under 
running water.

 3FQMBDF
UIF
HBTLFUT
BOE
GJMUFST
DBSFGVMMZ

in their places and tighten the hose 
nuts by hand.
Draining remaining water and...

EN
is emptied, repeat the above procedure 
to drain the water in the machine 
completely.
c.  When draining of water is finished, 
close the end by the plug again and fix 
the hose in its place.
d.  Turn the pump filter to take it out.
Discharging the water when the product 
does not have an emergency draining 
hose:
a.  Place a large container in front of the 
filter to catch water from the filter.
b.  Loosen pump filter (anticlockwise) until 
water starts to flow. Fill the flowing 
water into the...

28EN
7 Troubleshooting
Programme cannot be started or selected. 
Press and hold Start / Pause / Cancel 
button for 3 seconds to reset the machine to factory settings. (See "Cancelling the 
programme")
Water in the machine.
This is not a failure; water is not harmful to the 
machine.
There is water leaking from the bottom of the washing machine.
Be sure the seals of the water 
inlet hoses are securely fitted. Attach the hose to the tap tightly.
Make sure that the pump filter is 
completely closed....

29EN
Loading door cannot be opened.
t
 JOF

Drain the 
water by running the Pump or Spin programme.
t
 F

Wait until the 
programme completes.
t
 
PG
NJOVUFT
BGUFS

UIF
QSPHSBNNF
IBT
DPNF
UP
BO
FOE

Wait for a couple of minutes for 
deactivation of the door lock.
Washing takes longer time than the one specified in the manual.
t
 8BUFS
QSFTTVSF
JT
MPX

Machine waits until taking in adequate amount of 
water to prevent poor washing quality due to the decreased amount of water. 
Therefore,...

30EN
Machine does not switch to spinning step.
Automatic 
unbalanced load detection system might be activated due to the unbalanced 
distribution of the laundry in the drum.
  Machine does not switch to spinning step when the laundry is not evenly 
distributed in the drum to prevent any damage to the machine and to its 
surrounding environment. Laundry should be rearranged and re-spun.
Check the filter 
and the draining hose.
Use 
recommended amount of detergent.
Washing performance is poor: Laundry turns...