BEKO WKD 75100 S User Manual

EN25
Detergent drawer
Remove any powder residue buildup in 
the	drawer.	To	do	this;
1.	 Press	the	dotted	point	on	the	siphon in the softener compartment 
and pull towards you until the 
compartment is removed from the 
machine.
C  If more than a normal amount of 
water and softener mixture starts to 
gather in the softener compartment, 
the siphon must be cleaned.
2.  Wash the dispenser drawer 
and the siphon with plenty of 
lukewarm water in a washbasin. 
Wear protective gloves or use an 
appropriate...

EN26
•	 Remove	the	nuts	of	the	water	intake	hoses to clean the surfaces of the 
filters on the water intake valves with 
an appropriate brush.
•	 If	the	filters	are	very	dirty,	you	can	 pull them out by means of pliers and 
clean them.
•	 Take	out	the	filters	on	the	flat	 ends of the water intake hoses 
together with the gaskets and clean 
thoroughly under streaming water.
•	 Replace	the	gaskets	and	filters	 carefully and tighten the hose nuts 
by hand.
Draining any remaining water 
and cleaning the pump...

EN27
replace the plug into the end of the 
hose and fit the hose back into its 
place.
If your product is not supplied with an 
emergency drain hose, do the following 
as	shown	in	the	figure	below:
•		 Place	a	large	container	in	front	of	the	 filter to receive water flowing from 
the filter.
•		 Loosen	pump	filter	(anticlockwise)	 until water starts to flow out of it. 
Direct the flowing water into the 
container you have placed in front 
of	the	filter.	You	can	use	a	piece	of	
cloth to absorb any spilled...

EN28
ProblemCause Explanation / Suggestion
Program	
cannot be 
started or 
selected. Machine	may	have	
switched to self 
protection mode due to 
an infrastructure problem 
(such as line voltage, 
water	pressure,	etc.).
Reset	your	machine	by	pressing	“Start/Pause/
Cancel”	button	for	3	seconds.	(see,	Cancelling	
a	Program)
Water in the 
machine. There may be some water 
in your machine when you 
receive it. This is from the 
quality control process 
and is normal.
It is not harmful to your machine.
There...

EN29
The water 
being taken 
in is directly 
discharged.Improper position of the 
drain hose.
Connect the water draining hose as described 
in the operation manual.
No water can 
be seen in 
the machine 
during 
washing. This is not a problem. The 
water level is not visible 
from the outside of the 
machine.
The door is 
jammed. Water level might be 
above the lower level of 
the door.
Run	either	the	“Pump”	or	“Spin”	program.
Machine	might	be	heating	
up the water or it may be 
at the spinning cycle....

EN30
It continuously 
washes.
Remaining 
time does not 
count down.In the case of a paused 
countdown while taking in 
water:
Timer will not countdown 
until the machine is filled 
with the correct amount 
of water.
The machine will wait until there is a sufficient 
amount of water to avoid poor washing results 
due to lack of water. Then the timer will start to 
count down.
In the case of a paused 
countdown at the heating 
step:
Time will not count 
down until the selected 
temperature for the 
program...

EN31
Washing 
performance is 
poor:
Laundry turns 
gray - Using insufficient 
amount of detergent for a 
long time,
 - Washing at low 
temperatures for a long 
time,
 - Using insufficient 
amount of detergent for 
hard waters (soil can stick 
to	the	laundry),
 - Using excessive amount 
of detergent (detergent 
can	stick	to	the	laundry).  - Use the recommended amount of detergent 
appropriate for water hardness and the laundry.
 - Select the proper temperature for the laundry 
to be washed.
 - If the...

EN32
It does not 
rinse well.The amount, brand and 
storage conditions of the 
detergent used might not 
be appropriate.
Store detergent in a closed and dry place. Do 
not keep them under high temperatures.
Detergent might have 
been put in the wrong 
compartment. If detergent is put in the prewash compartment 
although prewash cycle is not selected, the 
machine can take this detergent during rinsing 
or softener step.
Machine	filter	may	be	
clogged. Check the filter.
Drain hose may be folded. Check the...

EN33
Detergent 
residue in the 
dispensing 
drawer.Detergent may have been 
put in wet dispenser 
drawer.
Dry the detergent drawer before putting in 
detergent.
Detergent may have 
gotten damp. Store detergent in a closed and dry place. Do 
not keep them under high temperatures.
Water pressure might be 
low
The detergent in the main 
wash compartment might 
have gotten wet while 
taking in the prewash 
water.. The	detergent	dispenser	outlet	(holes)	may	have	
a problem. 
There might be problems with the...

Machine	does	work.	
Nothing is displayed on 
the screen.The plug might not be 
plugged in the mains 
outlet.
Check the plug.
Fuse may have blown. Check the fuse.
Electricity may be cut 
off. Check the supply power.
The	“On/Off”	button	
might have not been 
pressed. Press	this	button.
The machine did not 
start after the program 
was selected and the 
“Start/Pause/Cancel”	
button was pressed. The front door may be 
ajar.
 
The Rinse Symbol 
amongst	the	Program	
Indicator Symbols is 
flashing. (Subject to...