Beko Dsfn 1530 B Manual

28
Adjusting the height of empty 
upper basket
(depends on the model)
You can adjust the height of the upper 
basket according to the size of the dish 
to be washed. Use basket rollers to 
change the basket height. 
1. Turn the stoppers on the ends of 
the upper basket rails by turning 
them aside (A). 
2. Take the basket out (B). 
3. Change the position of the rollers, 
place the basket into the rail and 
close the stoppers (C).
1022 eps


 
EN  

29
1. Turn the micro filter (3) and 
coarse filter (2) assembly counter 
clockwise and pull it out from its 
seating (A).
5Maintenance and cleaning
Service life of the product extends and 
frequently faced problems decrease if it 
is cleaned at regular intervals. 
A Unplug the product and turn off the 
tap before attempting any cleaning 
procedures.
C  Do not use abrasive substances for 
cleaning.
C Clean the filters and impellers at 
least once a week.
Cleaning the outer surface of 
the product
Clean...

30






4.  Clean all three filters under tap 
water by means of a brush.
5. Replace the metal/plastic filter.
6. Place the coarse filter into the 
microfilter. Make sure that it is 
properly seated. Turn the coarse 
filter clockwise until a “click” sound 
is heard. 
A Do not use the dishwasher without 
filter.
C  Incorrect placement of the filters 
will reduce washing efficiency.
Cleaning the hose filter
Damages on the machine that may be 
caused by impurities coming from the 
urban supply water or...

31
1032
Upper impeller
Check if the holes on the upper 
impeller (2) are clogged. If they 
are clogged, remove and clean the 
impeller. Turn its nut to left to remove 
the upper impeller (C, D).
Make sure that the nut is tightened well 
when installing the upper impeller. 





 
EN  

32
Troubleshooting
Machine does not start.
• Power cable is unplugged. >>> Check if the power cable is plugged in.
• Fuse is blown. >>> Check the fuses in your house.
• Water is cut. >>> Make sure that the water inlet tap is open.
• Door of the machine is open. >>> Make sure that you have closed the door 
of the machine.
• On / Off button is not pressed. >>> Make sure that you have turned on the 
machine by pressing the On / Off button.
Dishes are not washed clean
• Dishes are not placed orderly in the...

33
Dishes are not dry at the end of cycle
• Dishes are not placed orderly in the machine. >>> Place your dishes in a 
way that no water will accumulate in them.
• Rinse aid is not sufficient.  >>> Check the rinse aid indicator and add rinse 
aid if necessary. Increase the rinse aid setting if there is enough amount of 
rinse aid in the machine.
• Machine is unloaded right after the programme is over. >>> Do not unload 
your machine right after washing process is completed. Slightly open the\
 
door and...

34
Lime traces remain on dishes and glassware gains a misty appearance
• Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse 
aid if necessary. Increase the rinse aid setting if there is enough amount of 
rinse aid in the machine.
• Water hardness setting is low or salt level is insufficient >>> Measure the 
hardness of the supply water appropriately and check the water hardness \
setting.
• Salt leakage exists. >>> Pay attention not to spill salt around the salt filling 
hole...

35
Rust, discoloration or surface deterioration occurs on dishes
• Salt leakage exists. >>> Salt may cause deterioration and oxidation on 
metal surfaces. Pay attention not to spill salt around the salt filling \
hole 
while adding salt. Make sure that the salt reservoir lid is tightly clos\
ed after 
finishing the filling process. Run the prewash programme to remove the s\
alt 
that spilled inside the machine. Since the salt granules that will remai\
n under 
the lid will dissolve during prewash,...

36
Detergent remains in detergent dispenser.
• Detergent dispenser was damp when adding detergent. >>> Make sure that 
the detergent dispenser is dried well prior to filling it with detergent\
.
• Detergent is added long before the washing process. >>> Pay attention to 
add detergent shortly before start-up of the washing.
• Opening of the detergent dispenser lid is prevented during washing. >>> \
Place the dishes in a way that will not prevent the detergent dispenser \
lid 
from opening and the water...

37
A smear remains on glasses that resembles milk stain which can not be 
removed when wiped by hand. A bluish / rainbow appearance occurs when 
the glass is pointed to light.
• Excessive rinse aid is used. >>>Lower rinse aid setting. Clean the spilled 
rinse aid when adding rinse aid.
• Corrosion has occurred on glass due to soft water. >>> Measure the 
hardness of the supply water appropriately and check the water hardness \
setting. If your supply water is soft (>> Hand-wash detergents do not contain...