Beko 6111 W Manual

21EN
Programme selection and consumption table
• : Selectable
* : Automatically selected, no canceling.
**: Energy Label programme (EN 60456 Ed.3)
- : See the programme description for maximum load.
C Water and power consumption may vary subject to the changes in water pressure, 
water hardness and temperature, ambient temperature, type and amount of laundry, 
selection of auxiliary functions and spin speed, and changes in electric\
 voltage.
C The auxiliary functions in the table may vary according to...

22EN
Auxiliary function selection
Select the desired auxiliary functions before 
starting the programme. Furthermore, you 
can also select or cancel auxiliary functions 
that are suitable to the running programme 
without pressing the Start / Pause / Cancel 
button when the machine is operating. For 
this, the machine must be in a step before 
the auxiliary function you are going to 
select or cancel.
If the auxiliary function cannot be selected 
or canceled, light of the relevant auxiliary 
function...

23EN
simultaneously after washing programme 
has started. 1. The 1st Auxiliary Function 
light flashes continuously.
To deactivate the Child Lock:
Child lock must be deactivated to start a 
new programme after the programme has 
finished or to interrupt a running program. 
Press and hold 1
st and 2nd Auxiliary 
Function buttons for 3 seconds 
simultaneously to disable child lock. 
Progress of programme
Progress of a running programme can 
be followed from the Programme Follow-
up indicator. At the...

24EN
Canceling the programme
Press and hold Start / Pause / Cancel 
button for 3 seconds to cancel the current 
programme. At the end of this period, 
machine can drain the water inside it or 
can take in and drain water up to 3 times 
to cool down the laundry. Washing and End 
lights turn on. 
Once draining is complete, Start / Pause 
/ Cancel and Washing lights turn off, and 
Loading Door light starts flashing. 
When the Loading Door is openable, 
Loading Door light turns on and remains lit. 
In this...

25EN
6 Maintenance and cleaning
Service life of the product extends and 
frequently faced problems decrease if 
cleaned at regular intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular 
intervals (every 4-5 washing cycles) 
as shown below in order to prevent 
accumulation of powder detergent in time.
1.  Press the dotted point on the siphon 
in the softener compartment and pull 
towards you until the compartment is 
removed from the machine.
C If more than normal amount of water...

26EN
1. Close the taps.
2.  Remove the nuts of the water intake 
hoses to access the filters on the water 
intake valves. Clean them with an 
appropriate brush. If the filters are too 
dirty, take them out by means of pliers 
and clean them.
3.  Take out the filters on the flat ends of 
the water intake hoses together with 
the gaskets and clean thoroughly under 
running water.
4.  Replace the gaskets and filters carefully 
in their places and tighten the hose 
nuts by hand.
Draining remaining water and...

27EN
is emptied, repeat the above procedure 
to drain the water in the machine 
completely.
c.  When draining of water is finished, 
close the end by the plug again and fix 
the hose in its place.
d.  Turn the pump filter to take it out.
Discharging the water when the product 
does not have an emergency draining 
hose:
a.  Place a large container in front of the 
filter to catch water from the filter.
b.  Loosen pump filter (anticlockwise) until 
water starts to flow. Fill the flowing 
water into the...

28EN
7 Troubleshooting
Programme cannot be started or selected. 
•  Washing machine has switched to self protection mode due to a supply problem 
(line voltage, water pressure, etc.). >>> Press and hold Start / Pause / Cancel 
button for 3 seconds to reset the machine to factory settings. (See "Canceling the 
programme")
Water in the machine.
•  Some water might have remained in the product due to the quality control 
processes in the production. >>> This is not a failure; water is not harmful to...

29EN
Loading door cannot be opened.
• Door lock is activated because of the water level in the machine. >>> Drain the 
water by running the Pump or Spin programme.
•  Machine is heating up the water or it is at the spinning cycle. >>> Wait until the 
programme completes.
•  Child lock is engaged. Door lock will be deactivated a couple of minutes after 
the programme has come to an end. >>> Wait for a couple of minutes for 
deactivation of the door lock.
Washing takes longer time than the one specified in...

30EN
Machine does not switch to spinning step.
• There might be an imbalance of laundry in the machine. >>> Automatic 
unbalanced load detection system might be activated due to the unbalance\
d 
distribution of the laundry in the drum.
C Machine does not switch to spinning step when the laundry is not evenly \
distributed in the drum to prevent any damage to the machine and to its 
surrounding environment. Laundry should be rearranged and re-spun.
•  The machine will not spin if water is not drained...