Baumatic Br500 Instruction Manual

 
21 Aperture dimensions 
 
 
a) The diagram opposite shows 
the aperture size that you will 
need to be able to install your 
appliance. 
 
 
 
 
 
 
 
 
 
 
 
o The appliance must be stood on a level floor. You can use the 
levelling feet to take into account any minor unevenness in 
the floor. 
 
Adjusting the plinth/kickboard 
 
When the appliance has been placed underneath the worktop, you may 
decide to attach a plinth or kickboard to match your existing kitchen 
units. 
 
 
 
 
 
 
 
 
 
 
o...

 
22  
 
 
 
 
 
 
 
 
 
 
 
o Use a spanner to adjust the height of the adjustable feet. 
 
o If your aperture has a height of 820 mm, then the adjustable 
feet should be set at a height of 30 mm. 
 
o If your aperture has a height of 870 mm, then the adjustable 
feet should be set at a height of 50 mm. 
 
o The appliance should be flush with the underside of the worktop 
and be level. IMPORTANT: If the appliance is not level, then the 
door and door seal may be affected. 
 
o A cut out must be made in...

 
23 IMPORTANT: We recommend that two people install this appliance. 
 
a) Undo the screws from the two adjusting bolts that are located on 
the top of the appliance door and then remove the mounting bracket 
(1). 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
b) Measure the width of the furniture door, at the halfway point mark a 
line vertically down the inner surface of the furniture door. You should 
draw the line from the top of the furniture door to approximately 
halfway down.  
 
o Place the...

 
24 o Fix the mounting bracket to the furniture door using the screws 
provided and a Phillips-head screwdriver. These screws should 
be fully tightened. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
c) Hang the furniture door onto the appliance door, making sure that 
the brackets on the mounting bracket locate over the adjusting bolts. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
25 c) Use a screwdriver to adjust the gap on the lower section of the 
adjusting bolts. The gap should be set to approximately 9 mm (as 
shown in the above drawing). 
 
d) Fix the lower bracket to the bottom of the furniture door and the 
underneath of the appliance door (as shown in the drawing on the 
previous page). 
 
o It is possible to make minor adjustments to the position of the 
furniture door using the screws on the top and the bottom of the 
appliance door. You should make these adjustments...

 
26 o If the appliance is being installed under a granite worktop, use 
the L shaped brackets provided to secure the fridge to the side 
of the cabinet. Use a suitably sized drill bit to drill through the 
three holes in the bracket into the cabinet side on the opposite 
side to the hinges.  
 
o The oval holes rest over the hinge positions which are not being 
used on the front of the appliance. Use two screws to secure the 
bracket to the front of the appliance.   
 
Check that the door opens and...

 
27 o Ensure that the door is closing properly and that the door has 
not been opened for a prolonged period in error. 
 
o Ensure that there is adequate ventilation for your appliance. 
 
My fridge is noisy 
 
 
o The refrigerant gas that circulates the pipework of the appliance 
may make a slight noise, even if the compressor is not running. 
 
o If the noise worsens or the appliance gets louder than normal; 
check that it is levelled off correctly, that nothing is touching the 
rear of the fridge and...

 
28  
 
IMPORTANT: If your appliance appears not to be 
operating correctly, then you should disconnect it 
from your mains supply and then contact 
Baumatic Customer Care on telephone number 
(0118) 933 6911. 
 
DO NOT ATTEMPT TO REPAIR THE APPLIANCE 
YOURSELF. 
 
 
Please note that if an engineer is asked to attend whilst the product is 
under guarantee and finds that the problem is not the result of an 
appliance fault, then you may be liable for the cost of the call out 
charge. 
 
The appliance...

 
29
Baumatic Consumables 
 
 
o BC001 Degreaser for Dishwashers (200 g) 
 
o BC002 Descaler for Washing Machines and Dishwashers (200 g) 
 
o BC003 Ceramic Hob Cleaner (250 ml) 
 
o BC004 Oven Cleaner (250 ml) 
 
o BC005 Stainless Steel Cleaner and Protector (250 ml) 
 
o BC007 E-Cloth – General Purpose Cloth 
 
o BC008 Microwave Cover 
 
 
 
To order a Baumatic consumable product please call 0123 5437 244
 
and quote the product code. You can also order online from 
eshop.baumatic.co.uk...

 
30
Technical Data 
 
Manufacturer BAUMATIC LTD 
Model Number  BR500 
Product Category  1 – Refrigeration 
Energy Efficiency Class (1) A 
Annual Energy Consumption (2) 153 kWh 
Storage Volume of Fridge 
Compartment 144 litres 
Storage Volume of Freezer 
Compartment  
Star Rating   
Frost Free Compartments  Fridge 
Temperature Rise Time   
Freezing Capacity  
Climate Class (3) N 
Noise Level  47 dB 
Installation Type  Built-in 
 
(1) On a scale from A+++ (highest efficiency) to G (lowest efficiency)....