Baumatic Br195ss Instruction Manual

Installation 
IMPORTANT: Before installation and usage read 
all the instructions and make sure that the 
voltage (V) and the frequency (Hz) indicated on 
the rating plate are ex actly the same as the 
voltage and frequency in your home. The rating 
plate can be found on the front left edge of the    
            inside of the fridge section. 
 
The manufacturer declines all responsi bility in the event of the installer 
failing to observe all the accident  prevention regulations in force, 
which are...

 22
o 
When the connection is completed,  no stray strands or cut wire 
should be present. The cord cl amp must be secured over the 
outer sheath. 
 
Positioning 
  o It is advisable that your appliance is only installed in a location 
where the ambient temperature of  the room, corresponds with 
the climate classification that is st ated on the rating plate of your 
appliance. Your appliance may  not function correctly if the 
ambient temperature falls outs ide of the following ranges. 
 
Climate...

Reversing the doors 
 
 
IMPORTANT: Make sure you have enough room    
to lean the appliance back at a 45° angle. Care 
should be taken not to damage or break the 
condenser coils on the rear of the fridge freezer.  
 
THE APPLIANCE MUST BE DISC ONNECTED FROM THE POWER 
SUPPLY BEFORE COMMENCING THE DOOR REVERSAL PROCESS. 
 
CERTAIN SECTIONS OF THIS  PROCESS WILL REQUIRE TWO 
PEOPLE TO COMPLETE IT. 
 
WE RECOMMEND THAT THE DOOR S OF THE FRIDGE FREEZER 
ARE REVERSED BEFORE YOU START TO USE THE APPLIANCE....

 1) Gently prise off the three plas tic screw covers from the top 
cover, using a small flat-headed screwdriver. Then remove the 
screws from the front and back of  the top cover, before taking it 
off. 
 
2)  Gently prise off the top hinge hole  cover and then refit it to the 
opposite side of the top cover. 
 
3)  Gently prise off the plastic hinge  covers at the top of the fridge 
door, using a small flat-headed screwdriver. One of the plastic 
hinge covers is small; this one  will be reused later in...

 25
5)
 Carefully remove the fridge d oor from the middle hinge. The 
door should be gently placed on  some form of padded surface, 
so that damage is not caused to it.  
 
6)  Remove the middle hinge door plug from the left hand side of 
the fridge door. Remove the midd le hinge door stopper using a 
medium sized cross-headed screwdri ver and then refit it onto the 
opposite side of the fridge d oor. The middle hinge door plug 
should also be refitted to the opposite side of the fridge door.  
 
7)...

 
12) Unscrew the two screws that are fitted to the lower hinge holes on 
the left hand side of the cabinet.  Then fit the lower hinge to the left 
hand side of the cabinet using the screws that you have just removed. 
 
13) Carefully return the fridge freezer  back to its upright position. If 
necessary adjust the two front feet to  make sure that the appliance is 
level. 
 
14) Locate and refit the freezer  door onto the lower hinge. 
IMPORTANT:  You must ensure that th e hinge locates into the...

18) The upper hinge needs to be rotated through 180 degrees from its 
original position, before being refitted to the opposite side of the 
cabinet.  IMPORTANT:  You must ensure that the hinge locates into the 
relevant hole in the fridge door. 
 
19) Refit the top cover and then re tighten the screws at the front and 
back of the top cover. 
 
20) Re-fit the small plastic hinge cover that you removed in stage 3 
and fit the larger plastic hinge cove r that was supplied separately with 
the appliance, to...

Troubleshooting 
 
IMPORTANT: If your fridge freezer appears not to be 
operating properly, before contacting the Baumatic 
Customer Care Department, please refer to the 
checklist below.
 
 
My fridge freezer does not appear to be working/there 
is no power to my appliance. 
 
  o Check that the plug is fully in serted into the power socket. 
 
o  Check that there is power to yo ur mains supply (e.g. that there 
hasn’t been a power cut or that the fuse hasn’t blown). 
 
o  Check that the thermostat dial...

 
 
Ice has formed on the inner back wall of my fridge. 
 
  o Check that food has not been pu shed too far back inside the 
appliance, so that it is in contact with the inner back wall.  
  o IMPORTANT:  It is normal to get some ice droplets forming on 
the back wall of the appliance. Th e formation of ice droplets does 
not indicate an appliance fault. 
         
 
There is water in the base of  the fridge or leaking out 
of my fridge. 
 
  o Follow the “The defrost drai n hole” section on page 18....

IMPORTANT: Baumatic Ltd. operates a policy of continuous 
improvement and reserves the right to adjust and modify its 
products without prior notification. 
  
 
 
 
 
 
Czech Republic 
 Baumatic CR spol s.r.o. 
United Kingdom 
Průmyslová zóna Sever 696 
Baumatic Ltd., 
460 11 Liberec 11 
Baumatic Buildings, 
Czech Republic 
6 Bennet Road, 
 
Reading, Berkshire 
+420 483 577 200 
RG2 0QX 
 
United Kingdom 
www.baumatic.cz 
 
 
Sales Telephone
 
Slovakia 
(0118) 933 6900 
Baumatic Slovakia, s.r.o. 
Sales...