Baumatic Bf340ss Instruction Manual

							
 21
Positioning 
 
o It is advisable that your appliance is only installed in a location 
where the ambient temperature of  the room, corresponds with 
the climate classification that is st ated on the rating plate of your 
appliance. Your appliance may not function correctly if the 
ambient temperature falls outs ide of the following ranges. 
 
Climate classification Appropriate ambient temperature 
SN +10 to +32 degrees centigrade 
N +16 to +32 degrees centigrade 
ST +18 to +38 degrees centigrade 
T +18 to +43 degrees centigrade 
 
o Positioning the appliance requires  two people in order to avoid 
injuries or damage to the appliance. 
 
o  Your appliance should not be located in direct sunlight or 
exposed to continuous heat or extremes of temperature (e.g. 
next to a radiator or boiler). If  this is not feasible, then you 
should install an insulation pl ate between the appliance and the 
adjacent heat source. 
 
o  You should check whether there is  an electrical socket available, 
which will be accessible after your appliance is installed. 
 
o  Place the appliance flatly and  firmly on a solid base. The 
appliance is fitted with adjustable  feet on the front side, which 
can be used to level the appliance. 
 
o  Anything positioned above the a ppliance must be at least 15 cm 
away to allow sufficient cooling of the condenser. You must allow 
a 5 cm gap to the rear and either side of the appliance. 
 
o  If you are placing another cooling appliance next door to this 
product, then there must be a gap of at least 2cm between the 
appliances. This will help to prev ent condensation from forming. 
 
o Be sure to leave enough space  for the opening of the door, to 
avoid damage to the appliance or personal injury.  
 
 
 
 
 
 
 
 
 
						

							
Reversing the doors 
 
 
IMPORTANT: Make sure you have enough room    
to lay the appliance on its back, without 
damaging or breaking the condenser coils on the 
rear of the fridge freezer.  
 
You should also ensure that ther e are no sharp or hard objects 
on the floor in this area.  
 
THE APPLIANCE MUST BE DISCONNECTED FROM THE POWER 
SUPPLY BEFORE COMMENCING THE DOOR REVERSAL PROCESS. 
 
CERTAIN SECTIONS OF THIS PROCESS WILL REQUIRE TWO 
PEOPLE TO COMPLETE IT.   
 
You must disassemble the lowe r door first (freezer) and 
then the upper door (fridge).
 Any parts that you remove 
from the appliance whilst reversing the door, should be 
retained for later use. 
 
 
1) Lay the appliance on its back.  
 
 
 
 
 
 
 
 
 
 
 
2) Remove the plinth 
beneath the bottom door 
by gently pulling it away 
from the fridge freezer 
cabinet. 
 
3) Using a star-headed 
screwdriver, unscrew the 
lower hinge assemblies 
(left and right) and lift 
them out of their sockets. 
 
 
 
 
  22
 
						

							
4) Move the pin and washer that connect to the right hand hinge,  
from the right hand hole to the left hand hole. 
 
5) Remove the lower door by gently 
sliding it downwards, away from the main 
body of the fridge freezer. 
 
 
 
 
 
 
 
 
6) Using a star-headed screwdriver, unscrew 
the middle hinge and lift it out of its socket.  
 
 
 
 
 
 23
pper 
 
er 
 
7) Carefully slide the u
door from the upper hinge 
pin  (K) and then using a
star head screwdriv
unscrew the top hinge 
cover  (A) and sensor 
cover  (B). 
 
8) Using a star-headed 
screwdriver, unscrew the 
upper hinge and screw it 
onto the opposite side of 
the cabinet from its 
original position. 
 
9) Screw the top hinge cover and 
sensor cover back to the opposite 
side of the cabinet from their original 
positions.  IMPORTANT:  You should 
make sure that the position of the 
upper pin hinge lines up exactly with 
the hinge hole in the top of the upper 
door. 
 
 
 
 
 
						

							
10) Reattach the upper door to the hinge pin. IMPORTANT: The door 
must be supported from the underneath until step 15 has been 
completed. The upper door MUST NO T be allowed to hang loose whilst 
steps 10-15 are being followed. We recommend that one person 
supports the door, whilst the othe r person completes the steps 
outlined below. 
 
11) Using a small flat-headed screwdriver, prise 
the covering caps from the hole in the middle of 
the cabinet. Place them in the holes that have 
been left by the removal of the middle hinge. 
 
12) Invert the middle hinge and carefully place the 
hinge pin into the bottom hole of the upper door. 
 
13) Firmly secure the middle hinge assembly to the cabinet using the 
screws that you removed previously.  The holes contain insulation foam 
which can be easily bored into. 
 
14) Ensure that the upper door is  level, and make sure that it can 
open and shut easily, without fouling against the cabinet. 
 
15) Reconnect the lower door, taking  care to ensure that the top pin 
fits securely into its socket. 
 
16) Reattach the bottom hinges, maki ng sure that lower hinge pin and 
washers are located on the opposite si de of the cabinet to their original 
position. Take care to ensure that  the lower hinge pin fits into the 
socket properly. 
 
17) Ensure that all hole co vering caps are replaced. 
 
IMPORTANT: Check that bo th the upper and lower 
doors open and shut correctly, without fouling, after 
you have completed the door reversal process. 
 
 
 
 
 
 
 
 
 
 
 
 
  24
 
						

							
Troubleshooting 
 
IMPORTANT: If your fridge freezer appears not to be 
operating properly, before contacting the Baumatic 
Service Department, please refer to the checklist 
below.
 
 
My fridge freezer does not appear to be working/there 
is no power to my appliance. 
 
o  Check that the plug is fully in serted into the power socket. 
o Check that there is power to yo ur mains supply (e.g. that there 
hasn’t been a power cut or that the fuse hasn’t blown). 
o  Check that the thermostat insi de the appliance has not been 
turned to the COOL ING OFF position. 
o Check that your mains supply  voltage, corresponds to the 
voltage stated on the rating plate of your appliance. 
 
My fridge freezer appears to be performing poorly 
 
 
o  Check that the appliance isn’t ov erloaded and that food hasn’t 
been packed too tightly into it. 
o  The thermostat setting is t oo low; you should turn the 
thermostat up higher. 
o  Ensure that the door is closing  properly and that the door has 
not been left open for a prolonged period in error. 
o  Ensure that there is adequate  ventilation for your appliance. 
 
My fridge freezer is noisy 
 
 
o The refrigerant gas that circulates the pipework of the appliance 
may make a slight noise, even if the compressor is not running. 
o If the noise worsens or the app liance gets louder than normal; 
check that it is leveled off correc tly, that nothing is touching the 
rear of the fridge freezer and that nothing placed inside the 
appliance is rattling. 
 
Ice has formed on the inner back wall of the fridge, or 
there is water in the  base of the fridge.  
 
 
o Check that food has not been pu shed too far back inside the 
appliance, so that it is in contact with  the inner back wall.            
 
 
 
 
 
25
 
						

							
 26
Baumatic Ltd. Conditions of guarantee 
 
Dear Customer, 
 
Your new Baumatic appliance comes complete with a free 12 month guarantee covering both parts and 
labour costs resulting from defective materials or workmanship. 
 
Baumatic also gives you the opportunity to automatically extend the guarantee period for a further 12 
months at no extra cost, giving an initial guarantee period of 24 months. The extended guarantee period 
applies to England, Scotland, Wales and Northern Ireland only. 
 
To qualify for your full 24 months guarantee you must register your appliance within 28 days of purchase 
to be covered under this guarantee. This can be done online via: 
www.baumatic.co.uk or through returning 
the guarantee card which can be foun d in each new Baumatic appliance. 
  
* In addition, your appliance is covered by a 5 y ear parts warranty. Baumatic Ltd will provide free of 
charge the parts required to repair  the appliance, only if they are fitted by a Baumatic engineer, for any 
defect that arises due to faulty materials or workmanship within a period of 5 years from the original 
purchase date. 
* An additional 1 to 3 year insurance scheme for labour is available should you wish to extend the 
warranty period. 
Should any person other than an authorised representativ e of Baumatic Ltd interfere with the appliance, the 
policy is negated and Baumatic Ltd will be under no further liability. 
 
The guarantee covers the appliance for normal domestic use only, unless otherwise stated. 
 
Any claims made under the terms of the guarantee must be supported by the original invoice/bill of sale 
issued at the time of purchase. 
 
This guarantee is transferable only with  the written consent of Baumatic Ltd. 
 
If the appliance fails and is considered either not repairable or uneconomical to repair between 12 months 
(2 years if registered) and five years, a fr ee of charge replacement will not be offered. 
 
The guarantee for any replacement will only be for the remainder of the guarantee on the original product 
purchased. 
 
The guarantee does not cover: 
-  Sinks and taps 
-  Failure to comply with the manufacturers instructions for use. 
-  The replacement of cosmetic components of accessories 
-  Accidental damage or wilful abuse. 
-  Subsequent loss or damage owing to the failure of the appliance or electrical supply 
-  Incorrect installation 
-  Losses caused by Acts of God, civil war, failur e to obtain spare parts, strikes or lockouts 
-  Filters, fuses, light bulbs, external hoses, damage to bodywork, paintwork, plastic items, covers, 
baskets, trays, shelves, burner bases, burn er caps, decals, corrosion, rubber seals. 
 
In the course of the work carried out it may be  necessary to remove the appliance from it operating 
position. Whilst all reasonable care will be taken, Baumatic Ltd cannot accept responsibility for damage 
sustained to any property whatsoever in this process. 
 
This guarantee is in addition to and does not diminish your statutory or legal rights. 
 
Contacting Baumatic Ltd 
Sales              Service              Spares                  Technical/Advice   
TEL: 0118 933 6900        TEL: 0 118 933 6911  TEL: 0118 933 69 22              0118 933 6933 
FAX: 0118 931 0035       FAX: 0118 986 9124  FAX: 0118 933 6942             0118 933 6942 
For ROI (Republic of Ireland), please contact one of the numbers below: 
TEL: 01 – 6266798                   FAX: 01 - 6266634 
 
Thanks you for buying Baumatic. 
* Applies to UK, Scotland, Wales & Northern Ireland only (Republic  of Ireland has 1 year labour & 1 year parts warranty only) 
 
						

							
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Headquarters 
 
Baumatic Ltd. 
Baumatic Buildings, 
6 Bennet Road, 
Reading, 
Berkshire 
RG2 0QX,  United Kingdom 
 
 
Sales Telephone 
+44 118 933 6900 
 
Sales Fax 
+44 118 931 0035 
 
Service Telephone 
+44 118 933 6911 
 
Service Fax 
+44 118 986 9124 
 
Spares Telephone 
+44 118 933 6922 
 
Technical / Advice Telephone 
+44 118 933 6933 
 
E-mail: 
 
[email protected]
 
[email protected]
 
Http (Internet site): 
www.baumatic.com
 27
 
						

							
 28  28