Avio Mp-20e Multi Projector Users Manual

A Proposal for New
Presentations
MULTI PROJECTOR
User’s Manual
MP-20E
English
Deutsch
Français
Español 

E-2
Thank you for purchasing the AVIO MP-20E LCD Projector.
Please read this manual carefully in order to use the projector properly.
After reading this, please keep it in a safe place together with the warranty sheet.
Features of the MP-20E
•Very versatile three-in-one projector. A projector for the multimedia age.
1.Projection of documents, catalogs, and other printed materials. Printed materials can be projected directly without the
creation of OHP film.
2. Projection of personal computer screen...

E-3
 WARNING
●If a fault occurs:
•If you detect smoke, or a strange smell or sound, immediately disconnect the power cable.
It is dangerous to continue using the projector after a fault occurs. Return the projector to the dealer where it was purchased
for repair.
●Avoid placing the projector near dangerous substances.
•Make sure that no metallic or flammable material can get into the projector through the air vents.
•Do not place any objects containing water on top of or next to the projector.
●If...

E-4
 CAUTION
•Installation
•Avoid installing the projector in places where it may be exposed to:
-Strong vibrations
-Soot or steam
-Direct sunlight or near a heater (35°C/95°F or higher)
-High humidity or dust
-Extreme cold (0°C/32°F or lower)
-Strong magnetic or electric field generated from a nearby appliance
-Wobbling on an unstable surface
•Do not block the air vents.
•Do not block the air vents with cloth or an object.
When you put anything around the unit, be sure to ensure a space of 10 cm/4...

E-5
•Lamp implosion
•A DC type Super High pressure lamp is used in this projector and it is rare for the lamp to explode during use. The unit is also
designed to forcibly turn off the lamp because there is a high possibility that the lamp will break if it is used beyond the lamp
usage of 2000 hours (Refer to pages E-41 and E-42).
Note the following things
•A sound occurs because the internal pressure of the Super High pressure lamp gets extremely high.
The unit is designed so that no pieces of glass come...

E-6
Table of Contents
Safety Precautions ................................................. E-3
A Check of the Supplied Items
and the Names of the Parts .............................. E-7
Supplied Parts Check ............................................... E-7
Names and Functions of the Par ts (Projector) ......... E-8
Names and Functions of the Parts (Input Connectors)........... E-10
Names and Functions of the Parts (Operation Panel)............ E-11
Names and Functions of the Parts (Remote...

E-7
A Check of the Supplied Items and the Names of the Parts
Supplied Parts Check
Please check that the supplied parts are included.
Lens cap MP-20E Projector
Power cable (3 m) Remote control
Coin-type lithium battery: CR2025
(Inside the remote control)
User’s Manual
PC connection cable (2 m)
Pull out the sheet before use.
Replacement air filter
Users manual 

E-8
A Check of the Supplied Items and the Names of the Parts
Names and Functions of the Parts (Projector)
Remote control
IR sensor
Lens cap Focus adjustment ring
Turn this to adjust the focus.
See Page E-22. Projection lens
The image is projected from here.
* Be sure to remove the lens cap
before projecting.
Zoom lever
Turn this to adjust the screen size. See Page E-22. Document cover
The document or printed material to be read is
placed under this cover.
See Page E-29.
Operation panel
The buttons used...

E-9
A Check of the Supplied Items and the Names of the Parts
Speaker
(2 W, monaural)
Theft prevention lock
Please see the Note below. Remote control IR sensor Document reading area
The document or printed material
that you wish to project in the OHP
mode is placed here.
See Page E-29.
Power input connector
Plug in the power cable here. See Page E-21.
Lamp unit cover (Underneath projector)
The projection lamp unit is located inside.
See Page E-42.Handle
NOTE
About the anti-theft lock
The anti-theft lock...

E-10
A Check of the Supplied Items and the Names of the Parts
Names and Functions of the Parts (Input Connectors)
1. Audio input connectors for the video
Audio input connectors for use with the video. (Stereo sup-
ported)
See Page E-20.
NOTE: The sound of the left and right channels is output
from the monaural speaker.
2. Video input connector
This input connector is for use with the video (NTSC / PAL /
SECAM).
See Page E-20.
3. S-video input connector
This input connector is for use with the (Y/C)...