Avaya Partner Advanced Communications System System Planner Manual

PARTNER
® Advanced Communications System
31
Form F5–Customized Extensions/Pool Access Restrictions (Continued)
Form F5–Customized Extensions/Pool Access Restrictions (Continued) 
 
 
E 4NA


A

NA

A 

NA

NA

2

3

P

NA

343536
37
38
39
40
41
42
43
44
45
46
47
48
49
78
79
 
 
   
 
 
 
 
 
 
 
 
 
 
  
 
  
 
  
 
   
 
 
       
 
 
 
 
   
Identify Extension Settings
if different from default
Write line numbers or pool access
codes in each column to show desired
Line Ringing options.Identify Line...

PARTNER
® Advanced Communications System
32
Form F5: Instructions for Pool Access RestrictionsForm F5: Instructions for Pool Access RestrictionsPool Access Restriction (#315)By default, access to all lines and pools is set to No Restriction. To change the default, write the line numbers or pool access codes in the 
appropriate columns, as follows:
Outgoing only—User can place outside calls and receive only transferred calls on specified line or pool.
Incoming only—User cannot place outside calls but can...

PARTNER
® Advanced Communications System
33
PARTNER
® ACS 1600 DSL Module Planning Checklist
PA RT N E R
® ACS 1600 DSL Module Planning Checklist
Use this job aid to help you collect, organize and record the settings necessary for a PARTNER installation that includes the 1600 DSL module. 
Always double-check this data before allowing this document to be used to program the module. 

There is a worksheet at the end of this document that you can use for settings that will not fit in the table.

All...

PARTNER
® Advanced Communications System
34
PARTNER
® ACS 1600 DSL Module Planning Checklist
Required Information 
Notes 
Sample values 
Enter values for current installation 
2. Custom DSLAM 
settings If your SDSL provider uses a DSLAM not included on 
the list at right, you must obtain and program the 
information in this section to complete the configuration. Lucent Stinger 
Nokia 
Copper Mountain 
Paradyne 
AccessLan Set SDSL speed 
automatically
1
Allows the 1600 DSL to automatically match the...

PARTNER
® Advanced Communications System
35
PARTNER
® ACS 1600 DSL Module Planning Checklist
Required Information 
Notes 
Sample values 
Enter values for current installation 
Transmit/Receive CIR
1
The Committed Information Rate (CIR) to and from the provider. Default values may be 
used unless instructed by provider. Value should be the same for both voice and data 
PVCs. 
There are three values associated with CIR: 
 Committed Burst Size (Bc) 
 Circuit throughput 
 Excess Burst Size (Be) 
Leave...

PARTNER
® Advanced Communications System
36
PARTNER
® ACS 1600 DSL Module Planning Checklist
Required Information 
Notes 
Sample values 
Enter values for current installation 
5. VoIP settings Obtain these settings if your SDSL provider uses VoIP with the Lucent PathStar or other VoIP voice gateway. These settings are in 
addition to the required ATM or Frame Relay settings.    IP address of Notified 
Entity
1 
IP address of the VoIP gateway192.168.32.2 
IP address for MGCP 
signaling
1
Media Gateway...

PARTNER
® Advanced Communications System
37
PARTNER
® ACS 1600 DSL Module Planning Checklist
Required Information 
Notes 
Sample values 
Enter values for current installation 
10/100BaseT Ethernet 
subnet mask
3
Specifies the size of the network to which the LAN port 
is connected. 255.255.255.0 
User ID
3
Restricts access to the 1600 DSL at the User level. 
Case-sensitive. Up to 17 alphanumeric characters.myID 
User password
3
Restricts access to the 1600 DSL at the User level. 
Case-sensitive. Up to 17...

PARTNER
® Advanced Communications System
38
PARTNER
® ACS 1600 DSL Module Planning Checklist
Required Information 
Notes 
Sample values 
Enter values for current installation 
Static Binding IP 
address
3
Links a host to an address using MAC number. 192.168.32.33
00:c0:d5:d4:da:2c   See worksheet (if necessary)
NAT
3
Allows multiple LAN hosts to access the Internet behind 
one public IP address. E (to enable); D (to 
disable) 
7. Packet filtering needs Actions to be permitted 
or denied
3
Enter rules via...

PARTNER
® Advanced Communications System
39
PARTNER
® ACS 1600 DSL Module Planning Checklist
Required Information 
Notes 
Sample values 
Enter values for current installation 
Spanning Tree: Max 
Age
3
Spanning Tree: Forward 
Delay
3
Spanning Tree: Path 
Cost
3
1. Obtained from SDSL provider
2. Obtained from ISP
3. Obtained from customer/LAN VAR 

PARTNER
® Advanced Communications System
40
PARTNER
® ACS 1600 DSL Module Planning Checklist
Worksheet for extended values
Use the following space to note values that will not fit in the Planning Checklist table.
For example, NAT addresses, firewall considerations, routing values, etc.