Asus Z60np Installation Guide

							INSTALLATION & REPLACEMENT 
 1 - 11
 
 
CPU Module 
The Z60Np Series Notebook comes standard with a Intel®’s µFC-PGA Socket on the 
motherboard, which means it can support all µFC-PGA CPUs up to 1.7 GHz. 
 
First, remove AC-power and battery. 
Removing CPU 
1. Remove 2 screws(M2*4L ) from CPU Cover and take the cover away 
     
                     
2. Remove type and remove 2 screws (M2*4L) from FAN then take the CPU Fan 
over 
CPU MODULE 
 
CPU 
REMOVAL  
						

							INSTALLATION & REPLACEMENT 
 1 - 12
      
       
3. Remove 4 screws (M2*4L) from Heat-Sink then take the CPU heat-sink away  
      
            
4. Carefully remove the CPU thermal pad 
 
 
5. Turn the non-removable screw here 180 degrees counter-clockwise to loose the 
CPU  
						

							INSTALLATION & REPLACEMENT 
 1 - 13
 
 
6. Don’t touch the die above the CPU. Then use the CPU vacuum hand pump to 
“suck up” the CPU and take the CPU away.  
 
 
Installing CPU 
1. Use the CPU vacuum to “suck up” the CPU then install CPU onto the socket, 
make the triangle sign on the CPU match the socket triangle sign. 
     
                     
2. Turn the non-removable screw here180 degrees clockwise to fix the CPU and stick 
thermal pad on the CPU die 
CPU 
INSTALLATION  
						

							INSTALLATION & REPLACEMENT 
 1 - 14
       
                 
3. Place the CPU Heat-Sink on CPU then secure 4 screws (M2*4L) in sequence 
and stick the warranty label 
      
         
4. Place the CPU fan in the proper location then secure 2 screws (M2*4L) and 
place cable properly then use tape to fix it 
     
              
						

							INSTALLATION & REPLACEMENT 
 1 - 15
 
 
5. Place the CPU Cover then Secure 2 screws (M2*4L) to fix it 
      
 
 
First, remove AC-power and battery. 
Optical Drive Module Replacement 
 
1. Unlock and hold it then pull the optical drive out 
      
                   
2. Insert the Optical Drive into the system 
OPTICAL 
DRIVER 
REPLACEMENT 
  
						

							INSTALLATION & REPLACEMENT 
 1 - 16
      
        
 
 
 Installing Mini-PCI module 
1. Use the tool to prop the keyboard cover up and slide to the right and press key “F7” 
then turn over the keyboard cover at the same time.  
      
                            
2. Remove 2 screws (M2*2.5L) of the keyboard. Then turn over the keyboard 
       
                      
3. Insert the mini-PCI module at 45 degrees angle, and then push it down to 
secure.  
 
 
 
INSTALLATION 
OF MINI-PCI 
MODULE 
  
						

							INSTALLATION & REPLACEMENT 
 1 - 17
   
 
 
 
45 
degrees