Asus Memo Pad User Manual

							
K00B101

Coating notice
IMPORTANT!  To provide electrical insulation and maintain electrical safety, a 
coating is applied to insulate the device except on the areas where the I/O ports are 
located.
Driving safely
Never use this device while driving. It is an offence, that while driving, to hold the device or cradle it in your neck at any point, during the setup, making or taking text message or any other data related mobile communication. Use of fully installed car kits are still permitted, as are the use of alternate handsfree accessories.
In the interest of safety, we would recommend the use of a cradle while using any form of handsfree accessory.
While driving, we recommend that you use voicemail wherever possible, and that you listen to your messages when you are not in the car. If you must make a handsfree call when driving, keep it brief. 
Do not place objects, including both installed or portable wireless equipment, in the area over the airbag or in the airbag deployment area. An airbag inflates with great force. If the airbag inflates, serious injury could result.
Electronic devices
Most modern electronic equipment is shielded from RF energy.However, certain electronic equipment may not be shielded against the RF signals from your device. 
						

							
MeMO Pad E-Manual
10

Pacemakers
The Health Industry Manufacturers’ Association recommends that a minimum separation of six (6”) inches be maintained between a phone and a pacemaker to avoid potential interference with the pacemaker. These recommendations are consistent with the independent research by and recommendations of Wireless Technology Research.
If you have a pacemaker:
•  
Always keep your device more than six inches (15cm) from your pacemaker 
when turned on.
•   Do not carry your device in your breast pocket.
•   Use the ear opposite the pacemaker to minimize the potential for interference.
•   If you have any reason to suspect that interference is taking place, turn your 
device off immediately.
Hearing aids
Some digital phones may interfere with some hearing aids. In the event of such interference, call ASUS Customer Service to discuss alternatives. 
Other medical devices
If you use any other personal medical device, consult the manufacturer of your device to determine if it is adequately shielded from external RF energy. Your physician may be able to assist you in obtaining this information.
Turn your device off in healthcare facilities when any regulations posted in these areas instruct you to do so. Hospitals or healthcare facilities may be using equipment that could be sensitive to external RF energy.
Vehicles
RF signals may affect improperly installed or inadequately shielded electronic systems in motor vehicles. Check with the manufacturer or its representative regarding your vehicle. You should also consult the manufacturer of any equipment added to your vehicle.
Posted facilities
Turn your device off where posted notices so require. 
						

							
K00B10

Magnetic media
Magnetic fields generated by mobile devices may damage data on magnetic storage media, such as credit cards, computer discs or tapes. Do not place your device next to such media.
You should never expose your device to strong magnetic fields as this may cause temporary malfunction.
Other Safety Guidelines
Aircraft
Regulations prohibit using your mobile device while onboard an aircraft. Switch off your device before boarding an aircraft or turn off the wireless connections.
Blasting areas
To avoid interfering with blasting operations, turn your device off when in a ‘blasting area’ or in areas posted: “Turn off two-way radio.” Obey all signs and instructions.
Potentially explosive environments
Turn your device off when in any area with a potentially explosive environment and obey all signs and instructions.
Sparks in such areas could cause an explosion or fire resulting in bodily injury or even death.
Areas with a potentially explosive environment are often, but not always, clearly marked. They include fuelling areas such as gas stations, below decks on boats, fuel or chemical transfer or storage facilities, vehicles using liquified petroleum gas (such as propane or butane), areas where the air contains chemicals or articles, such as grain, dust, or metal powders, and any other area where you would normally be advised to turn off your vehicle’s engine.
Choking
Keep your away from children as the SIM card and other small parts present a choking hazard. 
						

							
MeMO Pad E-Manual
10

Proper disposal
Risk of explosion if battery is replaced by an incorrect type. 
Dispose of used batteries according to the instructions.
DO NOT throw the battery in municipal waste. The symbol of the 
crossed out wheeled bin indicates that the battery should not be 
placed in municipal waste.
DO NOT throw the MeMO Pad in municipal waste. This product has 
been designed to enable proper reuse of parts and recycling. The 
symbol of the crossed out wheeled bin indicates that the product 
(electrical, electronic equipment and mercury-containing button 
cell battery) should not be placed in  municipal waste. Check local 
regulations for disposal of electronic products.
DO NOT throw the MeMO Pad in fire. DO NOT short circuit the 
contacts. DO NOT disassemble the MeMO Pad.
Manufacturer:ASUSTeK Computer Inc.
Address:4F, No.150, LI-TE RD., PEITOU, TAIPEI 112, TAIWAN
Authorised representative 
in Europe:
ASUS Computer GmbH
Address:HARKORT STR. 21-23, 40880 RATINGEN, GERMANY
Model name:  K00B (ME173X)    
						

							
K00B10

EC Declaration of Conformity 
We, the undersigned, Manufacturer: ASUSTeK COMPUTER INC. Address, City: 4F, No. 150, LI-TE Rd., PEITOU, TAIPEI 112, TAIWAN Country: TAIWAN   Authorized representative in Europe: ASUS COMPUTER GmbH Address, City: HARKORT STR. 21-23, 40880 RATINGENCountry: GERMANYdeclare the following apparatus: Product name : 
ASUS MeMO Pad Model name : K00B conform with the essential requirements of the following directives: 2004/108/EC-EMC Directive   EN 55022:2010 / AC:2011   EN 61000-3-2:2006+A1:2009+A2:2009   EN 55013:2001+A1:2003+A2:2006
  EN 55024:2010   EN 61000-3-3:2008   EN 55020:2007+A11:20111999/5/EC-R &TTE Directive   EN 300 328 V1.7.1(2006-10)   EN 300 440-1 V1.6.1(2010-08)   EN 300 440-2 V1.4.1(2010-08)   EN 301 511 V9.0.2(2003-03)   EN 301 908-1 V5.2.1(2011-05)   EN 301 908-2 V5.2.1(2011-07)   EN 301 893 V1.6.1(2011-11)   EN 302 544-2 V1.1.1(2009-01)   EN 302 623 V1.1.1(2009-01)   EN 50360:2001   EN 62479:2010   EN 50385:2002   EN 62311:2008 
  EN 301 489-1 V1.9.2(2011-09)   EN 301 489-3 V1.4.1(2002-08)   EN 301 489-4 V1.4.1(2009-05)   EN 301 489-7 V1.3.1(2005-11)   EN 301 489-9 V1.4.1(2007-11)   EN 301 489-17V2.2.1(2012-09)   EN 301 489-24 V1.5.1(2010-09)   EN 302 326-2 V1.2.2(2007-06)   EN 302 326-3 V1.3.1(2007-09)   EN 301 357-2 V1.4.1(2008-11)   EN 302 291-1 V1.1.1(2005-07)   EN 302 291-2 V1.1.1(2005-07)   EN 62209-2:2010
2006/95/EC-LVD Directive EN 60950-1 / A12:2011   EN 60065:2002 / A12:2011 
2009/125/EC-ErP Directive   Regulation (EC) No. 1275/2008   Regulation (EC) No. 642/2009   Regulation (EC) No. 278/2009 
2011/65/EU-RoHS Directive                                                                                                                                                                    Ver. 130208CE marking
Declaration Date: 05/15/2013 Year to begin affixing CE marking:2013 
Position :   CEOName : Jerry    Shen
Signature :__________
(EC conformity marking)  
						

							
MeMO Pad E-Manual
10