Asus G1s Service Guide
Have a look at the manual Asus G1s Service Guide online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 379 Asus manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Disassembly procedure
2 - 11
8. Open one latch before LCD and then separate LCD module from system.
9. Disconnect the touch pad cable with pair of tweezers.
LCD Module
The illustrations below show how to remove and disassemble the LCD module. The
module contains LCD panel, Inverter board, LCD bezel, LCD back cover.
Disassembling LCD Module
1. Remove 7 screws from LCD module.
LCD MODULE
LCD MODULE
DISASSEMBLY
Disassembly procedure
2 - 12
2. Prying the inside edges of the bezel, then separate it from LCD back cover and take LCD front
bezel away.
3. Disconnect LCD cable from the inverter board and softly lift the board off LCD back cover,
then remove the tape pasting the other connector, and disconnect the inverter cable from the
inverter board, finally remove the inverter board.
Disassembly procedure
2 - 13
4. Remove the LED at both sides.
5. Remove 6 screws here
Disassembly procedure
2 - 14
6. Take the LCD panel out of LCD module.
7. Finally, remove 4 screws on the right LCD bracket, and 4 screws on the left side to disassemble
LCD brackets
8. Remove the paster and disconnect the VDS cable, then take the VDS cable out of LCD panel.
Disassembly procedure
2 - 15
9. Remove the right and left hinge.
10. Tear the following pastors on LCD back cover like the picture shows.
Disassembly procedure
2 - 16
11. Take the camera out of LCD, and then remove camera module.
12. Remove the other paster and take away both LED board out of LCD cover.
Disassembly procedure
2 - 17
13. Disconnect the camera cable from camera.
14. Remove all tapes on antenna cables.
Disassembly procedure
2 - 18
15. Remove 2 screws on the white, grey and black antennas respectively, and then remove them
from the LCD back cover.
17. Remove 18 screws (M2*5 M2*4) from the bottom case.
Disassembly procedure
2 - 19
18. Remove 1screw from the top case.
19. Remove 2 screws here, then separate the top case and the bottom case.
Disassembly procedure
2 - 20
20. Tear of the tapes here, remove 2 screws on the LED board and then remove the LED board.
21. Disconnect the LED cable.
22. Tear of the tapes and disconnect the touchpad cable.