Ask Proxima M8 User Guide

30
To reset the lamp time
1Turn on the projector.
2Press the [MENU] key to display the setup menu.
3Press the [T] key to select “Operational Info”, and then press the [ENTER] key.
4Press the [ENTER] key.
5This causes the message “Reset Lamp Time?” to appear.
6Press the [S] key to select “Yes”, and then press the [ENTER] key.
7This resets the lamp time to 0 hours.
8Press the [MENU] key to exit the setup menu.
9This causes the setup menu to disappear from the projected image.
To reset the lamp time after...

31
Appendix
When performing an operation on the remote controller, point it at the remote control signal 
receiver on the back or front of the projector. The following illustration shows the range of 
the remote controller signal.
Remote Controller Range
The allowable distance between the remote controller and the projector is less when there 
is a sharp angle between the remote controller and the remote control signal receiver.
Important!
To avoid running down the battery, store the remote control unit...

32
Some video devices are equipped with a component video output terminal. You can use an 
optionally available VESA to component video adapter (SP-VESA-ADPT-R) and a 
component video cable to connect the RGB input terminal of the projector to the component 
video output terminal of a video device.
Important!
Always turn off the projector and the video device before connecting them.
zComponent video output terminals come in 3-terminal sets: Y·Cb·Cr or Y·Pb·Pr. Be sure to 
match the colors of the plugs on...

33
Full-screen Display of an RGB Image
The projector outputs images using XGA (1024 pixels × 768 pixels) video resolution. When 
the input signal from the computer connected to the projector is not an XGA signal, 
“Resize Image To Fit” automatically enlarges or reduces the image so it matches the 
projector’s video resolution and fills the entire screen. The following shows how different 
input signals from a computer are adjusted during projection.
Input Signal ExampleProjected Image
When the input...

34
Use the following procedure to replace the lens cover if it should accidentally become 
detached from the projector. 
1Insert the nub (‘) of the left tab of the lens cover into the depression () of the 
tab under the lens.
zWhen performing the above step, make sure that the lens cover is open to 90 degrees in 
relation to the front of the Data Projector.
2Keeping the left nub (‘) in the left depression (), gently press the lens cover 
towards the right as you insert the nub (
’) of the right lens...