Apple xserve raid or xserve raid sfp User Manual
Have a look at the manual Apple xserve raid or xserve raid sfp User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Xserve RAID Take Apart - 33 Left or Right Front Light Pipe Left or Right Front Light Pipe Tools The only tools required for this procedure are a Phillips screwdriver and a flat-blade screwdriver. Preliminary Steps Before you begin, remove the system from the rack and place it on a sturdy, flat surface and ESD mat. Then remove the following: • Top cover • Front bezel • Right or left front panel board Note: The same light pipe is used behind both the left and right front panel boards. Part Location Light Pipe Behind Left Front Panel Board Light Pipe Behind Right Front Panel Board
34 - Xserve RAID Take Apart Left or Right Front Light Pipe Procedure 1. Using a flat-blade screwdriver, carefully pry up the light pipe and shield. 2. Remove the light pipe and shield from the bezel. Replacement Note: The light pipes come with a black plastic shield. Make sure the shield is in correct position over the light pipe before you place the light pipe back into the bezel.
Xserve RAID Take Apart - 35 Front Panel Buttons Front Panel Buttons Tools The only tools required for this procedure are a Phillips screwdriver and either a flat-blade screwdriver or needlenose pliers. Preliminary Steps Before you begin, remove the system from the rack and place it on a sturdy, flat surface and ESD mat. Then remove the following: • Top cover • Front bezel • Left front panel board Note: The front panel button kit comes with both the system identi fier button and the mute button. Part Location
36 - Xserve RAID Take Apart Front Panel Buttons Procedure 1. Using needlenose pliers or a flat-blade screwdriver, carefully lift out the button shield from the bezel. 2. Pry up the buttons and remove them from the bezel. Replacement Note: When replacing the buttons, be sure to orient them as illustrated below.
Xserve RAID Take Apart - 37 Front Panel Cable Front Panel Cable Tools The only tool required for this procedure is a Phillips screwdriver. Preliminary Steps Before you begin, remove the system from the rack and place it on a sturdy, flat surface and ESD mat. Then remove the following: • Top cover • Front bezel Part Location
38 - Xserve RAID Take Apart Front Panel Cable Procedure 1. Disconnect the front panel cable from the midplane board. 2. Remove any tape holding the cable to the chassis. 3. Route the cable out through the center opening in the chassis and remove the cable from the enclosure.
Xserve RAID Take Apart - 39 Rear Panel Cable Rear Panel Cable Tools The only tool required for this procedure is a Phillips screwdriver. Preliminary Steps Before you begin, remove the system from the rack and place it on a sturdy, flat surface and ESD mat. Then remove the top cover. Part Location
40 - Xserve RAID Take Apart Rear Panel Cable Procedure 1. Disconnect the rear panel cable from the midplane board and from the rear power button panel board or rear system ID panel board. 2. Remove the cable from the enclosure.
Xserve RAID Take Apart - 41 Rear System ID Panel Board Rear System ID Panel Board The rear system ID panel board includes the system ID and mute buttons. Tools The only tool required for this procedure is a small Phillips screwdriver. Preliminary Steps Before you begin, remove the system from the rack and place it on a sturdy, flat surface and ESD mat. Then remove the top cover. Part Location
42 - Xserve RAID Take Apart Rear System ID Panel Board Procedure 1. Disconnect the rear panel cable from the rear system ID panel board. 2. Remove the two panel board mounting screws. 3. Remove the rear system ID panel board and its button cover from the enclosure.