Apple xserve raid or xserve raid sfp User Manual
Here you can view all the pages of manual Apple xserve raid or xserve raid sfp User Manual. The Apple manuals for Server are available online for free. You can easily download all the documents as PDF.
Page 31
Xserve RAID Take Apart - 23 Midplane Board Procedure 1. Disconnect the front panel board cable and back panel board cables from the midplane board. 2. Grasp the front half of the chassis and rotate 90 degrees up. 3. Remove the six midplane board mounting screws. 4. Remove the midplane from the bottom housing.
Page 32
24 - Xserve RAID Take Apart Midplane Board Replacement Note: When repositioning the front half of the chassis back into place, make sure the small hole in the center of the chassis fits over the peg in the chassis floor.
Page 33
Xserve RAID Take Apart - 25 Center Front Panel Board Center Front Panel Board Tools The only tool required for this procedure is a Phillips screwdriver. Preliminary Steps Before you begin, remove the system from the rack and place it on a sturdy, flat surface and ESD mat. Then remove the following: • Top cover • Front bezel Part Location
Page 34
26 - Xserve RAID Take Apart Center Front Panel Board Procedure 1. Remove the two mounting screws on the center front panel board. 2. Remove the board from the bezel.
Page 35
Xserve RAID Take Apart - 27 Center Front Light Pipe Center Front Light Pipe Tools The only tools required for this procedure are a Phillips screwdriver and a small flat-blade screwdriver. Preliminary Steps Before you begin, remove the system from the rack and place it on a sturdy, flat surface and ESD mat. Then remove the following: • Top cover • Front bezel • Center front panel board Part Location
Page 36
28 - Xserve RAID Take Apart Center Front Light Pipe Procedure 1. Using a flat-blade screwdriver, carefully pry up the top center light pipe and shield and remove them from the bezel. 2. Remove the bottom light pipe and shield from the bezel.
Page 37
Xserve RAID Take Apart - 29 Left Front Panel Board Left Front Panel Board Tools The only tool required for this procedure is a Phillips screwdriver. Preliminary Steps Before you begin, remove the system from the rack and place it on a sturdy, flat surface and ESD mat. Then remove the top cover. Part Location
Page 38
30 - Xserve RAID Take Apart Left Front Panel Board Procedure 1. Disconnect the front panel board cable from the left front panel board. 2. Remove the mounting screw. 3. Remove the board from the enclosure.
Page 39
Xserve RAID Take Apart - 31 Right Front Panel Board Right Front Panel Board Tools The only tool required for this procedure is a Phillips screwdriver. Preliminary Steps Before you begin, remove the system from the rack and place it on a sturdy, flat surface and ESD mat. Then remove the top cover. Part Location
Page 40
32 - Xserve RAID Take Apart Right Front Panel Board Procedure 1. Disconnect the locking switch cable and the front panel board cable from the right front panel board. 2. Remove the mounting screw. 3. Remove the board from the enclosure.