Apple powerbook g4 12 inch dvi User Manual

PowerBook G4 (12-inch) Take Apart - 139
 Inverter Board (and Antenna Cable Assembly)7. Separate the clutch cover from the bezel and remove the LVDS cable.
8. Remove the antenna cables and inverter from the clutch cover. 

140 - PowerBook G4 (12-inch) Take Apart
 Inverter Board (and Antenna Cable Assembly) Replacement Note:
 When reinstalling the clutch cover, check that the cables are 
routed as shown below (Bluetooth cable on the bottom of the clutch): 

PowerBook G4 (12-inch) Take Apart - 141
 Hinges with Bezel Brace
Hinges with Bezel Brace
Part Location
Preliminary Steps
Before you begin, remove the following:
• Battery
• Memory door and memory card
• AirPort Extreme Card, if installed
• Keyboard
• Top case
• Hall effect sensor board and cable
• Hard drive
• Modem
• DC-to-DC board
• Heatsink with fan
• Inner frame (with RJ11 board attached)
• Logic board
• DC-in board
• Optical drive
• Display module
• Display housing
• LCD panel
• Inverter (and...

142 - PowerBook G4 (12-inch) Take Apart
 Hinges with Bezel Brace
Procedure
Important:  In the following steps, note that because of the position of the bezel, the 
designation of right and left differs. For example, the right hinge with bezel brace is 
removed from the left side of the bezel because you are viewing the bezel from its inner 
side. Likewise, the left hinge with bezel brace is removed from the right side of the bezel.
1. From the left side of the bezel, remove the three screws. 
2. Remove...

PowerBook G4 (12-inch) Take Apart - 143
 Hinges with Bezel Brace3.Replacement Note: If you are replacing the right hinge with bezel brace with a new 
one, make sure you transfer the sleep magnet to the replacement right bezel brace. 
Use a black stick to tilt the magnet out of the magnet holder on the right bezel brace. 
Important:
 Make sure the magnet is in place before reassembling the display 
module. 

144 - PowerBook G4 (12-inch) Take Apart
 Hinges with Bezel Brace 4. From the right side of the bezel, slide out the left hinge with bezel brace (no screws 
and no magnet on this side).
Replacement Note:
 To distinguish the right hinge with bezel brace from the left 
hinge with bezel brace, note that the right hinge has three flanges on the outer edge 
for the three screws. The left hinge has no screw flanges. 

PowerBook G4 (12-inch) Take Apart - 145
 Hinges with Bezel Brace
Identifying the Replacement Hinges
Before ordering a replacement hinge with bezel brace, verify the LCD panel manufacturer 
and hinge marking, as follows.
1. Check the manufacturer label shown on the LCD panel. 

146 - PowerBook G4 (12-inch) Take Apart
 Hinges with Bezel Brace 2. If the label on the LCD panel shows Samsung as the manufacturer, order replacement 
hinges that show a SAM-L or SAM-R designation on the outer arm of the bezel brace. 
• To replace a SAM-L hinge, order 922-5714.
• To replace a SAM-R hinge, order 922-5713 

PowerBook G4 (12-inch) Take Apart - 147
 Hinges with Bezel Brace3. If the label on the LCD panel shows IDTech as the manufacturer, order replacement 
hinges that show an LG-L or LG-R designation on the outer arm of the bezel brace. 
• To replace a LG-L hinge, order 922-5712.
• To replace a LG-R hinge, order 922-5711 

148 - PowerBook G4 (12-inch) Take Apart
 Display Bezel
Display Bezel
Part Location
Preliminary Steps
Before you begin, remove the following:
• Battery
• Memory door and memory card
• AirPort Extreme Card, if installed
• Keyboard
• Top case
• Reed switch (or hall effect sensor board)
• Hard drive
• Modem
• DC-to-DC board
• Heatsink with fan
• Inner frame (with RJ11 board attached)
• Logic board
• DC-in board
• Optical drive