Apple power mac g5 early 2005 User Manual
Here you can view all the pages of manual Apple power mac g5 early 2005 User Manual. The Apple manuals for Personal Computer are available online for free. You can easily download all the documents as PDF.
Page 181
Power Mac G5 Troubleshooting 187 Power-on LED illuminates when power button is pressed, fans spin, and boot tone chimes, but there is no video Reseat video card. (Make sure video card is fully inserted in connector and end of card is secured by the connector latch.) Reset PRAM (restart computer while holding down Command-Option-P-R keys until second boot tone chimes) Replace video card Reset logic board. Refer to “Resetting the PMU on the Logic Board” in this chapter. Replace logic board Power-on...
Page 182
188 Power Mac G5 Troubleshooting Startup Failures for Power Mac G5 (June 2004 Dual 2.5 GHz/ Early 2005 Dual 2.7 GHz) Power-on LED illuminates when power button is pressed but fans do not spin (or spin only momentarily) and there is no boot tone or video Reseat video card. (Make sure video card is fully inserted in connector and end of card is secured by the connector latch.) Reset logic board. Refer to “Resetting the PMU on the Logic Board” in this chapter. Verify power supply cables are fully...
Page 183
Power Mac G5 Troubleshooting 189 Power-on LED illuminates, fans and processor pump run harder, there is no boot and the system shuts down within a few minutes Remove the processor and look for loss of fluid on the absorbent liner on top of the power supply. If you see drops of fluid, replace the processor, otherwise go on to the next step. Reseat the processor. Replace the processor Replace the logic board Replace the power supply Fluid leak is suspected and the computer is plugged in Unplug the...
Page 184
190 Power Mac G5 Troubleshooting Fans Individual fan failure Replace fan Exception: The drive fan and blower located between the optical and hard drives cannot be replaced. You must replace the enclosure for these two parts. Replace logic board All fans run at high speed Run Apple Service Diagnostic (refer to “Thermal Calibration” earlier in this chapter). Media bay fans run at high speed Note: If any of the following three conditions cannot be verified, the red LED on the logic board near the...
Page 185
Power Mac G5 Troubleshooting 191 Other Failures Duct door sensor Reseat interlock sensor board cable Replace interlock sensor board Replace logic board Replace enclosure Hard drive (kernel panics, hard drive does not mount, or performance slows when second hard drive is installed) Replace hard drive guide screws Replace hard drive Optical drive Replace optical drive cable Replace optical drive Replace logic board FireWire port (front panel A) Reseat front panel board cable. Replace front panel...
Page 186
192 Power Mac G5 Troubleshooting Internal speakers (high-pitch tone) Replace power supply Replace logic board USB 2.0 (front port) Replace front panel board cable Replace front panel board Replace logic board USB 2.0 (rear-top port or rear bottom port) Replace logic board Modem Replace modem Replace modem filter board Replace logic board AirPort Replace AirPort Card Replace antenna card Replace logic board Bluetooth Replace Bluetooth card Replace antenna card Replace logic board Audio IO (front line...
Page 188
Power Mac G5 Upgrades — Modem Upgrade Kit 195 Modem Upgrade Kit Apple offers a modem board as a configure-to-order (CTO) option for the Power Mac G5 (Early 2005) computer. For customers who purchase this computer in retail or want to add a modem board after purchase, Apple will provide an upgrade kit for Apple Authorized Service Providers. Installation of the upgrade kit must be performed by an Apple Authorized Service Provider. Damage resulting from installation by anyone other than a service...
Page 189
Power Mac G5 Upgrades — Modem Upgrade Kit 196 Procedure Note for Chinese Installations Only: The Chinese upgrade kit includes a China-specific label that you must apply to the modem. To attach the label, remove the protective backing and wrap the label around the modem as illustrated below. Connect the modem filter cable to the connector on the end of the modem board. 1.
Page 190
Power Mac G5 Upgrades — Modem Upgrade Kit 197 Connect the modem to the modem connector on the logic board and install the two mounting screws. With a small, flat-blade screwdriver, pry up and remove the modem plug on the computer’s back panel. 2. 3.