Apple power mac g4 gigabit ethernet User Manual
Here you can view all the pages of manual Apple power mac g4 gigabit ethernet User Manual. The Apple manuals for Personal Computer are available online for free. You can easily download all the documents as PDF.
Page 181
Take Apart Rear Vented Panel - 159 1. Open the side access panel. 2. Remove the three 2.5 mm Allen screws. 3. Push in on the six tabs to release the panel from the chassis.
Page 182
Take Apart Rear Vented Panel - 160 4. Once the tabs are released, carefully pull the rear panel forward to remove.
Page 183
Take ApartLatch Panel - 161 Latch Panel Before you begin, remove the following: ¥ video card ¥ PCI cards (if present) ¥ Power Mac G4 (PCI Graphics): FireWire board (if present) ¥ Power Mac G4 (PCI Graphics): modem (if present) ¥ AirPort card (if present) ¥ logic board
Page 184
Take ApartLatch Panel - 162 1. Remove the four Phillips screws holding the panel to the chassis. 2. Slide the panel toward the hard drives, freeing the latch panel from the tabs on the chassis. Note: Circles indicate tab locations. 3. Remove the latch panel.
Page 185
Take Apart Right Side Access Panel - 163 Right Side Access Panel Before you begin, remove the following: ¥ PCI cards (if present) ¥ video card ¥ FireWire board (if present) ¥ modem (if present) ¥ AirPort card (if present) ¥ logic board
Page 186
Take Apart Right Side Access Panel - 164 1. Remove the four 2.5 mm Allen screws on the side panel.
Page 187
Take Apart Right Side Access Panel - 165 2. Open the side access panel. 3. Remove the two Phillips screws attaching the right side panel to the metal chassis.
Page 188
Take Apart Right Side Access Panel - 166 4. Using a flatblade screwdriver or needlenose pliers, push or squeeze the plastic tabs (protruding through the side chassis panel), to release the right panel from the metal chassis. 5. Remove the right side panel from the chassis.
Page 189
Take ApartLeft Side Panel - 167 Left Side Panel No preliminary steps are required before you begin this procedure.
Page 190
Take ApartLeft Side Panel - 168 1. Remove the four 2.5 mm Allen screws on the side panel.